Sony SLV-KH7PL Bedienungsanleitung

Video Cassette

Player

SLV-KH7PL

3-861-477-11 (1)

Operating Instructions

Introduction

WARNING

To prevent fire or shock hazard, do not expose

the unit to rain or moisture.

To avoid electrical shock, do not open the

cabinet. Refer servicing to qualified personnel

only.

The AC power cord must be changed only at a

qualified service shop.

Precautions

Safety

• This unit operates on 110 – 240 V AC, 50/60

Hz. Check that the unit’s operating voltage

is identical with your local power supply.

• If anything falls into the cabinet, unplug the

unit and have it checked by qualified

personnel before operating it any further.

• The unit is not disconnected from the AC

power source (mains) as long as it is

connected to the wall outlet, even if the unit

itself has been turned off.

• Unplug the unit from the wall outlet if you

do not intend to use it for an extended

period of time. To disconnect the cord, pull

it out by the plug, never by the cord.

Installing

• Allow adequate air circulation to prevent

internal heat buildup.

• Do not place the unit on surfaces (rugs,

blankets, etc.) or near materials (curtains,

draperies) that may block the ventilation

slots.

• Do not install the unit near heat sources

such as radiators or air ducts, or in a place

subject to direct sunlight, excessive dust,

mechanical vibration or shock.

• Do not install the unit in an inclined

position. It is designed to be operated in a

horizontal position only.

• Keep the unit and cassettes away from

equipment with strong magnets, such as

microwave ovens or large loudspeakers.

• Do not place heavy objects on the unit.

• If the unit is brought directly from a cold to

a warm location, moisture may condense

inside the unit and cause damage to the

video head and tape. When you first install

the unit, or when you move it from a cold to

a warm location, wait for about one hour

before operating the unit.

Caution

Television programs, films, video tapes and

other materials may be copyrighted.

Unauthorized recording of such material may

be contrary to the provisions of the copyright

laws. Also, use of this recorder with cable

television transmission may require

authorization from the cable television

transmitter and/or program owner.

Introduction

Table of contents

Getting Started

4Step 1: Unpacking

5Step 2: Setting up the remote commander

6Step 3: Hookups

Basic Operations

12 Playing a tape

16 Recording TV programs

Additional Operations

19 Playing/searching at various

speeds

21 Recording TV programs using the

easy timer

22 Karaoke sing-along

30 Searching with the AMS or index

function

32 Enjoying the surround sound

(Virtual Sound)

33 Adjusting the picture

34 Changing menu options

Editing

35 Hooking up to a VCR or stereo

system

36 Basic editing

37 Audio dubbing

Additional Information

40 General setup information

41 Troubleshooting

43 Specifications

44 Index to parts and controls

back cover

Index

Getting Started4

Getting Started

Step 1

Unpacking

Check that you have received the following items with the unit:

• Remote commander

• Size AA (R6) batteries

• 75-ohm coaxial cable with F-type

connectors

• Audio/video cable (3-phono to 3-

phono)

• Microphone

• Plug adaptor

If the plug supplied with your VCR does not

fit your power outlet, attach the supplied

adaptor to the plug.

5Getting Started

Getting Started

Inserting the batteries

Insert two size AA (R6) batteries by

matching the + and – on the

batteries to the diagram inside the

battery compartment.

Insert the negative (–) end first,

then push in and down until the

positive (+) end clicks into

position.

Using the remote commander

You can use this remote

commander to operate this unit

and a Sony TV. Buttons on the

remote commander marked with

a dot (•) can be used to operate

your Sony TV.

Step 2

Setting up the remote commander

Notes

• With normal use, the batteries should last about three to six months.

• If you do not use the remote commander for an extended period of time, remove

the batteries to avoid possible damage from battery leakage.

• Do not use a new battery with an old one.

• Do not use different types of batteries.

Remote sensor

To operate

the unit

a Sony TV

Set TV / VIDEO to

VIDEO and point at the remote sensor on the unit

TV and point at the remote sensor on the TV

TV␣ ␣ /␣ ␣ VIDEO

Getting Started6

Hookups

Selecting the best hookup option

There are many ways in which your unit can be hooked up. To hook up your

unit so that it works best for you, first scan through the table below. Then

use the accompanying diagrams and procedures on the following pages to

set up your unit.

Step 3

If you have

a TV that has both audio/

video inputs and outputs

a TV that has only audio/

video inputs

a TV that has neither audio/

video inputs nor outputs

Use

Audio/video (A/V) hookup for

viewing

Audio/video (A/V) hookup for

recording TV programs

Audio/video (A/V) hookup for

viewing

Antenna hookup

Refer to

Pages 7 and 8

Page 9

Page 7

Pages 10 to 11

After you’ve completed the connections, follow the instructions for setup.

During setup, if you need more details on the procedure described, page

numbers are provided where you can find complete, step-by-step

instructions.

After you’ve completed the setup, you’re ready to use your unit.

Before you get started

• Turn off the power to all equipment.

• Do not connect the AC power cords until all of the connections are

completed.

• Be sure you make connections firmly. Loose connections may cause

picture distortion.

• If your TV doesn’t match any of the examples provided, see your nearest

Sony dealer or qualified technician.

7Getting Started

Getting Started

Audio/video (A/V) hookup for viewing

If your TV has audio/video (A/V) input jacks, you will get a better picture

and sound if you hook up your unit using these connections. In addition,

for a true “home theater” experience, you should connect the audio outputs

of your unit or TV to your stereo system. If your TV doesn’t have A/V

inputs, see “Antenna hookup” on page 10.

If you’re planning to use your unit only to play back pictures and movies,

you’re finished setting up the unit after you’ve made these connections. If

you have a TV with audio/video outputs, and want to record TV programs

from your TV, complete these connections first, and then go to “Audio/

video (A/V) hookup for recording TV programs” on page 9.

Pages 7 and 8

AUse this hookup if your TV has stereo jacks

BUse this hookup if your TV doesn’t have stereo jacks

This unit

Audio/video cable (supplied)

Stereo receiver

This unit

Video cable (not supplied) Audio cable (not supplied)

Stereo receiver

Notes

• To play a tape in stereo, you must use the A/V connection.

• If you want to use the Trinitron TV Synchro Play function (page 15), the connection

using the audio/video cable is necessary. (If your TV has two or more inputs,

connect the audio/video cable to the VIDEO IN 1 jacks.)

continued

VIDEO

AUDIO

AUX IN

AUDIO VIDEO

LINE-1

OUT

Audio cable (not supplied)

VIDEO

AUDIO

AUDIO OUT

AUX IN

AUDIO VIDEO

LINE-1

OUT

Getting Started8

Step 3: Hookups (continued)

After you’ve connected your TV, use the following procedure to set up the

unit.

A/V hookup: Video cassette player setup

Press MENU and select

SET UP MENU.

Set AUTO ANT SEL to OFF

and press EXECUTE.

For details, see page 34.

SELECT :

SET : [ Vv]

[ EXECUTE ]

KARAOKE PROGRAM

SET UP KARAOKE

SET UP MENU

SELECT :

SET : [ Vv]

[ Bb]

AUDIO MIX ON OFF

APC ON• OFF

•

AUTO ANT SEL ON OFF

CONNECT L1 TV• OTHER

•

9Getting Started

Getting Started

When you connect both LINE-1 IN and LINE-1 OUT on the unit to the TV,

use the following procedure to set up the unit.

A/V hookup: Video cassette player setup

Press MENU and select

SET UP MENU.

Set CONNECT L1 to TV

and press EXECUTE.

For details, see page 34.

Audio/video (A/V) hookup for recording TV

programs

If your TV has audio/video (A/V) output jacks, you can record a program

showing on the TV. For details on recording, see “Recording TV programs”

on page 16.

Page 9

Use this hookup if your TV has audio/video output jacks

This unit

Audio/video cable (not supplied)

Note

• When you connect the LINE-1 IN jacks of the unit to other equipment, set

CONNECT L1 to OTHER.

OUT

VIDEO

AUDIO

AUDIO VIDEO

LINE-1

OUT

SELECT :

SET : [ Vv]

[ EXECUTE ]

KARAOKE PROGRAM

SET UP KARAOKE

SET UP MENU

SELECT :

SET : [ Vv]

[ Bb]

AUDIO MIX ON OFF

APC ON• OFF

•

AUTO ANT SEL ON OFF

CONNECT L1 TV• OTHER

•

Getting Started10

Step 3: Hookups (continued)

If you made A/V connections (page 7), skip this hookup.

AUse this hookup if you’re using:

• VHF/UHF antenna (you get channels 2–13 and channels 14 and higher)

• UHF-only antenna (you get channels 14 and higher)

• Separate VHF and UHF antennas

BUse this hookup if you’re using a VHF-only antenna (you get

channels 2–13 only)

VHF/UHF

Match the type of

connector on your

TV: A, B, or C.

Rear of TV

VHFC

UHF

VHF

Rear of TV

Match the type of

connector on your

TV: A, B, or C.

BFor connector types

B and C, no UHF

connection is

required.

UHF

VHF

If you cannot connect your antenna cable to the unit directly

If your antenna cable is a flat cable (300-ohm twin lead cable), attach an external

antenna connector (not supplied) so that you can connect the cable to the VHF/UHF

IN connector. If you have separate cables for VHF and UHF antennas, you should use

a U/V band mixer (not supplied). For details, see page 40.

This unit

VHF

UHF

This unit

Antenna hookup Pages 10 to 11

UHF

VHF/UHF

OUT

VHF/UHF

OUT

VHF/UHF

Inhaltsverzeichnis

Andere Sony Videorecorder-System Handbücher

Sony

Sony SLV-SE310G/I Bedienungsanleitung

Sony

Sony UVW-1800 Bedienungsanleitung

Sony

Sony DVCAM DSR-25 Bedienungsanleitung

Sony

Sony HDCAM-SR SRW5800 Bedienungsanleitung

Sony

Sony SLV-798HF Bedienungsanleitung

Sony

Sony SLV-KF295TK Bedienungsanleitung

Sony

Sony SLV-SE820G Bedienungsanleitung

Sony

Sony SLV-662HF Operating Instructions (SLV-662HF / 679HF / 679HF PX... Bedienungsanleitung

Sony

Sony SLV-P58EE Bedienungsanleitung

Sony

Sony SLV-420 - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-440 Bedienungsanleitung

Sony

Sony DSR-1500A Bedienungsanleitung

Sony

Sony SLV-662HF Operating Instructions (SLV-662HF / 679HF / 679HF PX... Bedienungsanleitung

Sony

Sony SLV-M20HF - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SLV-799HF - Video Cassette Recorder Bedienungsanleitung

Sony

Sony SL-HF600 Bedienungsanleitung

Sony

Sony SLV-380 Bedienungsanleitung

Sony

Sony BVW-75 Bedienungsanleitung

Sony

Sony SLV-EZ11AZ Bedienungsanleitung

Sony

Sony SVT-L400 Bedienungsanleitung

Sony

Sony VO-5630 Bedienungsanleitung

Sony

Sony DVW-A500P Bedienungsanleitung

Sony

Sony SLV-T2000 Bedienungsanleitung

Sony

Sony Walkman GV-D1000 Bedienungsanleitung

Beliebte Videorecorder-System Handbücher anderer Marken

Toshiba

Toshiba M-662 Bedienungsanleitung

JVC

JVC HR-J282EU Bedienungsanleitung

Magnavox

Magnavox VRU242AT Bedienungsanleitung

RCA

RCA VR634HF - Hi-Fi VCR Bedienungsanleitung

JVC

JVC HR-5910U Bedienungsanleitung

Panasonic

Panasonic ProLine AG-1320 Bedienungsanleitung

JVC

JVC HR-S8600EU Bedienungsanleitung

JVC

JVC HR-FS1U Bedienungsanleitung

Sharp

Sharp VC-H9888U Bedienungsanleitung

FUNAI

FUNAI LC-950 Bedienungsanleitung

Sharp

Sharp VC-S2000GM Bedienungsanleitung

Panasonic

Panasonic Omnivision PV-V4523S Bedienungsanleitung

Aiwa

Aiwa HV-E212 Bedienungsanleitung

JVC

JVC HR-J3006UM Bedienungsanleitung

GE VG4271 Bedienungsanleitung

Panasonic

Panasonic AGDTL1P - TIME LAPSE RECORDER Bedienungsanleitung

RCA

RCA VR678HF Bedienungsanleitung

Sylvania

Sylvania SRV196 Bedienungsanleitung