Sony SA-VE702 Bedienungsanleitung
Micro Satellite
System
3-867-384-12(1)
©1999 by Sony Corporation
SA-VE705
SA-VE702
Operating Instructions
Mode d’emploi
Owner’s Record
The model and serial numbers are located on the rear of the unit. Record the serial
number in the space provided below. Refer to them whenever you call upon your
Sony dealer regarding this product.
Model No. SA-VE705/VE702 Serial No.
GB
FR
2GB
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
NOTICE FOR THE CUSTOMERS IN THE
USA
This symbol is intended to alert the
user to the presence of uninsulated
“dangerous voltage” within the
product’s enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
CAUTION
You are cautioned that any changes or modification
not expressly approved in this manual could void
your authority to operate this equipment.
Note to CATV system installer:
This reminder is provided to call CATV system
installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.
NOTICE FOR THE CUSTOMERS IN
CANADA
CAUTION
TO PREVENT ELECTRIC SHOCK, DO NOT USE
THIS POLARIZED AC PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
3GB
GB
About this manual
The instructions in this manual are for SA-VE705 and SA-VE702, Sony Micro Satellite Systems.
Differences between the systems
•SA-VE705
The SA-VE705 is 5.1 channel speaker system consisting of two front speakers,
two rear speakers, one center speaker, and one subwoofer. It supports Sony Digital
Cinema Sound, Dolby* Pro Logic, and Dolby Digital (AC-3), and is thus geared
towards the enjoyment of movies.
•SA-VE702
Consisting of two front speakers and one subwoofer, the SA-VE702 is suited for the enjoyment
of music.
* Manufactured under license from Dolby Laboratories Licensing Corporation. DOLBY, the double-D symbol
;, “PRO LOGIC” and “Dolby Digital (AC-3)” are trademarks of Dolby Laboratories Licensing Corporation.
Any difference in operation is clearly indicated in the text, for example, “SA-VE705 only.”
Table of Contents
Hooking up the system ......................... 4
Positioning the speakers........................ 7
Listening to the sound ........................... 9
Adjusting the sound ............................ 10
Precautions ............................................ 11
Troubleshooting ................................... 12
Specifications ........................................ 12
4GB
Hooking up the system
Connect the speaker system to the speaker output terminals of an amplifier.
Make sure power to all components (included the subwoofer) is turned off before starting the
hook-up.
Hookup A (SA-VE705 only)
This configuration is used when the amplifier is connected to a DVD player, LD player, VCR or
other video devices.
eE Ee
Ee
Ee Ee
e
E
Ee Ee
LINE IN
WOOFER OUT
FRONT
CENTER REAR
R
R
L
L
Attach the satellite speakers (front, rear, and center speakers) to the supplied speaker stands for positioning.
For details, see “Positioning the front (and rear) speakers” on page 7 and “Positioning the center speaker
(SA-VE705 only)” on page 8.
Terminal (jack) connections
E
e
E
e
E
e
Ee
Amplifier
Front (Right) Subwoofer Center Front (Left)
Rear (Left)Rear (Right)
loosen
tighten
5GB
Hookup B (SA-VE705 only)
Try this configuration instead of “Hookup A” in the following situations:
— When there are no jacks on the amplifier for a subwoofer.
— When you want stronger bass sound from the subwoofer.
R
L
R
L
Ee Ee
SPEAKER
IN SPEAKER
OUT
e
e
E
E
eE Ee
Ee
FRONT
CENTER REAR
R
R
L
L
Ee Ee
e
E
Attach the satellite speakers (front, rear, and center speakers) to the supplied speaker stands for positioning.
For details, see “Positioning the front (and rear) speakers” on page 7 and “Positioning the center speaker
(SA-VE705 only)” on page 8.
Terminal connections
E
e
E
e
E
e
Ee
continued
Front (Right)
Subwoofer
Center Front (Left)
Rear (Left)Rear (Right)
Amplifier
loosen
tighten
6GB
Hookup C (SA-VE702 only)
This configuration is used when the amplifier is connected to a CD player, MD deck, cassette
deck, or other audio devices.
eE Ee
Ee Ee
FRONT
R
L
R
L
SPEAKER
IN SPEAKER
OUT
e
e
E
E
RL
Attach the front speakers to the supplied speaker stands for positioning. For details, see “Positioning the front
(and rear) speakers” on page 7.
Terminal connections
E
e
E
e
E
e
Ee
Notes
• Make sure the plus (+) and the minus (–) terminals on the speakers are matched to the corresponding the plus
(+) and the minus (–) terminals on the amplifier.
• Be sure to tighten the screws of the speaker terminals securely since loose screws may become a source of
noise.
• Make sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a
short-circuit.
• Do not connect the subwoofer to the amplifier’s CENTER output terminal (which is for Dolby Pro Logic or
Dolby Digital (AC-3)). No bass will output from the subwoofer if you do.
• For details regarding the connections on the amplifier side, refer to the manual that was provided with your
amplifier.
Tip
It is convenient to remember that all striped wires are minus (–) in polarity and should be connected to the
minus (–) speaker terminals.
Hooking up the system (continued)
Front (Right)
Subwoofer
Front (Left)
Amplifier
loosen
tighten
7GB
Positioning the
speakers
Location of each
speaker
AA
BB
*SA-VE705 only
Each speaker should face the listening
position. Better surround effect will result if
all speakers are set at the same distance from
the listening position.
Place the front speakers at a suitable distance
to the left and right of the television.
Place the subwoofer on either side of the
television.
Place the center speaker on the top-center of
the TV set.
The placement of rear speakers greatly
depends on the configuration of the room.
The rear speakers may be placed on both
sides of the listening position Aor behind
the listening position B.
Tips
• Movies are best enjoyed in a room that produces
no echoes (as in one with surrounding curtains).
• Music (especially classical music) is best enjoyed
in a room that produces some echo.
• Adjust the height of the front speakers so that it
corresponds with the center of the TV screen, as
illustrated below.
Positioning the front
(and rear) speakers
Attach the front (and rear) speakers to
supplied speaker stands and place them at
their optimum locations.
For details on the location of the front (and
rear) speakers, see “Location of each speaker”
on this page.
1Detach the plate from the stand.
2Pass the speaker cord into the hole
on the back of the stand and out
from the hole at the center of the
stand.
Center*
Subwoofer
Front
(Right)
Rear*
(Right)
Rear*
(Left)
Front
(Left)
continued
8GB
3Separate the speaker cord, then
secure the cord to the speaker stand
with the plate.
4Connect the speaker cord to the
speaker terminal.
The cord should be pressed into the
groove in the stand.
5Using the supplied hex wrench, two
screws, and washers, secure the
speaker to the stand.
Notes
• Do not remove the supplied speaker grille from
the speaker while attaching the speaker to the
speaker stand.
• Do not touch or press tweeter’s cover on the center
of the speaker.
Positioning the speakers
(continued) Positioning the center
speaker
(SA-VE705 only)
Attach the center speaker to the supplied
speaker stand and place it on a top of the TV
set.
For optimum listening enjoyment, the
speaker should face directly towards the
listener. Adjust the angle of the speaker
stand for that purpose.
1Pass the speaker cord into the hole
on the back of the stand and out
from the hole at the center of the
stand.
2Connect the speaker cord to the
speaker terminal.
9GB
3Using the supplied hex wrench, two
screws, and washers, secure the
speaker to the stand.
Notes
• Do not remove the supplied speaker grille from
the speaker while attaching the speaker to the
speaker stand.
• Do not touch or press tweeter’s cover on the center
of the speaker.
4Adjust the angle of the speaker
stand.
Loosen the two screws under the base to
adjust the angle. Then tighten them
again afterwards.
15º
25º
The optional speaker
stands
For greater flexibility in the positioning of the
speakers, use the optional WS-FV10 (floor
stand), WS-TV10 (TV stand), or WS-WV10
(wall mount bracket) speaker stand (available
only in certain countries).
Listening to the sound
Operation panel on the subwoofer
!
LEVEL MODE
MIN
ON/
STANDBY
MAX
MOVIE MUSIC
!
First, turn down the volume on the amplifier.
The volume should be set to minimum before
you begin playing the program source.
1Turn on the amplifier and select the
program source.
2Press !on the subwoofer.
The ON/STANDBY indicator on the
subwoofer lights up green.
3Play the program source.
Power turns on and off
automatically — Auto power on/off function
When the subwoofer is on (i.e, the
ON/STANDBY indicator lights up green)
and there is no signal input for a few minutes,
the ON/STANDBY indicator changes to red
and the subwoofer enters power saving
mode. While in this mode a signal is input to
the subwoofer, the subwoofer automatically
turns on (auto power on/off function).
To turn this feature off, slide the POWER
SAVE switch on the rear panel to OFF.
AUTO
OFF
POWER
SAVE
Note
If you turn down the volume level of the subwoofer
too low, the auto power on/off function may
activate, causing the subwoofer to enter power
saving mode.
ON/STANDBY
indicator
WS-FV10 WS-TV10 WS-WV10
Screws
10GB
Adjusting the sound
Slight adjustments to the system can enhance
your sound enjoyment.
Adjusting the
subwoofer
Operation panel on the subwoofer
LEVEL MODE
LEVEL MODE
MIN
ON/
STANDBY
MAX
MOVIE MUSIC
!
1Set MODE according to the program
source as follows:
Source MODE
DVD, LD, video cassette MOVIE
or other video source
MD, CD, cassette tape MUSIC
or other audio source
2Rotate LEVEL to adjust the volume.
Set the volume level to suit the program
source.
Notes
• Some amplifier functions for enhancing the sound
may cause distortion in the subwoofer. If such
distortion occurs, turn off those functions.
• To enjoy high-quality sound, do not turn the
subwoofer volume too high.
• To increase the bass sound from the subwoofer,
connect the system using “Hookup B” (see
page 5).
Setting your amplifier
to enjoy movies
(SA-VE705 only)
For the Dolby Digital (AC-3)
If your amplifier is connected internally or
externally with a Dolby Digital (AC-3)
processor, you should use the some setup
menus in the amplifier to specify the
parameters of your speaker system.
See the table below for the proper settings.
For details on the setting procedure, refer to
the manual that was provided with your
amplifier.
When “Hookup A” is used
(Speaker setup menu)
For Set to
Front speakers SMALL
Center speaker SMALL
Rear speakers SMALL
Subwoofer ON (or YES)
(Other setup menu)
Menu Set to
LFE* MIX –10 dB
BASS BOOST** ON
* Low Frequency Effect
**A function that reinforces the bass sound
When “Hookup B” is used
(Speaker setup menu)
For Set to
Front speakers LARGE
Center speaker SMALL
Rear speakers SMALL
Subwoofer OFF (or NO)
(Other setup menu)
Menu Set to
LFE MIX –10 dB
BASS BOOST ON
Andere Handbücher für SA-VE702
1
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Sprachen:
Andere Sony Stereoanlage Handbücher
Sony
Sony HCD-F250AV - Compact Disc Receiver System Bedienungsanleitung
Sony
Sony CFD-S70 Bedienungsanleitung
Sony
Sony MHC-GN800 Bedienungsanleitung
Sony
Sony HCD-MD595 Bedienungsanleitung
Sony
Sony CAS-1 Bedienungsanleitung
Sony
Sony MHC-GN88D Bedienungsanleitung
Sony
Sony HCD-GX35 Bedienungsanleitung
Sony
Sony SRS-X2 Bedienungsanleitung
Sony
Sony CMT-EH25 Bedienungsanleitung
Sony
Sony HCD-RG550 Bedienungsanleitung
Sony
Sony HCD-GNX700 Bedienungsanleitung
Sony
Sony HCD-GNZ77D Bedienungsanleitung
Sony
Sony HCD-GT111 Bedienungsanleitung
Sony
Sony HCD-GNV99D Bedienungsanleitung
Sony
Sony ZS-E5 Marketing Specifications (Aqua) Bedienungsanleitung
Sony
Sony HCD-RXD6AV Bedienungsanleitung
Sony
Sony HCD-EP50LIV Bedienungsanleitung
Sony
Sony SRS-X9 Bedienungsanleitung
Sony
Sony HCD-DX70 Bedienungsanleitung
Sony
Sony MEX-BT4100E Bedienungsanleitung
