Office No- 114, First Floor, Dhuri Commerce Plaza,
Vasai Station (E), Opposite Bus Depot,
Dist : PALGHAR- 401208
3.5 Data save and checking method: The data save can be used under P peak mode, and the
measured data can be discarded by directly pressing C key, and press OK key to save. After save is
completed, you will automatically return back to the measurement interface for re-testing. By such
circulation, max. data can be saved to 99 groups (data number is 001.002 099 by sequence).
Data check. Press M key to check the saved data group on the measurement interface (display 0000
under no saved data) and data number can be checked by UP/DN keys, then if no operation lasts for
2 seconds, it will display the detailed force values saved by this number. After checking, press M
key continuously until returning back to the measurement interface.
3.6 Clearing data storage values: Shortly press M key for 5 times on the measurement interface to
pop up CLR, and press C key to pop up No?, then press C key again to confirm clear, which
display DEL for completion, then returning back to the measurement interface. (If in No? Press M
key on the interface to discard and delete, then returning back to the measurement interface. Note:
Data clearing is one-time clear which completely clears all the data without single operation)
Precautions -
4.1
In order to maintain good accuracy, it is recommended to re-calibrate one time approximately
every year.
4.2
Over-torque may cause damage or loss of accuracy (more than 105% of the maximum torque
range).
4.3
Do not shake the wrench vigorously or drop the wrench to the ground.
4.4
Do not use the wrench as a hammer.
4.5
Do not place the wrench in a place with high temperature, high humidity or direct
sunlight.
4.6
Do not use the wrench near water.
4.7
If you accidentally wet the wrench, dry it with a dry towel immediately. Salt in the
sea can damage the wrench.
4.8
Do not use organic solvents to clean the wrench, such as alcohol or paint thinner.
4.9 Do not place the wrench close to the magnetic object.
4.10 Do not place the wrench in a place with a lot of dust or sand, which will cause
serious damage to the wrench.
4.11 Do not heavily press LCD screen.
Battery treatment
5.1 If you do not use the torque wrench for a long time, please take out the battery.
5.2 When you need to travel long distances or in a cold area, please prepare a spare
battery.
