
8
3RET/VTR button
Use this button when a CCU-D50/
D50P/M5A/M5AP or VTR is
connected to the CCU/VTR/CMA
connector.
When a CCU-D50/D50P/M5A/
M5AP is connected: Holding down
this button displays return video
in the viewfinder. When the
button is released, the viewfinder
returns to the video being shot by
the camera.
When a VTR is connected: This
button functions as a VTR
recording start/stop button.
Recording starts when the button
is pressed and stops when it is
pressed again.
4CCU/VTR/CMA connector
(26-pin, male)
Connect a CCU-D50/D50P/M5A/
M5AP, VTR, or CMA-8A/8ACE AC
Adaptor. This connector sends and
receives power and all video, audio,
and control signals between this unit
and the connected device.
5INTERCOM knob
Adjusts the received signal level of
intercom audio.
6EARPHONE jack (mini jack)
Connect earphones. Earphones allow
you to monitor the recording or
playback audio of a VTR connected to
this unit.
7INTERCOM connector (mini
intercom jack)
Connect the DR-100 headset (not
supplied). The DR-100 allows you to
talk with the operators of camera
control units, special effects units,
switchers, and so on.
8PROMPT/GENLOCK connector
(BNC type)
When a CCU is not connected:
Input a reference video signal
(black burst or composite video
signal) for external
synchronization.
When a CCU is connected: This
connector outputs prompter
signals whenever prompter
signals are input to the CCU.
9DC IN connector (XLR 4-pin)
Connect to an external DC power
supply (12 V). Use the CCQX-3 DC
Power Cord (not supplied) to connect
this connector and the CMA-8A/
8ACE AC Adaptor (not supplied).
Power supplied from the DC IN
connector is given priority over power
supplied from the CCU/VTR/CMA
connector.
0SDI OUT connector (BNC type)
Outputs video signals from the camera
as digital video (SDI) signals.
Location and Functions of Parts