Sony StorStation LIB-D81 Bedienungsanleitung

LIB-D81

4-673-839-12 (1)

AIT Autoloader

Operating Instructions

Before operating the unit, please read this manual

thoroughly and retain it for future reference.

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet.

Refer servicing to qualified personnel only.

Caution

The mains plug on this equipment must be used to disconnect mains power.

Please ensure that the socket outlet is installed near the equipment and shall be easily accessible.

NOTICE

Use the power cord set approved by the appropriate testing organization for the specific countries where this unit is to be

used.

Achtung

Zur Trennung vom Netz ist der Netzsecker aus der Steckdose zu ziehen, welche sich in der Nähe des Gerätes befinden

muß und leicht zugänglich sein soll.

Hinweis

Der höchste Schalldruckpegel beträgt 70 dB(A) order weniger gemäß ISO7779.

Ratings

Voltage

AC 100 V - 240 V

Current

0.7 A - 0.35 A

Frequency

50 / 60 Hz

Max. Ambient Temperature

40°C

A certified power supply cord has to be used with this equipment.

The relevant national installation and/or equipment regulations shall be considered.

A certified power supply cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227

(designation H05VV-F 3G 0.75 mm2or H05VVH2-F2 3G 0.75 mm2) shall be used. Alternative a flexible cord be of

synthetic rubber according to IEC 60245 (designation H05RR-F 3G 0.75 mm2) shall be used.

Zum Netzanschluss dieses Gerätes ist eine geprüfte Leitung zu verwenden.

Es sind die zutreffenden nationalen Errichtungs- und/oder Gerätebestimmungen zu beachten.

Es isteine geprüfte flexible PVC-ummantelte Leitung entsprechend IEC 60227 (H05VV-F 3G 0.75 mm2oder H05VVH2-

F 3G 0.75 mm2) zu verwenden. Andernfalls ist eine flexible Leitung aus synthetischem Gummi entsprechend IEC 60245

(Bauartkurzzeichen H05RR-F 3G 0.75 mm2) zu verwenden.

INFORMATION

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to

operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmfulinterference to radio communications.However,there isno guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experience radio/TV technician for help.

The shielded interface cable recommended in this manual must be used with this equipment in order to comply with the

limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

If you have any questions about this product, please access Sony Support Center written in the warranty card.

Ratings are indicated on the rear, while regulatory agency marks are separately affixed on the bottom.

Declaration of Conformity

Trade Name: SONY

Model No.: LIB-D81

Responsible Party: Sony Electronics Inc.

Address: 680 Kinderkamack Road Oradell, NJ 07649-1601

Telephone No.: 201-930-6972

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Table of Contents

Chapter 1 Introduction

Overview.......................................................................7

Product Features and Functions ...............................8

Front................................................................................8

Rear.................................................................................9

Interior (Front) ..............................................................10

AIT Drive (Front)..........................................................11

System Structure.......................................................12

Compatible Cartridges..............................................12

AIT Cartridges ..............................................................12

Cleaning Cartridge........................................................13

Software .....................................................................13

Precautions................................................................13

Chapter 2 Installation

Overview.....................................................................14

Unpacking ..................................................................14

Package Contents .....................................................15

Preparing the Host Computer ..................................15

Installing the AIT Autoloader....................................16

Connecting the Power Cable....................................17

Connecting to the Host Computer...........................17

Setting the DIP Switches ..........................................19

Setting the SCSI ID....................................................21

Connecting SCSI Peripheral Devices......................22

Turning the Power On/Off.........................................22

Setting Cartridges .....................................................24

Preparing Cartridges .....................................................24

Inserting Cartridges.......................................................25

Setting Application Software....................................27

Chapter 3 Basic Usage

Overview.....................................................................28

Control Panel .............................................................28

Using the Control Panel................................................28

Message Display ...........................................................29

Warnings ....................................................................29

Errors..........................................................................30

Disaster Recovery Function.....................................31

Assigned Element Addresses..................................32

Handling the Cartridges............................................32

Handling........................................................................32

Storing...........................................................................33

Maintenance...............................................................33

Chapter 4 Operating the AIT Autoloader

Overview.....................................................................34

Using Cartridges........................................................34

Ejecting/Changing Cartridges.......................................34

Chapter 5 Cleaning the AIT Drive

Overview.....................................................................37

Cleaning the AIT Drive ..............................................37

Appendix

Cleaning the Air Filter ...............................................41

Troubleshooting ........................................................42

Transporting the AIT Autoloader .............................44

Hardware Specifications...........................................45

Hardware.......................................................................45

Memory.........................................................................45

SCSI Cable and Terminator Specifications.............46

SCSI Cable....................................................................46

SCSI Cable Length........................................................46

SCSI Specifications...................................................46

About the SCSI Components........................................46

About the SCSI Bus......................................................46

Error Code List ..........................................................47

Other Messages.........................................................52

Index ...........................................................................55

Trademarks

• Sony, StorStation and Advanced Intelligent Tape are trademarks or registered trademarks of Sony Corporation in this

country, other countries, or both.

• Other product names are trademarks or registered trademarks of their respective owners in this country, other countries,

or both.

Chapter 1 Introduction

Chapter1

Introduction

Overview

The LIB-D81 is a desktop AIT (Advanced Intelligent Tape) automatic loader

(hereafter, “AIT autoloader”) with a built-in AIT drive. Up to 8 cartridges can

be inserted in the AIT autoloader. The unit can also be connected to and used

with a workstation or server.

Up to 8 cartridges can be used

Up to 8 AIT cartridges can be used. Cartridges can be replaced from the front

panel. The following types of cartridges can be used in this AIT autoloader:

• AIT-3 cartridge: records up to 1.6 terabytes of data

• AIT-2 cartridge: records up to 0.8 terabytes of data

• AIT-1 cartridge: records up to 0.56 terabytes of data

Notes

• Cartridges that can be used vary according to the type of built-in drive.

• The memory capacity mentioned above assumes a data compression ratio of

2:1.

Compact

Because of its compact size (170 × 350 × 224 mm) and light weight (approx. 7

kg), the LIB-D81 is the perfect desktop AIT Autoloader.

Wide LVD SCSI compliant

The AIT autoloader is Wide LVD SCSI compliant.

Chapter 1 Introduction

Product Features and Functions

Front

AVentilation Holes

Be careful not to block the ventilation holes. If the ventilation holes are blocked,

the AIT autoloader may overheat, resulting in damage.

BFront Door

Used in inserting and ejecting AIT cartridges. Press the DOOR button to unlock

and open the door. The AIT autoloader cannot operate when the door is open,

therefore when inserting or replacing a cartridge, be that the door is securely

closed. When the door is closed it locks automatically.

CDOOR Button

Press to open the front door. Do not press this button while the AIT autoloader

is operating.

DCLEAN Button

Insert the cleaning cartridge in slot CL/8 and press for at least three seconds to

clean the AIT drive.

EMessage Display

The message display displays how many cartridges are in the AIT autoloader.

When in normal standby state, it displays the status of the AIT autoloader.

FERROR/WARNING LED

Lights or flashes orange when a specific operation is necessary or an error

occurs. When it lights it indicates a warning, whereas when it flashes it indicates

an error. When this happens, a 2-character code appears on the message display.

For details about these codes, see “Error Code List” (page 47), “Other

Messages” (page 52), or the code reference table.

GCLEANING LED

Flashes green when the AIT drive is in need of cleaning. For details about

cleaning the AIT drive, see “Cleaning the AIT Drive” (page 37).

AIT LIBRARY LIB-D81

CLEAN DOOR

WARNING

CLEANING

ERROR

Chapter 1 Introduction

Rear

ASetup DIP Switches and DIP Switch Cover

Used to set up the AIT autoloader. Remove the screws and cover to access the

DIP switches. For details, see “Setting the DIP Switches” (page 19).

BVentilation Holes

Please be careful not to block the ventilation holes. If the ventilation holes are

blocked, the AIT autoloader may overheat, resulting in damage.

CPower Switch

To turn the AIT autoloader on or off, press this power switch. When you restart

the AIT autoloader, be sure to wait at least 10 seconds before turning it on again.

DPower Supply Connector

Plug the provided power cord into this connector.

ESCSI connector 1 6SCSI connector 2

For information about connecting the SCSI connectors, see “Connecting to the

Host Computer” (page 17) and “Connecting SCSI Peripheral Devices” (page

22) in Chapter 2, “Installation”.

FSCSI ID Setup Switch

Used to set the SCSI ID of the AIT autoloader. For details, see“Setting the SCSI

ID” (page 21).

1 2

567

Chapter 1 Introduction

Interior (Front)

AFront Door

BAir Filter

Periodically clean the air filter with a vacuum cleaner (we recommend monthly

cleaning). For details about how to replace the air filter, see “Cleaning the Air

Filter” (page 41).

CCartridge Case

You can insert up to eight AIT cartridges in the case. Slots are numbered 1 to 8,

from the highest slot down. When using it, make sure that you insert the

cleaning cartridge in slot CL/8 (the lowest slot).

DAIT Drive

The AIT autoloader is equipped with one AIT drive.

EElevator

Lowers cartridges to the AIT drive and returns them to their slots. When you

turn on the AIT autoloader, the elevator moves up and down counting the

cartridges, whose number appears on the message display.

AITLIBRARYLIB-D81

CLEAN DOOR

WARNING

CLEANING

ERROR

Andere Handbücher für StorStation LIB-D81

Inhaltsverzeichnis

Andere Sony Lagerung Handbücher

Sony

Sony StorStation AITi90 Bedienungsanleitung

Sony

Sony CSMA-EX200S Bedienungsanleitung

Sony

Sony AIT-SDX460 Montageanleitung

Sony

Sony MSAC-US40 - MemoryStick Flash Memory Card USB 2.0... Bedienungsanleitung

Sony

Sony PCV-LX810 - Vaio Slimtop Computer Bedienungsanleitung

Sony

Sony PWS-4400 Bedienungsanleitung

Sony

Sony PDW-1 Bedienungsanleitung

Sony

Sony MicroVault USM4GM Bedienungsanleitung

Sony

Sony SDX-900V Series Bedienungsanleitung

Sony

Sony MicroVault USM4GL Bedienungsanleitung

Sony

Sony RMO-S551 Bedienungsanleitung

Sony

Sony LKRA-009 Bedienungsanleitung

Sony

Sony VAIO PCGA-CDRWX1 Bedienungsanleitung

Sony

Sony VGC-RB10M - Vaio Desktop Computer Bedienungsanleitung

Sony

Sony SR Series Bedienungsanleitung

Sony

Sony SDX-550V Bedienungsanleitung

Sony

Sony SDX-300 Series Bedienungsanleitung

Sony

Sony HDPS-M10 - Data Storage Wallet Bedienungsanleitung

Sony

Sony QDH16 Bedienungsanleitung

Sony

Sony HD-EG5 Bedienungsanleitung

Sony

Sony HD-EG5 Bedienungsanleitung

Sony

Sony VGN-CS320J Bedienungsanleitung

Sony

Sony MicroVault USM64GQX Bedienungsanleitung

Sony

Sony StorStation AITi1040 Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

HP P9000 Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung