Sony DSC-S40 - Cyber-shot Digital Still Camera Bedienungsanleitung

How to hardwire the Sony DSC-S40 Digital Camera

This document covers in detail how to modify the Sony DSC-S40 digital camera for remote shutter control from the

PixController Universal or LE camera control board. Please see http://www.pixcontroller.com or email

support@pixcontroller.com for more information.

Please note that if you make this modification to your Sony camera that you will void your

camera’s warranty. This modification can also result in damage to your digital camera if

you do not follow the instructions properly.

Tools/Parts Needed

1. 2.4 mm #0 Philips Screwdriver & Small Flat Blade Screwdriver.

2. Fine tipped soldering iron with heat control.

3. 30 Gauge wire. Wire Wrap type wire can be purchased from your local Radio Shack store. Find one of the 3

part numbers: 278-501, 278-502, 278-503. They come in a spool of 50 feet of wire for $2.99

4. Small tweezers.

5. Flat blade screw driver or knife.

6. Sony DSC-S40 flat flex cable from Nature-Qwest, LLC., or purchase the Universal or LE Sony S40 kit.

7. PixController Universal board with Sony S40-U PIC chip, or LE board with LE II PIC chip

Remove batteries and media card

Before starting your project be sure to remove the

2 AA internal batteries and the Media Card.

Remove the 2 AA batteries and Media Card

Remove the camera case screws

Remove all 3 screws from the camera case. Be sure to

place the screws in a safe place while modifying the

camera.

Remove screws 1,and 2 from the bottom of the camera case.

Note, screw 2 is under the memory card door.

Remove screw 3 from the right side of the case.

Remove the case

Carefully remove the back of the camera case from

the camera exposing the interior electronics, Figure

Next, remove the front of the camera case, Figure 2.

This is a little harder to remove, but take your time

and unsnap all of the hinges. The front of the case

will be attached with a small ribbon cable, so take

care as not to handle this too hard or damage the

ribbon cable.

Figure 1

Figure 2

Prep the S40 Shutter Assembly Cable

You must use the S40 Shutter Assembly Cable in

order to modify this digital camera. The solder

contacts are too small even for the most skilled

technician to handle.

You must add 2 small gauge wires to the cable

before you start. Add the wires to the solder points

shown in Figure 3. In our example we added a Red

wire to the solder pad “P” for Power on/off, and Blue

to solder pad “S” for shutter.

Sony S40 Shutter Assembly cable from Nature Qwest, LLC.

Figure 3

Insert the Shutter Assembly Cable

The next step is to insert the S40 Shutter

Assembly cable into the shutter connector.

Locate the shutter connector shown in Figure

4. Using a small pair to tweezers with smooth

jaws carefully remove the cable from this

connector. Carefully grab the base of the

ribbon cable and take your time to remove

this cable.

Next insert the S40 Shutter cable, which will

be sandwiched in with the current cable.

Insert the cable in the orientation as shown in

Figure 5. Be sure to align the properly and

use your tweezers to push both cables into

the connector.

Once inserted add a small piece of electrical

tape to keep the cable in place as shown in

figure 6.

Figure 4

Figure 5

Figure 6

Attach the ground wire

Next attach the ground wire, which is a small gauge

wire, and in our example we added a black wire. This

wire is soldered to one of the UBS hood solder pads

on the back of the camera near the LCD display.

Figure 7 shows the exact location.

The modification is now complete. You can drill a

small hole in the Tripod connector and run the 3

wires, Power, Shutter, and Ground through this

location, or add any connector you wish. We leave

this design up to the user.

Figure 7

Route the cable through the tripod connector

Re-attach case and replace the screws

Once you are complete with this process place

the camera case back together and replace the

camera case screws.

Attaching the Sony S40 to the PixController LE

Board and Universal Board

1. Wiring your S40 camera to the PixController LE

board.

Connect the following wires to your LE board:

Shutter – Shutter on LE, J2-1

Ground – Ground on LE, J2-2

Power – Refresh on LE, J2-3

Last, remove the R17 resistor from the LE board,

see: http://www.pixcontroller.com/PixLE

/PixLE_ResistorRemoval.htm

2. Wiring your S40 camera to the PixController

Universal board.

Connect the following wires to your Universal

board:

Shutter – Shutter, J14-1, or Phone Cable Shutter

Wire

Ground – Ground, J14-7, or Phone Cable Ground

Wire

Power – Power, J14-3, or Phone Cable Power

Wire

PixController LE Camera Port Diagram

PixController Universal Camera Port Diagram

PixController Universal Phone Port

Completed Modification

Zoom Lens issue

Because of the zoom lens on the Sony S40 this

can be an issue to get a good seal between the

camera lens and the case as to not get flash

bleed during night photos.

Figure 8 shows a simple solution to this problem

by adding 3 of the Large Flash Masking

Washers sold on the www.pixcontorller.com web

site under the camera accessories. These 3

washers can be easily glued together using

Marine GOOP.

Figure 8



8/20/05

Andere Handbücher für DSC-S40 - Cyber-shot Digital Still Camera

Inhaltsverzeichnis

Andere Sony Digitalkamera Handbücher

Sony

Sony NEX-7 &alpha Bedienungsanleitung

Sony

Sony DSC T700 - Cyber-shot Digital Camera Bedienungsanleitung

Sony

Sony MVC-CDZOO/CD300 Bedienungsanleitung

Sony

Sony Cyber-shot DSC-TX20 Bedienungsanleitung

Sony

Sony Cyber-shot DSC-F707 Montageanleitung

Sony

Sony Alpha 7C Bedienungsanleitung

Sony

Sony Alpha DSLR-A290 Bedienungsanleitung

Sony

Sony DSC-730 Bedienungsanleitung

Sony

Sony Alpha NEX-3 Bedienungsanleitung

Sony

Sony NEX-5T Bedienungsanleitung

Sony

Sony DSC-P7 - Cyber-shot Digital Still Camera Bedienungsanleitung

Sony

Sony DSC-T2 Bedienungsanleitung

Sony

Sony ILCE-3000K Bedienungsanleitung

Sony

Sony DSC-T2/B Bedienungsanleitung

Sony

Sony FD Mavica MVC-FD200 Bedienungsanleitung

Sony

Sony DSLR-A900 Bedienungsanleitung

Sony

Sony DSLR-A100 Bedienungsanleitung

Sony

Sony DSC-WX1 Bedienungsanleitung

Sony

Sony Cyber-shot DSC-W710 Bedienungsanleitung

Sony

Sony DSC-TX7 - Cyber-shot Digital Still Camera Bedienungsanleitung

Sony

Sony Cyber-shot DSC-WX5 Bedienungsanleitung

Sony

Sony Alpha DSLR-A350 Bedienungsanleitung

Sony

Sony FCBIX47C Bedienungsanleitung

Sony

Sony A900 - Alpha 24.6MP DSLR Camera Bedienungsanleitung

Beliebte Digitalkamera Handbücher anderer Marken

Mercury

Mercury 350K Bedienungsanleitung

Pentax

Pentax Optio LS 465 Bedienungsanleitung

Sanyo

Sanyo VPC-S1085 Bedienungsanleitung

GE SMART A1255 Bedienungsanleitung

Point Grey

Point Grey Gazelle Bedienungsanleitung

Nikon

Nikon COOLPIX A Bedienungsanleitung

Pentax

Pentax P-5 Bedienungsanleitung

BlazeVideo

BlazeVideo A280 Bedienungsanleitung

ATIK Cameras

ATIK Cameras One Bedienungsanleitung

CohuHD Costar

CohuHD Costar 3930 Series Bedienungsanleitung

Leica

Leica M10-R Bedienungsanleitung

FujiFilm

FujiFilm FinePix A700 Bedienungsanleitung

Lorex

Lorex LNZ81P25 Series Bedienungsanleitung

GE J1470S Bedienungsanleitung

Canon

Canon EOS ELAN7 Bedienungsanleitung

Samsung

Samsung SCC-C4253 Bedienungsanleitung

JVC

JVC GT-HM890 Bedienungsanleitung

GE POWER series E1486TW Bedienungsanleitung