Sony HKSR-5804 Bedienungsanleitung

NETWORK INTERFACE BOARD

HKSR-5804

INSTALLATION MANUAL

1st Edition

HKSR-5804

!WARNING

This manual is intended for qualified service personnel only.

To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that

contained in the operating instructions unless you are qualified to do so. Refer all servicing to

qualified service personnel.

!WARNUNG

Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt.

Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die

Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu vermeiden, sind bei

Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen. Andere als die angegeben

Wartungsarbeiten dürfen nur von Personen ausgeführt werden, die eine spezielle Befähigung

dazu besitzen.

!AVERTISSEMENT

Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin

de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les

réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres.

Pour toute réparation faire appel à une personne compétente uniquement.

1-1 (E)

HKSR-5804

Section 1

Installation

Purpose of this manual

This manual is an installation manual of Network I/F Board HKSR-5804.

This manual is intended for system and service engineers, so describes information regarding installation.

Related manual

Besides this installation manual, the following manual is available for HKSR-5804.

.SRW-5800 Maintenance Manual (available on request)

This manual describes the information for the maintenance of this unit and the information that pre-

mises the parts level service.

If this information is required, contact your local Sony Sales Office/Service Center.

1-1. Specifications

General

Dimensions (w/h) MY-115 Board: 355 x183 mm

Mass MY-115 Board: approx. 1.03 kg

Power requirements +6.2V dc: 5.3 A

+3.3V dc: 1.8 A

Power consumption 38.8 W

1-2. Installation Overview

Components

.MY-115 Board (x1)

.Network panel assembly (x1)

Assembly of parts listed below

. Network 2 panel (x1)

. IF-1071 Board (incl. a modular jack) (x1)

. Coaxial cables with a BNC connector (x4)

.Connection cord (with modular plugs) (x1)

A ferrite core is attached.

.Operation manual (CD-ROM) (x1)

.Installation guide (x1)

.Installation manual (x1)

Applicable model

SRW-5800

1-2 (E) HKSR-5804

Matching Connectors/Cables/Signal Inputs and Outputs

When external cables are connected to the connector of this unit, the hardware listed below (or equiva-

lents) must be used.

Panel indication Matching connector (cable) Sony part No. Signal

AUX INPUT A BNC 75 Z, MALE 1-569-370-12 HD SDI signal input

AUX INPUT B BNC 75 Z, MALE 1-569-370-12 HD SDI signal input

AUX OUTPUT A BNC 75 Z, MALE 1-569-370-12 HD SDI signal output

AUX OUTPUT B BNC 75 Z, MALE 1-569-370-12 HD SDI signal output

NETWORK 2 Commercially available

NETWORK 2: RJ-45 modular jack

Standard : Complied with IEEE 802.3ab (1000BASE-T)

Pin No. I/O Signal

1 I/O TP0 (+)

2 I/O TP0 (_)

3 I/O TP1 (+)

4 I/O TP2 (+)

5 I/O TP2 (_)

6 I/O TP1 (_)

7 I/O TP3 (+)

8 I/O TP3 (_)

External view

1-3 (E)

HKSR-5804

Description of the switch function on the MY-115 Board

Ref. No Name Description Factory setting

S900 PCI Factory use

S1000 Reset System reset

S1001 —Factory use

S1400 —Factory use

S1401 —Factory use

S1402 —Factory use

S1403 —Factory use

A B C D E F G H J K L M NP

7S5000

S1001

S1000

S1404

S1402

S1400

S1403

S1401

S4501

S4500

S3001

S900

S3000

1-4 (E) HKSR-5804

Ref. No Name Description Factory setting

S1404 —S1401-1 OFF : Normal start

ON : Start by program of boot

S1401-2 to 8 Factory use

S3000 SW A Factory use

S3001 SW B Factory use

S4500 SW C Factory use

S4501 SW D Factory use

S5000 PLD SW A Factory use

1-5 (E)

HKSR-5804

1-3. Installation Procedure

1. Turn off the power of the VTR.

2. Fully loosen the fixing screw, and then slide the two

knobs on the upper lid (front) assembly each to the

inside.

Move the knobs to the outside to fix the upper lid

(front) assembly.

3. Remove the upper lid (front) assembly in the arrow

direction.

4. Fully loosen the two fixing screws, and then remove

the upper lid (rear) assembly in the arrow direction.

Knob

Upper lid (front) assembly

Fixing screw

Removal

Installation

Upper lid (rear)

assembly Fixing screw

Fixing screw

Protrusion

Square hole

1-6 (E) HKSR-5804

5. Disconnect all coaxial cables from HIF and FC (TX)

boards. Leaving EQ and HPR boards, raise eject levers

and then pull out the other boards upward.

6. Remove the six screws to detach the blank panel from

the connector panel assembly.

Remove the ten screws to detach the connector panel

assembly.

7. Attach the network panel assembly of HKSR-5804 to

the connector panel assembly with the screws that

were used for the blank panel.

8. Pass the four coaxial cables of the network panel

assembly one by one through the chassis.

APR

DVP

HIF

HPR

Eject lever

Blank panel Connector panel assembly

BVTT

3 x6

BVTT

3 x6

BVTT

3 x6

BVTT

3 x6

Connector panel assembly

Network panel assembly

Chassis

Coaxial cables

1-7 (E)

HKSR-5804

IF-1071 board

Connection cord

(with modular plugs)

Harness clamps

Connector panel assembly

BVTT3 x 6

Portion A

9. Connect the connection cord (with modular plugs) to the IF-1071 board on the network panel.

Insert the two connectors on the back of the connector panel assembly to the mother board, and fix

the connector panel assembly with ten screws.

Push the portions A of connector panel assembly, and connect it firmly to the connector of the mother

board.

Pass the connection cord (with modular plugs) through the two harness clamps and draw the other

end up.

1-8 (E) HKSR-5804

10. Check the DIP switches on the MY-115 board are

correctly set as Section 1-2.

11. Insert the MY-115 board and the plug-in boards, that

were removed in the step 5, into their respective slots.

Perform in the following order.

1) Insert the MY-115 board.

Be sure not to catch the connection cord (with

modular plugs) in the connectors of MY/Mother

boards.

2) Connect the connection cord (with modular plugs)

to CN700 on the MY-115 board.

3) Connect four coaxial cables to the MY-115 board.

4) Insert the HIF-46 board, and connect 13 coaxial

cables.

5) Insert the DVP-43 board (HKSR-5802).

6) Insert the FC-91 board (HKSR-5001) and connect

four coaxial cables to TX-96 boards on the FC-91

board.

7) Insert the APR-81 board.

8) Insert the SS-102 board.

9) Press down the eject levers of respective boards, to

tightly connect the boards to the connectors on the

mother board.

APR

DVP

HIF

HPR

Eject lever

CN700

LK76

CN2253

CN2254

CN2251

CN2250

MY-115 Board (HKSR-5804)

black

Connection cord (blue)

(with modular plugs)

CN211 CN213

CN210

CN209

CN202

CN205

CN208

CN203

CN204

CN200

CN201

CN207

CN206

black

white orange

HIF-46 Board

green

blue

CN204

CN203

TX-96

CN204

CN203

TX-96

black black

FC-91 Board/TX-96 Board (HKSR-5001)

Andere Handbücher für HKSR-5804

Inhaltsverzeichnis

Andere Sony Aufnahmegeräte Handbücher

Sony

Sony AWS-G500E Bedienungsanleitung

Sony

Sony SRW-1 Bedienungsanleitung

Sony

Sony TCM-4300 Bedienungsanleitung

Sony

Sony SLV-E510EE Bedienungsanleitung

Sony

Sony XDCAM PDW-HD1500 Bedienungsanleitung

Sony

Sony SRPC-1 Bedienungsanleitung

Sony

Sony DVW-500P Bedienungsanleitung

Sony

Sony SB-V3000 Bedienungsanleitung

Sony

Sony XDS1000 Bedienungsanleitung

Sony

Sony ICD-PX232 Bedienungsanleitung

Sony

Sony DPS-D7 Bedienungsanleitung

Sony

Sony AWS-G500HD Anycast Station Bedienungsanleitung

Sony

Sony HVR-M25C Bedienungsanleitung

Sony

Sony HSR-J2009 Bedienungsanleitung

Sony

Sony SRP-L210 Bedienungsanleitung

Sony

Sony RCD-W3 - Cd/cdr Recorder/player Bedienungsanleitung

Sony

Sony IFB-40 Bedienungsanleitung

Sony

Sony SIU-100 Bedienungsanleitung

Sony

Sony RCD-W100 Bedienungsanleitung

Sony

Sony SRW-1 Bedienungsanleitung

Sony

Sony HXR-IFR5 Bedienungsanleitung

Sony

Sony RCD-W3 - Cd/cdr Recorder/player Bedienungsanleitung

Sony

Sony MU-R201 Bedienungsanleitung

Sony

Sony CFD-S550 - Cd Radio Cassette-corder Bedienungsanleitung

Beliebte Aufnahmegeräte Handbücher anderer Marken

KV2 Audio

KV2 Audio 500 Series Bedienungsanleitung

Robotics Technologies

Robotics Technologies microBus-Cam II Bedienungsanleitung

Seca

Seca 460 Bedienungsanleitung

Cognex

Cognex MVS-8000 Series Bedienungsanleitung

Mect

Mect MPNC006 Series Bedienungsanleitung

Bad Caf

Bad Caf THE LEASH Bedienungsanleitung

Strymon

Strymon NIGHTSKY Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Bedienungsanleitung

Tews Technologies

Tews Technologies TPMC465 Bedienungsanleitung

Honeywell

Honeywell Excel 50 Bedienungsanleitung

SeaLevel

SeaLevel COMM+8.LPCI Bedienungsanleitung

Arturia

Arturia AUDIOFUSE STUDIO Bedienungsanleitung

Rukra

Rukra RK-1240 Bedienungsanleitung

Samson

Samson SCOM Bedienungsanleitung

Dynacord

Dynacord DPS260 Bedienungsanleitung

Pyle Pro

Pyle Pro PSS8 Bedienungsanleitung

Nice

Nice Core Bedienungsanleitung

RF-System

RF-System TinyGate Gebrauchs- und Pflegehandbuch