Not to be distributed without prior consent of SPI Lasers UK Ltd.
Slide: 6 FS-S00149-Rev A
Customer Requirements Pre Install
29/06/2016
•Water Connections PIPA-Q Optical connector.
•The water connections to the PIPA-Q optical connector requires a separate water supply which can be achieved
by using a two channel chiller unit with independent settings for each channel.
•It is essential that the PIPA-Q optical connector is adequately cooled with a source of clean, chilled water in
accordance with the specifications in the table above . Operating the PIPA-Q optical connector without an
adequate flow of cooling water may result in catastrophic damage.
•It is the customers responsibility to provide the fittings and hose for the install of the laser, SPI recommends the
use of John Guest fittings as shown below.
•John Guest 10mm Equal Elbow PM0310E
10mm Equal Straight PM0410E
10mm Locking Clip PM1810R
10mm Plug PM0810R
10mm LLDPE Tubing (Cold Plate) PE-1007-100M-*
6mm LLDPE Tubing (PIPA-Q) PE-0604-0100M-*
10mm Equal Elbow PEM0310W
Tube Cutter TSNIP
•Essentra End Cap FCWA-0095-013
