Rain Gear Instructions
All rain gear is found in the
pocket of the travel bag. (1) Find
the black lens hood. (2) This
flexible lens hood can be folded
over onto itself and the Velcro
holds its position as shown. (3)
To begin the attachment
process, you will first loosen the
camera mount knob and (4) slide
the quick release plate from the
camera mount.
Next, (1) line the black lens hood
up with the camera’s thread,
found on the bottom of the
camera and attach the quick
release plate through one of the
lens hood’s holes as shown. Be
sure to tighten the quick release
plate screw into the camera to
secure the lens hood. (2) Fold
the lens hood around the top of
the camera, inserting the
viewfinder through the slit, and
Velcro as show. The lens hood
should cover (3) the front of the
camera lens by several inches as
shown. (4) Attach quick release
plate with camera and lens hood
back onto the camera mount.
Next, (1) Open the large Velcro
opening of the black waterproof
cover and slide it over camera
and then close the Velcro.
Position (2) the small bungee
opening around the lens hood
and tighten as shown. Close (3)
the large bungee opening. Make
sure all the cable connections
are also covered by the
waterproof cover. Finally, put
(4) the clear monitor rain cover
over the monitor and remote
plate.
