Spyder Pleasure-Way Bedienungsanleitung

TOUCHSCREEN CONTROL PANEL

OPERATION MANUAL

G GETTING STARTED

12 VOLT BATTERY DISCONNECT SWITCH

To operate the touchscreen control panels, the 12 VOLT

BATTERY DISCONNECT switch must be in the ON position.

(This applies to the front and rear touchscreen control panels)

Touch anywhere on the touchscreen for the display to light up.

DISPLAY SCREEN MENU OPTIONS

The menu options are located off to the right of the

touchscreen control panel. There are five menu pages:

HOME, LIGHTING, POWER MANAGEMENT, MECHANICAL

AND SETTINGS.

Touch a menu icon to display the screen you want to access.

iGETTING STARTED

i12 Volt Battery Disconnect Switch

i Display Screen Menu Options

1HOME PAGE

1 Lighting Quick Access

2 Climate Control Center

3Water Pump

3Tank Level Panel

3 Water Heater

4DC Power

4 AC Power Display

4 Generator

5LIGHTING PAGE

5 Getting Started

6 Home Page Lighting Quick Access

7POWER MANAGEMENT PAGE

7 DC Power

8 AC Power

9 The EMS (Energy Management System)

9 Solar Charger

10 Solar Charger Settings

11 Generator

11 AGS Easy Setup

13 AGS Manual Setup

15 MECHANICAL PAGE

15 Power Sofa

16 Awning

16 Fan-Tastic Vent Fan

17 SETTINGS PAGE

18 Screen Settings

19 Diagnostics

TABLE OF

CONTENTS

HOME PAGE MECHANICAL PAGE

(Sofa, Awning, Fantastic Fan)

SETTINGS PAGE

(Module Status, G12 Status,

DCM3, Faults)

LIGHTING PAGE

POWER

MANAGEMENT PAGE

LIGHTING QUICK ACCESS

This area provides a short cut to your 3 most used lights.

(See LIGHTING PAGE 6) for customization.

The configuration shown here will allow you to turn

ON or OFF lighting for the KITCHEN, SOFA VALANCE,

READING and the BACK LIGHT.

Buttons with up/down arrows are capable of dimming.

Touch and hold the light button for brightening and

dimming of the lighting.

Select the LIGHTING PAGE button for a complete list of

lighting options.

HOME PAGE

To access the HOME page, select the icon from the menu off to the right of the touchscreen control panel.

Buttons will display in light blue when activated.

The HOME page will display the following: LIGHTING, CLIMATE CONTROL, WATER PUMP, WATER HEATER, TANK LEVELS, DC

POWER, GENERATOR START/STOP and AC SOURCE.

CLIMATE CONTROL CENTER

The CLIMATE CONTROL CENTER displays the inside

temperature and the desired temperature in the center circle.

The actual inside temperature of the coach is displayed

in the smaller number below the set temperature. The set

temperature is the large number selected by touching the

white dot and moving it around the temperature scale to the

desired temperature.

Use the MODE buttons on the left to select the desired item

that you want to operate. You can select: FURNACE, AIR

CONDITIONER, VENT FAN or FAN SPEED to the right. These

devices are thermostatically controlled.

NOTE: Fahrenheit or Celsius can be selected on the

Settings page.

FURNACE MODE (TRUMA VARIOHEAT)

If the desired temperature is above the interior temperature

the furnace will engage and warm the coach to the desired

temperature. At the desired temperature the furnace

will cycle off. If the temperature drops below the desired

temperature the furnace will cycle back on. Ensure that the

propane switch on the exterior of the coach is in the ON

position.

NOTE: Ensure that the fan speed on the right side is set to FAN

AUTO. If there is 110 volt available and the fan is left on HIGH or

LOW, the fan in the AC will engage during the furnace mode.

VENT MODE

If the desired temperature is below the interior temperature,

the roof vent fan will open and the fan will engage. The fan

will run at high speed until the interior temperature reaches

the desired temperature. When the interior temperature

reaches the desired temperature the fan will shut off,

however the vent lid will remain open. The fan will cycle off

and on to keep the desired temperature.

A/C MODE

120 volt power from a shore line or from the generator must

be present to activate the air conditioner. In the A/C mode

if the desired temperature is below the interior temperature

the roof top A/C will engage to cool the interior of the coach.

The FAN HIGH, FAN LOW and FAN AUTO are used to control

the air conditioner fan speed. If the FAN HIGH or FAN LOW is

chosen the air conditioner fan will continue to run while the

air conditioner compressor will cycle on and off.

If FAN AUTO is chosen the air conditioner fan will cycle

on and off a short time before, and a short time after the

air conditioner compressor engages, to keep the desired

temperature.

NOTE: The FAN HIGH, FAN LOW and FAN AUTO are used to

control the air conditioner fan speed only. These controls will

not affect the roof vent or the furnace fan speeds.

WATER PUMP

Select the WATER PUMP button to run the on-board water

pump.

Ensure there is water in the fresh water holding tank before

engaging the water pump. The water pump should not be

turned on when the motorhome is connected to city water.

It’s recommended that you turn off the water pump when

the water system is not in use or when you are going to be

away from your motorhome.

TANK LEVEL PANEL

The FRESH, GREY and BLACK tank levels. The fresh and grey

water tanks are located underneath the floor of the vehicle. The

black water tank is located above the floor directly under the

toilet.

The LPG indicates how full the LP tank is. The LP gauge is

located on the tank with a sending unit that sends levels to the

touchscreen control panels.

WATER HEATER

Please refer to the manufacturer’s operating instructions for

further information.

Select the WATER HEATER symbol to adjust.

Set water temperature using the - or + symbols. Press OK to

return to HOME PAGE.

The water heater setting will be displayed at the top right of the

HOME PAGE.

DC POWER (COACH BATTERIES)

This gauge displays the STATE-OF-CHARGE, BATTERY

VO LTAG E , BATTERY TEMPERATURE, and REAL TIME LOSS/

GAIN AMPERAGE.

(for more information see page 7)

AC POWER DISPLAY (120 VOLT POWER)

When operating your coach on AC power, the current power

source you are using will light up and be displayed on the

Home Page.

GENERATOR

This gauge displays the START/STOP SWITCH, GENERATOR

STATUS and AUTO GENERATOR START STATUS.

These buttons will start and stop your generator. Touch and

hold the button to start the generator. There will be a slight

delay before the starter engages.

To access the LIGHTING PAGE, select the icon from the menu off to the right side of the touchscreen control panel.

NOTE: LIGHTING PAGES will vary depending on the model.

GETTING STARTED

Select a light button to turn ON or OFF lighting associated with the area. Buttons will display in light blue when activated.

The LIGHT MASTER button turns ON or OFF all the lights inside the vehicle. The LIGHT MASTER button does not control AWNING

LIGHT or the PORCH LIGHT.

Buttons with a sliding bar are capable of dimming.

To turn OFF the screen display, select the BACK LIGHT button on the HOME page. To turn the screen display back ON, touch

anywhere on the screen.

WARNING: Ensure the awning light is off when the awning is retracted in the stow position.

LIGHTING PAGE

HOME PAGE LIGHTING QUICK ACCESS

The QUICK ACCESS LIGHTING buttons on the HOME page

can be customized to show any 3 lights, by following

these instructions:

1. Select the SETTINGS icon on the touchscreen control

panel.

2. Select the SCREEN SETTINGS button. This will bring up

the DEFAULT BUTTONS section.

3. Use the + and – buttons to adjust lighting options.

NOTE: BACK LIGHT is a required for the quick access panel

and cannot be changed.

POWER MANAGEMENT PAGE

The POWER MANAGEMENT PAGE will assist you in managing your power consumption. This

especially helpful when you are dry camping.

DC POWER

BATTERY PANEL

Indicates the state-of-charge of the batteries, battery voltage and the temperature of the

batteries. The temperature gauge measures the current temperature inside the coach battery

box and will help you determine if it’s safe to charge your batteries.

Battery voltage will vary depending on the load. The battery voltage will change depending on

the amount of charge the battery is receiving from the solar panel, engine alternator, or the

inverter/charger.

NOTE: The temperature of the batteries is important, do not charge the batteries if the

temperature is below 32 degrees Fahrenheit or 0 degrees Celsius.

To access the POWER MANAGEMENT PAGE, select the icon from the menu off to the right side of the touchscreen control panel.

LOSS/GAIN AMPERAGE METER

The LOSS/GAIN AMPERAGE METER gives a real time level of

DC amperage used in the motorhome. A positive number will

indicate that more amperage is going into the battery bank

than is being used. A negative number means the battery

bank is being drawn down.

ESTIMATION GAUGE

The ESTIMATION GAUGE gives an estimate of time remaining

for the DC power that can be drawn from the battery bank.

The average rating takes into consideration consumption over

a short period of time.

The ESTIMATION GAUGE also estimates the charging time

when plugged into shore power, on generator power, solar

charging or when the vehicle is running and the batteries are

being charged.

AC POWER

The AC POWER display will show the source of AC power

(GENERATOR, INVERTER or SHORE), the VO LTA G E of AC

power and the FREQUENCY of AC power. It will also indicate

the AMPERAGE draw of the 120 VAC appliances.

Andere Handbücher für Pleasure-Way

Inhaltsverzeichnis

Andere Spyder Touch-Screen Handbücher

Spyder

Spyder Pleasure-Way Bedienungsanleitung

Beliebte Touch-Screen Handbücher anderer Marken

Elecro Engineering

Elecro Engineering Poolsmart Plus Montageanleitung

Johnson Controls

Johnson Controls IQ4 HUB Bedienungsanleitung

Elo TouchSystems

Elo TouchSystems ET2270L Bedienungsanleitung

Elo TouchSystems

Elo TouchSystems ET1002L Bedienungsanleitung

Elo TouchSystems

Elo TouchSystems 3201L Bedienungsanleitung

Duratec

Duratec S15 Bedienungsanleitung

Crestron

Crestron TPMC-3SM Bedienungsanleitung

Racelogic

Racelogic MFD Touch Bedienungsanleitung

J2 580 Benutzerhandbuch

HAI

HAI OmniTouch 10p Bedienungsanleitung

panel

panel PC PSR108-FM Series Bedienungsanleitung

Tipro

Tipro FREE+ Bedienungsanleitung

Systemline

Systemline Commander Bedienungsanleitung

Interactive Technologies

Interactive Technologies Insite Bedienungsanleitung

GVision

GVision Legacy Bedienungsanleitung

BeiJer

BeiJer T21C-C24 Bedienungsanleitung

Advantech

Advantech ITM-5117 Series Bedienungsanleitung

Edge

Edge CS Bedienungsanleitung