Sorotec Basic Line Bedienungsanleitung
SOROTEC GmbH
Withig 12
77836 Rheinmünster
Tel.: +49 (0) 7227-994255-0
Fax: +49 (0) 7227-994255-9
E-Mail: [email protected]
Web: www.sorotec.de
Basic Line
Maintenance Manual
Version 1.1.0
MPF.BL
Page 2/4
Basic Line
Maintenance Manual
www.sorotec.de V 1.1.0
Maintenance
With normal use, the portal milling machine should
be lubricated every six months, but at the latest after
twelve months. To do this, proceed as follows:
All greasing points
After lubricating, remove excess grease with a rag.
Note:
As a grease gun, we recommend the HIWIN
grease gun set from the Sorotec online shop
(item no. SM.0014).
Common multi-purpose grease is sucient for
lubricating the spindle nuts and carriages.
Guide carriages X-axis
• Drive the portal to the front stop of the X-axis.
The lubricating nipples of the carriages are now
easily accessible from the front.
• Lubricate on the left and right as shown in
Fig. 44.
• On a machine with a performance kit, repeat
the process from the rear for the rear guide
carriages.
Fig. 44: Lubricating front carriages X-axis
Spindle nut X axis
• Carry out the lubrication as shown in Fig. 45.
Note:
The lubricating nipple of the X spindle nut can
only be reached from below. You can simplify the
greasing process with a maintenance opening in
the base of the machine.
Otherwise, the portal milling machine must be
laid on its side or lifted at the rear to lubricate the
X-spindle nut.
Fig. 45: Lubricating the X-spindle nut with the machine tilted
forward
Page 3/4
Basic Line
Maintenance Manual
www.sorotec.de V 1.1.0
Guide carriages Y-axis
• Drive the Y-axis to the right stop. The grease
nipples of the upper and lower carriage are now
easily accessible from the left side.
• Lubricate the Y-axis carriages as shown in
Fig. 46.
Fig. 46: Lubricating guide carriages Y-axis
Spindle nut Y-axis
• Center the Y axis. The lubricating nipple of the
Y-spindle nut is now easily accessible through
the opening in the middle of the portal beam.
• Lubricate the Y-spindle nut as shown in Fig. 47.
Fig. 47: Lubricating the Y spindle nut
Page 4/4
Basic Line
Maintenance Manual
www.sorotec.de V 1.1.0
Guide carriage Z-axis
• Drive the Y-axis to the right stop.
• Remove the left Z-axis bracing plate. It is not
necessary to remove the reference switch
beforehand. The lubricating nipples of the guide
carriage are now easily accessible from the left
side.
• Carry out the lubrication of the lower guide
carriage as shown in Fig. 48.
• For machines with the Performance Kit, repeat
the process for the upper carriage.
Fig. 48: Lubricating guide carriages Z-axis
Spindle nut Z axis
The grease nipple on the Z-axis spindle nut is easily
accessible from behind and above.
• Lubricate the Z-spindle nut as shown in Fig. 49.
Fig. 49: Lubricating the Z-axis spindle nut
Andere Sorotec Industrieanlagen Handbücher
