GB 9
3.3 DELETING ALL TRANSMITTERS
This procedure deletes all hand transmitters which are programmed to this
control. This work should be performed by a qualified electrician or a service
technician, since the control box has to be opened.
1. Unplug the controller
2. Unscrew the lid of the control box
3. Diagonally across from the screen in the control box is a dark-gray box;
this is the radio receiver. Unscrew the cover of the receiver.
4. Insert the power plug (Caution: mains voltage in the control box, but not
in the radio receiver). See page 8.
5. Press and hold Programming Buttons C1 and C2. The LEDs will blink.
Hold the buttons until the blinking stops (about 15 seconds). All trans-
mitters have now been erased. The controller is not operational in this
mode, since no transmitter has been programmed.
3.4 INFORMATION ABOUT THE REMOTE CONTROL
Radio range:
The Magic rotation control is fitted as standard with a high-quality radio
system, which guarantees safe operation. The range is up to 50 metres, and
the radio signal also goes through walls. Visual contact with the fireplace
or the control box is not necessary. Under certain environmental conditions,
the range of the radio system might be limited.
The following factors can affect the range:
• weak transmitter batteries
• the location where the control box is installed
• building parts reinforced with steel, such as reinforced concrete ceilings
or walls
• radio activity in the area (radio and television broadcasting masts, CB
radio, mobile telephony)
5. Simultaneously press Programming Button C1 and Button A on the
remote control. The LED on Channel C1 will then light up briefly.
6. CAUTION: If C1 is released before Transmitter Button A is pressed, can-
cel the programming by briefly pressing Button C2.
7. Simultaneously press Programming Button C2 and Button B on the
remote control. The LED on Channel C2 will then light up briefly.
8. CAUTION: If C2 is released before Transmitter Button B is pressed, can-
cel the programming by briefly pressing Button C1.
3.2 DELETING SPECIFIC TRANSMITTERS
This work should be performed by a qualified electrician or a service tech-
nician, since the control box has to be opened.
1. Unplug the controller
2. Unscrew the lid of the control box
3. Diagonally across from the screen in the control box is a dark-gray box;
this is the radio receiver. Unscrew the cover of the receiver.
9. Insert the power plug (Caution: mains voltage in the control box, but not
in the radio receiver). See page 8.
1. Press and hold Programming Buttons C1 and C2. The LEDs will blink.
Now, quickly press Button A to delete the remote control. The LEDs will
then go out again. Then, release Buttons C1 and C2. The whole process
cannot take longer than 10 seconds; otherwise, if C1 and C2 are held
for too long, the radio receiver passes into the format of the memory.
2. To erase Button B from the respective transmitter, press and hold But-
tons C1 and C2 again. Then, press Button B on the transmitter and
release C1 & C2 again. The whole process cannot take longer than 10
seconds; otherwise, if C1 and C2 are held for too long, the radio receiver
passes into the format of the memory.
