Sony SSM-125 Bedienungsanleitung

Operating Instructions Page 2 _______________________________________________

Mode d'emploi Page 12 _______________________________________________________

Manual de instrucciones Página 20 __________________________________________

3-709-345-11 (1)

Black and White Monitor

SSM-125

Owner’s Record

The model and serial numbers are located at the rear.

Record the serial number in the space provided below.

Refer to these numbers whenever you call upon your Sony

dealer regarding this product.

Model No. SSM-125 Serial No. ______________

WARNING

To prevent fire or shock hazard, do not expose the

unit to rain or moisture.

This symbol is intended to alert the user to

the presence of uninsulated “dangerous

voltage” within the product’s enclosure that

may be of sufficient magnitude to constitute

a risk of electric shock to persons.

This symbol is intended to alert the user to

the presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the appliance.

CAUTION:

TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS

POLARIZED AC PLUG WITH AN EXTENSION CORD,

RECEPTACLE OR OTHER OUTLET UNLESS THE

BLADES CAN BE FULLY INSERTED TO PREVENT

BLADE EXPOSURE.

This unit is not intended to be used with computer work

stations.

English

For the customers in the U.S.A.

This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own

expense.

You are cautioned that any changes or modifications not

expressly approved in this manual could void your authority

to operate this equipment.

For the customers in Canada

The Class A digital apparatus meets all requirements of the

Canadian Interference-Causing Equipment Regulations.

CAUTION:

These potential hazards shall be considered common to

most rack installation.

1) Elevated Operating Ambient Temperature

After installed, the operating temperature may be greater

than room ambient. Consideration shall be given to the

environment temperature compatible within the

Manufacturer’s specified limit ofAmbient Temperature of

0°C – +35°C.

2) Reduced Air Flow

After installed, the amount of air flow required for safe

operation of this equipment shall not compromised.

3) Circuit Overloading

Before installing, refer to rated current on this equipment

and make sure that no overloading to the supply circuit

on the rack.

Please confirm the rated current described on this

Operating Instructions.

4) Providing Protective Earth

When this product is installed in a rack and supplied

power from an outlet on the rack, please confirm that the

outlet is provided with a reliable protective earth

connection.

5) Prevention against achieving hazardous condition

due to uneven mechanical loading

When this product is in a rack, please make sure that the

rack does not achieve hazardous condition due to

uneven mechanical loading.

English

Table of Contents

Features .............................................................................. 4

Precautions ......................................................................... 5

Location and Function of Controls .................................. 6

Front Panel ...................................................................... 6

Rear Panel ....................................................................... 7

Connections ........................................................................ 8

Connecting a Video Camera or a VCR ........................... 8

Connecting the Monitors................................................. 9

Specifications.................................................................... 10

Features

•This unit can be used as a closed circuit television monitor

or a video preview/playback monitor.

•Loop through connection allows up to three monitors to

display the same picture.

•Electronic circuits provide safeguards against interference,

noise and change of signal strength to maintain a clear and

stable picture.

Before operating the unit, please read this manual

thoroughly and retain it for future reference.

Precautions

Cleaning

Clean the unit with a lightly damp soft cloth. Use a mild

household detergent. Never use strong solvents such as

thinner or benzine as they might damage the finish of the

unit.

If you have any question or problem concerning your unit

that is not covered in this manual, please consult your

nearest Sony dealer.

Safety

•The unit operates on 120 VAC, 50/60 Hz.

•Should any liquid or solid object fall into the cabinet,

unplug the unit and have it checked by qualified personnel

before operating it any further.

•Unplug the unit from the wall outlet if it is not going to be

used for several days or more. To disconnect the cord,

pull it out by the plug. Never pull the cord itself.

•Allow adequate air circulation to prevent internal heat

build-up. Do not place the unit on surfaces (rugs,

blankets, etc.) or near materials (curtains, draperies) that

may block the ventilation holes.

•Height and vertical linearity controls located at the rear

panel are for special adjustments by qualified personnel

only.

Installation

•Do not install the unit in an extremely hot or humid place

or in a place subject to excessive dust or mechanical

vibration.

•The unit is not designed to be waterproof. Exposure to

rain or water may damage the unit.

Location and Function of Controls

1INPUT select switch

Keep this switch released (øA) to monitor the signal from

the VIDEO A IN connector.

Depress this switch (ØB) to monitor the signal from the

VIDEO B IN connector.

2H-HOLD (horizontal hold) control

When the picture does not appear in the center of the screen,

or some of the letters are missing on the screen, turn the H-

HOLD control to move the picture horizontally.

3V-HOLD (vertical hold) control

When the picture rolls up or down on the screen, turn the V-

HOLD control until a single stationary picture is obtained.

4POWER switch and indicator

To turn on the monitor, depress this switch. The green

indicator lights up.

To turn off the monitor, press the switch again.

5CONTRAST control

Turn clockwise to increase picture contrast and

counterclockwise to decrease it.

6BRIGHT (brightness) control

Turn clockwise for a brighter picture and counterclockwise

for a darker picture.

Front Panel

INPUT select

switch

CONTRAST

control

POWER switch

and indicator

BRIGHT

control

H-Hold

control

V-HOLD

control

7VIDEOA connectors and 75ΩON/OFF switch

8VIDEO B connectors and 75ΩON/OFF switch

Two video input connectors (VIDEO A and VIDEO B) for

the composite video signals and their loop-through output

connectors.

To monitor the signals input to the VIDEOA IN connector,

keep the INPUT select switch released (øA).

To monitor the signals input to the VIDEO B IN connector,

keep the INPUT select switch released (ØB).

IN connector (BNC type)

Connect the video output of a VCR, video camera, or

another monitor for loop-through connection.

OUT connector (BNC type)

Connect the video input of a VCR, video camera, or another

monitor for loop-through connection.

75ΩON/OFF switch

Set this switch to ON when only the IN connector is used.

Set this switch to OFF, when both the IN and OUT

connectors are used together for a loop-through connection.

9DC CLAMP ON/OFF switch

When the switch is set to OFF, the black and white areas

may become slightly gray.

To reproduce clear black and white definition, set this switch

to ON.

0V-LIN (vertical linearity) and HEIGHT controls

For special adjustments by qualified personnel only.

Rear Panel

ON OFF

IN OUT

ON OFF

IN OUT

ON OFF

IN OUT

VIDEO BVIDEO A DC CLAMP

ON OFF

VIDEO A connectors and

75ΩON/OFF switch VIDEO B connectors and

75ΩON/OFF switch

V-LIN (vertical linearity)

and HEIGHT controls

DC CLAMP ON/OFF switch

Connections

Connecting a Video Camera or a VCR

Connect the VIDEO IN connector to the video output of a

video camera or a VCR.

Video camera

VCR

Video camera

VCR

to video output

ON OFF

IN OUT

VIDEO BVIDEO A DC CLAMP

ON OFF

Connecting the Monitors

Using the loop-through feature of this unit, the same picture

can be obtained on all the monitors connected. You can

connect up to three monitors.

Adjust the picture contrast and brightness of each monitor.

Video camera

to video output

OFF OFF ON

First monitor Second monitor Third monitor

ON OFF

IN OUT

VIDEO BVIDEO A DC CLAMP

ON OFF

ON OFF ON OFF

IN OUT

VIDEO BVIDEO A DC CLAMP

ON OFF

ON OFF ON OFF

IN OUT

VIDEO BVIDEO A DC CLAMP

ON OFF

General

System EIA standard

Picture tube 12-inch picture measured

diagonally

90-degree deflection

Resolution More than 750 TV line

(horizontal)

Video input Composite: 0.5 – 2 Vp-p, sync

negative (×2)

Video input impedance High impedance for loop-

through; 75Ωterminated

Video output Composite: 0.5 – 2 Vp–p, sync

negative (×2)

Power requirements 120 VAC, 50/60 Hz

Power consumption Approximately 30W

Operating temperature 0°C to +35°C (32°F to 95°F)

Storage temperature –10°C to +40°C (14°F to 104°F)

Dimensions 296 ×303 ×301 mm (w/h/d)

(11 3/4×12 ×11 7/8inches)

Mass Approx. 9.2 kg (20 lb 5 oz)

Supplied Accessory Operating Instructions (1)

Specifications

Design and specifications are subject to change without

notice.

Inhaltsverzeichnis

Sprachen:

Andere Sony Monitor Handbücher

Sony

Sony BRAVIA FW-43BZ35F Bedienungsanleitung

Sony

Sony BVM-D20F1U, BVM-D20F1E, BVM-D20F1A, BVM-D24E1WU, BVM-D24E1WE, BVM-D24E1WA, BVM-D32E1WU, BVM-D32E1WE,... Bedienungsanleitung

Sony

Sony VAIO PCVA-15XD2 Bedienungsanleitung

Sony

Sony FWD-50PX1 (English: pgs. 52-97) Bedienungsanleitung

Sony

Sony Trinitron HMD-A200 Bedienungsanleitung

Sony

Sony LMD1750W Bedienungsanleitung

Sony

Sony LMD-1530MD Bedienungsanleitung

Sony

Sony Multiscan CPD-G520 Bedienungsanleitung

Sony

Sony MFM-HT205 Bedienungsanleitung

Sony

Sony HMZ-T3 Benutzerhandbuch

Sony

Sony Trinitron CPD-1320UC2 Bedienungsanleitung

Sony

Sony SDM-HS74 Bedienungsanleitung

Sony

Sony XVM-F65 Bedienungsanleitung

Sony

Sony KLV-40ZX1M (RM-VL610A Remote... Installationsanleitung

Sony

Sony Multiscan SDM-N50 Bedienungsanleitung

Sony

Sony PVM-14L1 Bedienungsanleitung

Sony

Sony SDM-P82 Bedienungsanleitung

Sony

Sony Multiscan SDM-M51 Kurzanleitung

Sony

Sony Trinitron HMD-A200/L Bedienungsanleitung

Sony

Sony Multiscan CPD-420GS Installationsanleitung

Sony

Sony SDM-P232W - PREMIERPRO - 23" LCD Monitor Bedienungsanleitung

Sony

Sony PLM-A55 - Glasstron - 0.7" TFT Active Matrix Head Mounted... Bedienungsanleitung

Sony

Sony Multiscan CPD-L181 Bedienungsanleitung

Sony

Sony TRIMASTER HX BVM-HX310 Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung