Squareled CW/WW Bedienungsanleitung

User Manual: Squareled CW/WW 220W Led Video Softlight

IP20

SQUARELED

CW/WW 220W LED Video Softlight

User Manual

SAFETY INSTRUCTIONS

CAUTION

Be careful with your operations.With a dangerous voltage you can suffer

a dangerous electric shock when touching wires!

This device has left the factory in perfect condition. In order to maintain this condition and

to ensure a safe operation, it is absolutely necessary for the user to follow the safety

instructions and warning notes written in this user manual.

If the device has been exposed to temperature changes due to environmental changes, do

not switch it on immediately. The arising condensation could damage the device.

Leave the device switched off until it has reached room temperature.

This device falls under protection-class I. Therefore it is essential that the device be

earthed.

The electric connection must carry out by qualified person. The device shall only be used

with rate voltage and frequency.

Make sure that the available voltage is not higher than stated at the end of this manual.

Make sure the power cord is never crimped or damaged by sharp edges. If this would be

the case, replacement of the cable must be done by an authorized dealer.

Always disconnect from the mains, when the device is not in use or before cleaning it. Only

handle the power cord by the plug. Never pull out the plug by tugging the power cord.

During initial start-up some smoke or smell may arise. This is a normal process and does

not necessarily mean that the device is defective, it should decrease gradually.

Please don't project the beam onto combustible substances.

Fixtures cannot be installed on combustible substances, keep more than 50cm distance

with wall for smooth air flow, so there should be no shelter for fans and ventilation for heat

radiation.

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively

replaced by the manufacturer or his service agent or a similar qualified person in order to

avoid a hazard.

IMPORTANT

Damages caused by the disregard of this user manual are not subject to

warranty. The dealer will not accept liability for any resulting defects or

problems.

Unpacking

Thank you for choosing our 220W LED Video Panel Light. For your own safety, please read this

manual before installing the device. This manual covers the important information on installation

and applications. Please install and operate the fixture with following instructions. Meanwhile,

please keep this manual well for future needs.

The 220W LED Video Panel Light is made of a new type of high temperature strength of cast

aluminum casing with nice outlook. The fixture is designed and manufactured strictly following CE

standards, complying with international standard DMX512 protocol. It's available independently

controlled and linkable with each other for operation. And it is applicable for large-scale live

performances, theater, studio, nightclubs and discos.

Please carefully unpack it when you receive the fixture and check whether it is damaged during

the transportation. And please check whether the following items are included inside the box:

① 220W PANEL 1PC

②Signal Cable 1PC

③Power Cable 1PC

④User Manual 1PC

③

FEATURES & SPECIFICATIONS

Features

•1920PCS premium quality and high CRI LED (Cool White+Warm White)

•Accurate color temperatures tunable from 3000K to 6000K

•50,000 hours life span and low power consumption

•Color Rendering Index(CRI): Ra≥95

•Flat and even projection with soft edge

•High intensity, long throw and 180° wide field angle

•Housing made by rugged, die cast aluminum alloy

•Thermally insulated knobs and single aluminum handle for installing

•Barn door included

•Tripod stand as optional

•Superior free noise thermal cooling system

•0-100% Smooth and precise linear dimmer

•2 Individual dimmer knows to adjust color temperatures

•No noticeable color shift throughout the entire range

•Flicker-free at any frame rate or shutter angle

•25T/sec high speed shutter/strobe effect with variable speed

•Preset variable/random strobe and dimming pulse effect

•2DMX channels USITT DMX-512

•DMX, Auto run and Master/Slave

•LCD with touch screen

•3-Pin connectors IN/OUT

•-30-40°C Max ambient temperature

•IP20 protection rating

Specifications

D8.6*9.17cm

P14.5cm(1pc/carton)

Net Weight: 9.5kg

PRODUCT STRUCTURE:：

DMX-512 CONTROL CONNECTIONS

Connect the provided XLR cable to the female 3-pin XLR output of your controller and the

other side to the male 3-pin XLR input of the moving head. You can chain multiple

Moving head together through serial linking. The cable needed should be two core,

screened cable with XLR input and output connectors. Please refer to the diagram below.

DMX-512 connection with DMX terminator

For installations where the DMX cable has to run a long distance or is in an electrically

noisy environment, such as in a discotheque, it is recommended to use a DMX

terminator. This helps in preventing corruption of the digital control signal by electrical

noise. The DMX terminator is simply an XLR plug with a 120 Ω resistor connected

between pins 2 and 3,which is then plugged into the output XLR socket of the last fixture

in the chain. Please see illustrations below.

1 2

2 1

DMX OUT

3-Pin XLR Socket

DMX IN

3-Pin XLR Socket

1:Ground

2:Data(-)

3:Data

(

)

DMX+

DMX-

COMMON

DMX512 OUT

3-Pin XLR

DMX512 OUT

3-Pin XLR

DMX IN DMX OUT POWER IN

MENU OPERATIONS

1. Main Menu

1.1. Main Menu

1.2. Operation Status

Mode Display Description

DMX Mode Dxxx “D”stand for DMX mode

Temperature

Mode

M-WP “M”stand for stand Master, “WP”stand for“White

Point”

120 Ω

PIN3

PIN2

Reverse Display

Running Status

Vice Menu Button

2. DMX Menu & Channel data

3. DMX menu

Enter DMX mode:

1. If you are in DMX mode,the main menu will turn into DMX menu automatically after 5

seconds

2. Menu of DMX address (DMX mode) will turn into DMX menu automatically after 5

seconds

Quit DMX mode

1. Screw mode: Press knob 2.

2. Touch mode: Touch any area out of “DMX”in DMX menu (press “DMX”is enter

the menu for setting DMX address)

DMX Menu Operation:

1. DMX mode: When the DMX 512 signal is connected correctly and the data of channel

1 which is bigger than 0, use the received DMX data value for dimmer and temperature

control (See the channel data sheet). This moment knob 1 and knob 2 can not be used in

dimmer; knob 1 only use for menu operation. For example, Changing the DMX address:

press knob 1 to enter or exit the editing status. (Turn left or right for changing the dmx

address)

2. Screw mode: When disconnect DMX signal or the channel 1 data is 0, can use knob 1

for the dimmer, knob 2 for color temperature.

4.Vice Menu

nutateperation ity Dimmer（0~100%） Press knob 1 to enter or exit the editing of address

data. (Turn left or right for changing the data)

White Point Color temperature（3000~6000K）

enutateptionark creen Calibration Touch Screen

Calibration

Dimmer Frequency Choose the

dimmer frequency

500HZ

…… Increase or decrease

with data of 100HZ

25000HZ

Dimmer Curve Choose the

dimmer curve

Standard

Incandescent

Linear

Quick

Over Temperature Set the protect

temperature

45~95 Increase or decrease

with data of 5

Backlight Adjust the

Backlight

brightness

10%~100% Increase or decrease

with data of 5%

Backlight Timeout Set the screen

protect time

screen protect or screen

protect after 5~60 seconds

Increase or decrease

with data of 5

Load Factory Settings Reset

Inhaltsverzeichnis

Andere Squareled Beleuchtungsausrüstung Handbücher

Squareled

Squareled Typhoon 600W dual white IP65 Bedienungsanleitung

Squareled

Squareled NPQ818 Bedienungsanleitung

Squareled

Squareled Sputnik MK2 Bedienungsanleitung

Squareled

Squareled Fidelio Bedienungsanleitung

Squareled

Squareled Storm1000 Bedienungsanleitung

Squareled

Squareled Hi-Precision 200W RGBW Bedienungsanleitung

Squareled

Squareled Element 19X40W Washlight Bedienungsanleitung

Squareled

Squareled Edison's Sunstrip 10x50W White Amber 3000K Bedienungsanleitung

Squareled

Squareled Mr. Beam Bedienungsanleitung

Squareled

Squareled Modular Series Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung