Sonus SBC 1000 Bedienungsanleitung

Revision

Date

Revised By

Comments

0.1

12/03/2015

Roman Kokes

Initial Publication

0.2

3/16/2015

Grant Gist

Internal review

0.4

3/26/2015

Andy N. Tran

Customer review

1.0

4/13/2015

Tech Pubs

Final Edit and Release

SBC 1000/2000 Configuration Guide with

Lync 2013 for Windstream/ LPAETEC SIP

Trunk Deployments

Application Notes

Rev. 1.0

Last Updated: April 10, 2015

Sonus –Network Design Group 2 of 39

Sonus –Network Design Group 3 of 39

1Document Overview..............................................................................5

1.1 Glossary.................................................................................................................................. 5

1.2 Overview................................................................................................................................. 6

2Introduction ...........................................................................................6

2.1 Audience................................................................................................................................. 6

2.2 Requirements.......................................................................................................................... 7

2.3 Reference Configuration......................................................................................................... 8

Network Topology ............................................................................................................... 8

3Configuring Sonus SBC 1000 and SBC 2000 Series.............................9

3.1 External Peer Side SBC Configuration................................................................................. 10

Node Interfaces................................................................................................................. 10

SIP profile.......................................................................................................................... 12

Media Profile ..................................................................................................................... 13

Voice Codec Profiles .................................................................................................................14

SIP Server Tables......................................................................................................................15

Static IP Route Table ........................................................................................................ 15

Signaling Groups............................................................................................................... 16

Call Routing Table............................................................................................................. 17

Transformation Tables ...................................................................................................... 18

Trunk Registration............................................................................................................. 19

3.2 Internal Side SBC configuration............................................................................................ 20

Node Interfaces................................................................................................................. 20

SIP Profile ......................................................................................................................... 22

Media Profiles.................................................................................................................... 23

Voice Codec Profiles .................................................................................................................24

Signaling Group................................................................................................................. 25

Sip Server Table................................................................................................................ 26

Call Routing Table............................................................................................................. 27

Transformation Tables ...................................................................................................... 28

4Lync Server 2013 configuration........................................................... 31

4.1 Lync 2013 Configuration Settings......................................................................................... 31

Addition of the SBC to the Lync Server............................................................................. 31

Adding the SBC to Lync Server 2013 Routing.................................................................. 35

Sonus –Network Design Group 4 of 39

5SBC and Lync 2013 Specific Configurations...................................... 37

5.1 Initial Setup for All Calls........................................................................................................ 37

Calling number manipulation............................................................................................. 37

Called number................................................................................................................... 37

5.2 Initiating Transfers with REFER............................................................................................ 37

Call transfer via REFER method....................................................................................... 37

5.3 Initiating Transfers with Re-INVITE ...................................................................................... 38

Call transfer via Re-Invite method..................................................................................... 38

Sonus –Network Design Group 5 of 39

1 Document Overview

These Application Notes describe the configuration steps required for the Sonus Session Border Controller

(SBC) 1000 and SBC 2000 to interoperate with the Lync 2013 system and a SIP trunk group to PSTN.

The objective of the document is to describe the configuration procedures to be followed during interoperability

testing of SBC 1000 and SBC 2000 with Lync 2013 server over SIP trunk to PSTN.

For additional information on Sonus SBC 1000 and SBC 2000 series, visit http://www.sonus.net

For additional information on Lync 2013, visit http://www.microsoft.com

1.1 Glossary

Term

Definition

AOC

Advice Of Charge

B2B UA

Back to Back User Agent

Calling Party

CPD

Call Progress Detection

CPE

Customer Premise Equipment –Cisco SIP Server is the CPE device

in this case.

CTI

Computer Telephony Integration

DNIS

Dialed Number Identification Service

Internet Protocol

Media Server

PBX

Private Branch Exchange

PSX

Policy Server Exchange

SDOP

Signaled Digits Out-Pulsed

SIP

Session Initiation Protocol

UUI

User to User Information

Sonus –Network Design Group 6 of 39

1.2 Overview

The Sonus SBC 1000 and SBC 2000 session border controllers are designed to use the same application

software, boot image and Survivable Branch Appliance software. They differ in the number of physical Ethernet

connections and processing power but are otherwise viewed from a software standpoint as being the same.

With this in mind, this particular effort was tested with an SBC 1000 but is fully applicable to an SBC 2000.

2 Introduction

This document provides a configuration guide for Sonus SBC 1000 Series (Session Border Controller) when

connecting to a SIP trunk group and a Lync 2013.

The Sonus SBC 1000 and SBC 2000 are Session Border Controllers that connect disparate SIP trunks, SIP

PBXs, and communication applications within an enterprise. The SBC can also be used as a SIP routing and

integration engine.

The Sonus SBC is the point of connection between the SIP trunk group to PSTN and the Lync 2013.

2.1 Audience

This technical document is intended for telecommunication engineers with the purpose of configuring the Sonus

SBC 1000 and SBC 2000 and aspects of the SIP trunk group together with Lync 2013 product. There will be

steps that require navigating the third-party and Sonus SBC Command Line Interface (CLI). Understanding the

basic concepts of IP/Routing and SIP/RTP is also necessary to complete the configuration and for

troubleshooting, if necessary.

This configuration guide is offered as a convenience to Sonus customers. The specifications and information

regarding the product in this guide are subject to change without notice. All statements, information, and

recommendations in this guide are believed to be accurate but are presented without warranty of any kind,

express or implied, and are provided “AS IS”. Users must take full responsibility for the application of the

specifications and information in this guide.

Technical support on SBC 1000 and SBC 2000 can be obtained through the following:

Phone: +1 888-391-3434 (Toll-free) or +1 978-614-8589 (Direct)

Web: http://www.sonus.net/company/maintenance/log-trouble-tickets

Sonus –Network Design Group 7 of 39

2.2 Requirements

The following equipment and software was used for the sample configuration provided:

Sonus Equipment

Type

Version

SBC 1000

4.1.0 Build 369

3rd Party Equipment

Type

Version

Microsoft Lync 2013

Mediation Server

5.0.8308.420

Polycom CX500

Lync Edition

SIP Phone

4.0.7577.4455

Windstream Equipment

Type

Version

Broadsoft West

Broadsoft platform

R17 SP4

ACME SBC

ACME Net-Net 4250

SC6.2.0 Patch 3 (Build

497) Build

Date=02/12/10

Sonus –Network Design Group 8 of 39

2.3 Reference Configuration

A simulated enterprise site consisting of a Lync 2013 and a SIP trunk group to PSTN connected over the SBC

1000. The SBC 1000 was running software version 4.1.0 Build 369 during testing.

Network Topology

PSTN

Lync 2013

Sonus

SBC 1000

Windstream

Internal IP Network

Figure 2.1 Network Topology

The figure above represents the equipment used for the integration and certification testing. The SBC 1000 is

used to route and facilitate calls between the PSTN and the Lync 2013 system.

The SBC 1000 under test has 2 Ethernet ports configured. The SBC 2000 can have up to 4 physical Ethernet

ports and two physical T1/E1 ports. For more information on Media port deployment options or other network

connectivity queries, refer to the SBC 1000 Network Deployment Guide or contact your local Sales team for

information regarding the Sonus Network Design professional services offerings.

Sonus –Network Design Group 9 of 39

3 Configuring Sonus SBC 1000 and SBC 2000 Series

The SBC 1000 and SBC 2000 share a common code base and user interface. In this example, we are using an

SBC 1000.

Lync 2013 Signaling Group

Internal

Lync 2013

External

Signaling Group: To/From Lync

Call Routing: From Lync

Signaling Group: To/From Windstream

Call Routing: From Windstream

10.35.180.136:5068

SIP over TCP Windstream

10.35.177.230:5060

64.199.64.220:5060

216.110.2.235:5060

SIP over UDP

Figure 3.1 SBC 1000 SIP Trunk Diagram

Sonus –Network Design Group 10 of 39

3.1 External Peer Side SBC Configuration

Node Interfaces

The Sonus SBC 1000 allows you to configure the identification information, Physical Data Layer, and Networking

Layer for the Ethernet ports. If you want to change the IP Address, you must configure the associated Logical

Interface or use the Modify Ethernet IP task found under the Tasks tab.

Settings for the Ethernet connection between the Sonus SBC 1000 and the public Internet are shown in the

figures below.

Figure 3.2 External Port

Andere Handbücher für SBC 1000

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sonus Controller Handbücher

Sonus

Sonus 5200 Handbuch

Sonus

Sonus 5100 Bedienungsanleitung

Sonus

Sonus 5100 Handbuch

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Rockwell Automation

Rockwell Automation 1769-L31 Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Samson

Samson Type 5824 Service-Handbuch

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Fishman

Fishman TriplePlay Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung