Sony SLV-KA177PL Bedienungsanleitung

Video Cassette

Player

Operating Instructions

3-861-244-12 (1)

SLV-KA177PL

Introduction

WARNING

To prevent fire or shock hazard, do not expose

the unit to rain or moisture.

To avoid electrical shock, do not open the

cabinet. Refer servicing to qualified personnel

only.

The mains lead must only be changed at a

qualified service shop.

Precautions

Safety

• This unit operates on 110 – 240 V AC,

50/60 Hz. Check that the unit’s operating

voltage is identical with your local power

supply.

• If anything falls into the cabinet, unplug the

unit and have it checked by qualified

personnel before operating it any further.

• The unit is not disconnected from the mains

as long as it is connected to the mains, even

if the unit itself has been turned off.

• Unplug the unit from the mains if you do

not intend to use it for an extended period of

time. To disconnect the cord, pull it out by

the plug, never by the cord.

Installing

• Allow adequate air circulation to prevent

internal heat buildup.

• Do not place the unit on surfaces (rugs,

blankets, etc.) or near materials (curtains,

draperies) that may block the ventilation

slots.

• Do not install the unit near heat sources

such as radiators or air ducts, or in a place

subject to direct sunlight, excessive dust,

mechanical vibration or shock.

• Do not install the unit in an inclined

position. It is designed to be operated in a

horizontal position only.

• Keep the unit and cassettes away from

equipment with strong magnets, such as

microwave ovens or large loudspeakers.

• Do not place heavy objects on the unit.

• If the unit is brought directly from a cold to

a warm location, moisture may condense

inside the unit and cause damage to the

video head and tape. When you first install

the unit, or when you move it from a cold to

a warm location, wait for about one hour

before operating the unit.

Caution

Television programmes, films, video tapes, and

other materials may be copyrighted.

Unauthorized recording of such material may

be contrary to the provisions of the copyright

laws. Also, use of this recorder with cable

television transmission may require

authorization from the cable television

transmitter and/or programme owner.

Introduction 3

Table of contents

Getting Started

4Step 1: Unpacking

5Step 2: Setting up the remote commander

6Step 3: Hookups

Basic Operations

10 Playing a tape

Additional Operations

12 Playing/searching at various speeds

14 Karaoke sing-along

16 Adjusting the picture

Additional Information

17 General setup information

18 Troubleshooting

20 Specifications

21 Index to parts and controls

back cover

Index

Getting Started

Step 1

Unpacking

Check that you have received the following items with the unit:

• 75-ohm coaxial cable with F-type

connectors

• Microphone

• Remote commander

• R6 (Size AA) batteries

Getting Started 5

Getting Started

Step 2

Setting up the remote commander

Inserting the batteries

Insert two R6 (size AA) batteries by

matching the + and – on the batteries to

the diagram inside the battery

compartment.

Insert the negative (–) end first, then push

in and down until the positive (+) end

clicks into position.

Using the remote commander

You can use this remote

commander to operate the unit

and a Sony TV. To operate this

unit, point at the remote sensor

on the unit. To operate the TV,

point at the remote sensor on

the TV.

Notes

• With normal use, the batteries should last about three to six months.

• If you do not use the remote commander for an extended period of time, remove

the batteries to avoid possible damage from battery leakage.

• Do not use a new battery with an old one.

• Do not mix different types of batteries.

Turn the TV to standby or active mode

Turn on the TV power

Increase (+) or decrease (–) the TV volume

Change the TV programme position

Select an input source of the TV either from aerial in or from line in

Press

u(on/standby)

;(TV power)

VOL +/–

PROG(CH) +/–

TV/VIDEO

Remote sensor

;(TV power)

(on/standby)

TV/VIDEO

PROG(CH) +/–

VOL +/–

REC

Getting Started

Step 3

Hookups

Selecting the hookup

There are basically two ways to hookup this unit depending on whether

your TV has audio/video inputs or not.

If your TV has audio/video inputs

See “Audio/video (A/V) hookup” on page 7.

If your TV doesn’t have audio/video inputs

See “Antenna hookup” on pages 8 and 9.

Before you get started

• Turn off the power to all equipment.

• Do not connect the AC power cords until all of the connections are

completed.

• Be sure you make connections firmly. Loose connections may cause

picture distortion.

• If your TV doesn’t match any of the examples provided, see your nearest

Sony dealer or qualified technician.

Getting Started 7

Getting Started

Audio/video (A/V) hookup

If your TV has audio/video (A/V) input jacks, you will get a better picture

and sound if you hook up your unit using these connections.

You’re finished setting up the unit after you’ve made the connections.

If your TV doesn’t have A/V inputs, see page 8 for antenna hookup.

AUse this hookup if your TV has stereo jacks

BUse this hookup if your TV doesn’t have stereo jacks

continued

This unit

Audio/video cable (not supplied)

VIDEO

AUDIO

AUDIO VIDEO

LINE OUT

VIDEO

AUDIO

AUDIO VIDEO

LINE OUT

Getting Started

Make the following connections if your TV doesn’t have A/V inputs.

AUse this hookup if you’re using:

• VHF/UHF antenna (you get channels 2–13 and channels 14 and higher)

• UHF-only antenna (you get channels 14 and higher)

• Separate VHF and UHF antennas

Antenna hookup

VHF/UHF Match the type of

connector on your

TV: A, B, or C.

Rear of TV

VHFC

UHF

VHF

This unit

UHF

BUse this hookup if you’re using a VHF-only antenna (you get

channels 2–13 only)

Rear of TV

VHF/UHF Match the type of

connector on your

TV: A, B, or C.

BFor connector types

B and C, no UHF

connection is

required.

UHF

VHF

UHF

This unit

If you cannot connect your antenna cable to the unit directly

If your antenna cable is a flat cable (300-ohm twin lead cable), attach an external

antenna connector (not supplied) so you can connect the cable to the VHF/UHF IN

connector. If you have separate cables for VHF and UHF antennas, you should use a

U/V band mixer (not supplied). For details, see page 17.

OUT

VHF/UHF

OUT

VHF/UHF

Step 3: Hookups (continued)

Getting Started 9

Getting Started

When connecting the unit to the TV using only the antenna cable, you must

set the RF UNIT switch on the rear of the unit so that the TV can receive the

correct signal from the unit.

1Set the RF UNIT switch to

CH 3 or CH 4, whichever

channel is not used in your

area. If both are used, set the

switch to either channel.

2Insert a recorded tape into

the tape compartment.

The unit turns on and starts

playing automatically.

3Press TV/VTR to turn on the

TV/VTR indicator in the

display window.

4Press ·PLAY (if playback

didn’t start in step 2).

5Turn on your TV and set it to

the channel you selected in

step 1 (channel 3 or 4).

The video playback picture

will be clearly displayed on

the TV screen.

Whenever you use the unit,

set the TV to the channel

selected in step 1.

Antenna hookup: Video cassette player setup

TV/VTR

·PLAY

RF UNIT

CH4

CH3

Basic Operations

Playing a tape 6EJECT

PPAUSE

3/#

)FF

·PLAY

0REW

pSTOP

PLAY

1Turn on your TV and set it to the video channel.

2Insert a tape.

The unit turns on, and starts playing

automatically if you insert a tape with its

safety tab removed.

3Press ·PLAY.

When the tape reaches the end, it will rewind automatically.

REC

Inhaltsverzeichnis

Andere Sony Videorecorder-System Handbücher

Sony

Sony SLV-AX10 - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-KS1 - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-798HF Bedienungsanleitung

Sony

Sony HDCAM-SR SRW5800 Bedienungsanleitung

Sony

Sony SLV-N500 - Video Cassette Recorder Bedienungsanleitung

Sony

Sony PVW-2600 Bedienungsanleitung

Sony

Sony Walkman GV-8 Bedienungsanleitung

Sony

Sony SLV-ED55PS Bedienungsanleitung

Sony

Sony SLV-N71 - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-777HF - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-662HF Operating Instructions (SLV-662HF / 679HF / 679HF PX... Bedienungsanleitung

Sony

Sony EV-S3000 Bedienungsanleitung

Sony

Sony SLV-998HF CS Bedienungsanleitung

Sony

Sony Professional U-matic SP BVU-950 Bedienungsanleitung

Sony

Sony SLV-772HF - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-688HF - Video Cassette Recorder Bedienungsanleitung

Sony

Sony DVCAM DSR-80 Bedienungsanleitung

Sony

Sony SLV-GA30 Bedienungsanleitung

Sony

Sony SVT-DL224 Bedienungsanleitung

Sony

Sony SLV-LX66S Bedienungsanleitung

Sony

Sony SLV-SE610K Bedienungsanleitung

Sony

Sony SLV-E205EY Bedienungsanleitung

Sony

Sony DVW-A500P/1 Bedienungsanleitung

Sony

Sony SLV-765HF Bedienungsanleitung

Beliebte Videorecorder-System Handbücher anderer Marken

Toshiba

Toshiba M-662 Bedienungsanleitung

JVC

JVC HR-J282EU Bedienungsanleitung

Magnavox

Magnavox VRU242AT Bedienungsanleitung

RCA

RCA VR634HF - Hi-Fi VCR Bedienungsanleitung

JVC

JVC HR-5910U Bedienungsanleitung

Panasonic

Panasonic ProLine AG-1320 Bedienungsanleitung

JVC

JVC HR-S8600EU Bedienungsanleitung

JVC

JVC HR-FS1U Bedienungsanleitung

Sharp

Sharp VC-H9888U Bedienungsanleitung

FUNAI

FUNAI LC-950 Bedienungsanleitung

Sharp

Sharp VC-S2000GM Bedienungsanleitung

Panasonic

Panasonic Omnivision PV-V4523S Bedienungsanleitung

Aiwa

Aiwa HV-E212 Bedienungsanleitung

JVC

JVC HR-J3006UM Bedienungsanleitung

GE VG4271 Bedienungsanleitung

Panasonic

Panasonic AGDTL1P - TIME LAPSE RECORDER Bedienungsanleitung

RCA

RCA VR678HF Bedienungsanleitung

Sylvania

Sylvania SRV196 Bedienungsanleitung