SpaceLift 5200-S Series Bedienungsanleitung

Page 1 SpaceLift 5200-S Series Attic Lift Manual (9/19-R)

SpaceLift 5200-S Series Attic Lift

Operating Instructions

Step 2 Step 3

Operation: Step 1

WARNING: Before any operation of the SpaceLift 5200-S Series attic lift,

inspect the platform operating area to verify no persons, animals or objects

are within 5 feet of the platform.

To avoid injury in loading and unloading operations, make sure to use proper

lifting practices. Secure objects in the lift platform to prevent them from

shifting or falling off while the platform is in motion.

Maximum load limit is 200 pounds. Exercise caution when loading heavier

items. Avoid dropping on lift platform.

The 5200-S Series attic lift system automatically performs a variety of checks

before each operation.

SAVE THESE INSTRUCTIONS

Figure shown

operating optional

remote control unit.

Manufacured by Redco Home

SPACELIFT INSTALLATION VIDEOS

We have 7 YouTube videos to compliment the site selection, installation and operations manuals:

https://www.youtube.com/playlist?list=PL64o5GKvoOih2lYcdQkBEfJzRYz4ZOv7u

READ THIS FIRST:

NORMAL SEQUENCE OF OPERATION

With lift in the fully stowed Up position the Unit

Control will display only a Down Button. When

stowed, pressing the Up Button will do nothing.

NOTE: It is the responsibility of the operator to

insure an overloaded condition does not occur.

Pressing and holding the Down Button will start

the following sequence:

•The tray will slowly lower while the microprocessor

monitors the speed. If the tray has an overload of

more than 200 pounds the speed will become

excessive, causing an overspeed error and the

microprocessor will halt the motion. The Down

Button will FLASH Red and the Up Button will

display STEADY Red.

•When the load is less than 200 pounds the tray will

continue moving downward as long as the Down

Button is continuously pressed. The tray will con-

tinue traveling downward and accelerate to the

normal run speed. The tray will continue down until

it approaches the bottom limit where it will decel-

erate and automatically slowly settle onto the floor

(provided bottom limit is set correctly).

•With tray on the floor only the Up Button will be

illuminated green indicating only upward travel is

possible. Pressing the Down Button will do nothing.

Pressing and holding the Up Button starts the

following sequence:

•Tray will slowly lift off the floor and accelerate

while the microprocessor continuously monitors

the overload. If the load exceeds 200 pounds the

tray will stop and the UP Button will FLASH Red

while the DOWN Button displays STEADY Red.

•Provided load is 200 pounds or less, the tray will

continue going up until tray is near the top where

it will decelerate and continue slowly up to the

stow position. When stowed the Control Unit will

display one GREEN Down Button indicating only

downward motion possible.

While traveling Up or Down:

•If the tray is stopped by the operator releasing a

travel button at any point between the “stowed”

and “on floor” positions, both Control Unit Buttons

will show GREEN indicating travel is possible either

Down or Up.

•While tray is moving upward or downward the load

management system continuously monitors the

load and drive motor in order to detect an over-

load, over speed or slack Poly-Web Straps. If any

of these errors occur the Control Unit will display a

unique illumination pattern for each. See indicator

table below.

After a few seconds, arrow indicators will revert to

green indicating travel may resume.

NOTE: It is up to the operator to determine whether or

not any condition still exists that would generate another

error (i.e. an overload or slack Poly-Web Straps).

Page 2 SpaceLift 5200-S Series Attic Lift Manual (9/19-R)

INDICATOR TABLE

Normal operation (no errors)

Stowed ........................DOWN green, UP no illumination

Traveling .....................UP/DOWN no illumination

Stopped in middle ...UP/DOWN green

On floor........................UP green, DOWN no illumination

Errors

Slack .............................DOWN red flashing, UP green

Persistent Slack ..........DOWN and UP flashing red ---

........................................no movement allowed until fault

is cleared.

Overload .....................UP red flashing, DOWN red steady

Over speed ................DOWN red flashing, UP red steady

Top Safety....................DOWN red steady, UP red steady

SpaceLiftProducts.com

WARNING: Before any operation of the SpaceLift

5200-S Series attic lift system inspect the platform

operating area to verify no persons, animals or

objects are within 5 feet of the platform.

To avoid injury in loading and unloading operations,

make sure to use proper lifting practices. Secure

objects in the lift platform to prevent them from

shifting or falling off while the platform is in motion.

The 5200-S Series attic lift system automatically

performs a variety of checks before each operation.

NOTE: Maximum load limit is 200 pounds. Be

careful, especially when loading heavier items, not

to drop them on the lift platform.

STEP 1. Turn on Remote Control Unit with Key.

•Up/Down Buttons – Arrows display GREEN to

indicate directions possible (i.e. stowed lift will

only go down).

•Obstacle Detection – If lift hits obstruction,

remote will display RED. (See Indicator Table

for all possible error codes)

STEP 2. Use the Down Button to lower the cargo lift

platform to the lower level landing position.

STEP 3. Load the lift platform with items to be trans-

ported. Weight of items should be centered in tray.

Maximum load must be limited to 200 pounds per trip.

Be sure objects are secured to prevent load shifting

during lift operations.

STEP 4. Depress and hold the Up Button until the lift

cycle is complete. To halt operation, release the

button any time during the lift cycle.

STEP 5. Unload lift platform.

STEP 6. Turn Key OFF when lift operations are

complete.

NOTE: If power is lost during operation the lift will stop.

When power is restored, depress the Up Button and

return the lift to the fully stowed position. This enables

the system to maintain consistent operation.

WARNING: When using the cargo lift system

Remote Control Unit, keep the lift platform in sight

until completely stopped in either the bottom or

top position. DO NOT allow children to play under

or near the lift platform.

WARNING: The lift platform moves rapidly. Keep

path clear.

Contacting Redco Home

If your product fails during the warranty period and the

product documentation does not solve the problem,

you may receive support by:

1. Check Model 5200-S Series FAQ on the SpaceLift

website.

2. Contact the dealer from whom you purchased.

3. Use SpaceLift website Contact form for inquiry.

Before contacting your dealer or Redco Home, have

the following:

•Product serial number (found on the motor

housing label)

•Product model name and model number

•Detailed notes for questions

SpaceLift 5200-S Series Attic Lift

Operating Instructions

Step 4

Step 5

Page 3 SpaceLift 5200-S Series Attic Lift Manual (9/19-R)

Step 2 Step 3

Operation:

Step 1

Figure shown

operating optional

remote control unit.

Manufacured by Redco Home

Extent of Limited Warranty

SpaceLift Products, Inc. warrants that the cargo lift

product will be free from defects in material and

workmanship for two years. SpaceLift Products does

not warrant that the operation of the product will be

uninterrupted or error free.

This limited warranty covers only those defects that

arise as a result of normal use of the product and

does not cover any other problems, including those

that arise as a result of: (i) improper maintenance or

modification; (ii) operation outside the product’s spec-

ifications; or (iii) unauthorized modification or misuse.

If SpaceLift Products receives, during the applicable

warranty period, notice of a defect in any product,

which is covered by this warranty, SpaceLift Products

shall either repair or replace the product at its sole

discretion and option.

Limitations of Warranty

TO THE EXTENT ALLOWED BY LOCAL LAW,

NEITHER SPACELIFT PRODUCTS NOR ITS THIRD

PARTY SUPPLIERS MAKES ANY OTHER WARRANTY

OR CONDITION OF ANY KIND, WHETHER EXPRESS

OR IMPLIED WARRANTIES OR CONDITIONS OF

MERCHANTABILITY, SATISFACTORY QUALITY, AND

FITNESS FOR A PARTICULAR PURPOSE.

Limitations of Liability

To the extent allowed by local law, the remedies

provided in this Limited Warranty Statement are the

customer’s sole and exclusive remedies.

TO THE EXTENT ALLOWED BY LOCAL LAW, EXCEPT

FOR THE OBLIGATIONS SPECIFICALLY SET FORTH

IN THIS WARRANTY STATEMENT, IN NO EVENT

SHALL SPACELIFT PRODUCTS OR ITS THIRD PARTY

SUPPLIERSBELIABLEFORDIRECT,INDIRECT,SPECIAL,

INCIDENTAL OR CONSEQUENTIAL DAMAGES,

WHETHER BASED ON CONTRACT, TORT, OR ANY

OTHER LEGAL THEORY AND WHETHER ADVISED OF

THE POSSIBILITY OF SUCH DAMAGES.

Local Law

This Limited Warranty Statement gives the customer

specific legal rights. The customer may also have

other rights, which vary from state to state in the

United States, from province to province in Canada,

and from country to country elsewhere in the world.

To the extent that this Limited Warranty Statement

is inconsistent with local law, this Statement shall be

deemed modified to be consistent with such local

law. Under such local law, certain disclaimers and

limitations of this Warranty Statement may not apply

to the customer. For example, some states in the

United States, as well as some governments outside

the united States (including provinces in Canada),

may: (i) preclude the disclaimers and limitations in this

Warranty Statement from limiting the statutory rights

of a consumer (e.g., United Kingdom); (ii) otherwise

restrict the ability of a manufacturer to enforce such

disclaimers or limitations; or (iii) grant the customer

additional warranty rights, specify the duration of

implied warranties which the manufacturer cannot dis-

claim, or allow limitations on the duration of implied

warranties.

THE TERMS IN THIS WARRANTY STATEMENT,

EXCEPT TO THE EXTENT LAWFULLY PERMITTED, DO

NOT EXCLUDE, RESTRICT, OR MODIFY, AND ARE

IN ADDITION TO, THE MANDATORY STATUTORY

RIGHTS APPLICABLETO THESALE OF THESPACELIFT

PRODUCTS TO SUCH CUSTOMERS.

SpaceLiftProducts.com/Products

Protected by U.S. Patents No. 8,292,031 and

9,120,645 B2.

SpaceLiftProducts.com

Limited Warranty

SpaceLift Products Model 5200-S Series Lift System

MANUFACTURED BY

edited design

edited design vertical

515 Fan Hill Rd., Monroe, CT 06468

Andere SpaceLift Hebesystem Handbücher

SpaceLift

SpaceLift 5200 Series Bedienungsanleitung

Beliebte Hebesystem Handbücher anderer Marken

morse

morse 82H-124 Bedienungsanleitung

Braun

Braun NL955 Series Bedienungsanleitung

haacon

haacon 1889.10 Bedienungsanleitung

Protekt

Protekt AT 252 Bedienungsanleitung

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Bedienungsanleitung

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Bedienungsanleitung

Genie

Genie Z-60/34 Bedienungsanleitung

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Bedienungsanleitung

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Bedienungsanleitung

Custom Equipment

Custom Equipment Hy-Brid 3 Series Programmierhandbuch

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Programmierhandbuch

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Programmierhandbuch

BERG

BERG BeNomic EasyLeaf Bedienungsanleitung

Powermate

Powermate LiftGate LG-3 Bedienungsanleitung

Snorkel

Snorkel TM12 Series Bedienungsanleitung

Terberg

Terberg OMNIDEKA Bedienungsanleitung

Harmar Mobility

Harmar Mobility AL625 Betriebsanleitung

Rotary

Rotary SPO16 Bedienungsanleitung