StarTech.com 8STSATDUP11 Bedienungsanleitung
Manual Revision: 07/06/2018
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
SATDUP11
1 to 1 Standalone Hard Drive Duplicator
and Eraser
*actual product may vary from photos
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Instruction Manual
i
Table of Contents
Product Diagram ....................................................................................1
Front View .................................................................................................................................................... 1
Rear View...................................................................................................................................................... 1
Introduction............................................................................................2
Packaging Contents ................................................................................................................................. 2
Hardware Setup......................................................................................................................................... 3
User Menu Table of Contents................................................................................................................ 4
Hardware Operation..............................................................................5
1. Copy .......................................................................................................................................................... 5
2. Compare .................................................................................................................................................. 6
3. Copy & Compare ................................................................................................................................... 6
4. Erase .......................................................................................................................................................... 6
5. Utility......................................................................................................................................................... 8
6. Setup......................................................................................................................................................... 13
Technical Support ..................................................................................17
Warranty Information............................................................................17
Instruction Manual
1
Product Diagram
Front View
Rear View
1. Display Screen
2. Navigation buttons
3. OK button
4. Esc button
5. SATA HDD source port
6. SATA HDD Target port
1. Power Switch
2. Power Adapter Port
2
4
5
1
2
1
3
6
Instruction Manual
2
Introduction
Packaging Contents
• 1X – HDD Duplicator/Eraser
• 2X – SATA Cables
• 1X – Power Adapter
• 3X – Power Cords (NA, UK, EU)
• 1X – Instruction Manual
• 2X- HDD Pads
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a
large grounded metal surface (such as the computer case) for several seconds.
Instruction Manual
3
Hardware Setup
1. Ensure the power switch is set in the o position. Connect the included power
adapter from an available AC power outlet to the Power Adapter Port on the back of
the SATDUP11.
2. Using an included SATA Cable, attach the HDD you would like to duplicate to the
source port. (SATA port on the left identied as source, see below).
3. Using an included SATA Cable, connect the HDD you would like to have over
written, or erased to the target port. (SATA port on the right identied as source, see
below)
Note: For added protection, and heat insolation the source and target drives can be
placed on included HDD Pads.
WARNING! Any Data remaining on the target drive will be over written.
4. Press the power switch to the “On”position, the SATDUP11 is now ready to use.
Instruction Manual
4
User Menu Table of Contents
1. Copy
2. Compare
3. Copy and Compare
4. Erase 4.1 Quick Erase
4.2 Full Erase
4.3 DoD Erase
4.4 Dod Erase Comp
5.Utility 5.1 Show HDD
Info
5.1.1 Model Number
5.1.2 Version of Firmware
5.1.3 Serial Number
5.1.4 Device Power Cycle
5.1.5 Power-On Hours
5.1.6 Reallocation Event Count
5.1.7 O-Line Scan Uncorrectable
5.1.8 Seek Error Rate
5.1.9 Temperature
5.2 Update
System
5.2.1 Update BIOS
5.2.2 Create Update HDD
5.3 System Info 5.4 Read Speed
5.5 Write Speed
6. Setup 6.1 Copy Area 6.1.1 System and Files
6.1.2 ALL Partitions
6.1.3 Whole HDD
6.1.4 Percentage
6.2 Skip Error
6.3 Language
6.4 Advanced
Setup
6.4.1 Unknown Format
6.4.2 Erase Master
6.4.3 Erase Pattern
6.4.4 Wait HDD Time
6.4.5 Transfer Rate
6.4.6 Stop Motor Time
6.5 Restore Defaults
Instruction Manual
5
Hardware Operation
1. Copy
Copy Process
Copy Result
Copy
Pass
Copied Time
Copied Progress %
Copied Data Capacity
Total Data Capacity
No Bad Sector!
2047M
0:58
0:26 50% 1037M
The copy function copies data from the source HDD to the target HDD. Please ensure
you have selected your desired copy mode before executing the copying process.
Refer to function [6.1 Copy Area] for details.
Note: By Default quick copy mode “System and Files” is selected.
Note: The Default setting is the quick copy mode“System and Files”.
Instruction Manual
6
2. Compare
3. Copy & Compare
4. Erase
The Compare function can be used after a duplication s nished to conrm the data on
the target HDD is identical to the source HDD.
The Copy & Compare function executes a duplication and then automatically executes
the compare function immediately afterwards.
4.1 Quick Erase
The Quick Erase function only erases the HDD index table. It is the fastest way to erase
a HDD.
4.2 Full Erase
The full Erase function performs a single pass overwrite which will erase all sectors on
the HDD. It will take a longer time than quick erase.
WARNING! Any Data remaining data on any drive connected to a designated erase
port will be over written. Please back up all data before performing any Erase function.
The Erase function allows for three dierent types of drive erasing: Quick Erase, Full
Erase, and DoD Erase. Select your desired mode to clear all data from the drive. Refer to
functions [4.1 / 4.2 / 4.3] for details.
Notes:
• You can also use the source port and delete two drives simultaneously. Refer to
function [6.3 Erase Master] for details. By default the Source port is disabled as
an erase port.
• The Erase function can be stopped while in process by pressing the [ESC] for 3
to 4 seconds. However, any data that has already been deleted including the
drive partition table cannot be recovered.
Instruction Manual
7
4.3 DoD Erase
DoD Erase is a three pass overwrite erase which erases all sectors of the HDD. It can
guarantee the data was fully deleted by erasing the HDD bit for bit three times. DoD
Erase will damage the data on the HDD, so please make sure you have backed up all
important data before using this function.
The system will start executing DoD Erase after pressing [OK].
Erasing.
The system will show the result afternishing.
Steps of DoD Erase
DoD Erase
Fail: 0Pass: 5
DoD Erase
Prepare Pattern
DoD Erase
Erase[00]
2:05
4818M
Erasing 1 HDD
[02] 465G
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere StarTech.com Disc-Duplikator Handbücher
StarTech.com
StarTech.com USBDUP12 Bedienungsanleitung
StarTech.com
StarTech.com UNIDUPDOCK Bedienungsanleitung
StarTech.com
StarTech.com SU2DUPERA11 Bedienungsanleitung
StarTech.com
StarTech.com USBDUPE115 Bedienungsanleitung
StarTech.com
StarTech.com SDOCK2U313R Bedienungsanleitung
StarTech.com
StarTech.com SATDUP13 Bedienungsanleitung
StarTech.com
StarTech.com SATDUPUE Bedienungsanleitung
StarTech.com
StarTech.com SATDOCK2REU3 Bedienungsanleitung
StarTech.com
StarTech.com SATDOCK2REU3 Bedienungsanleitung
StarTech.com
StarTech.com SATDUP11IMG Bedienungsanleitung
StarTech.com
StarTech.com SATDUP11 Bedienungsanleitung
StarTech.com
StarTech.com 8STUSBDUP15 Bedienungsanleitung
StarTech.com
StarTech.com SATDUP11 Bedienungsanleitung
StarTech.com
StarTech.com SM2DUPE11 Bedienungsanleitung
StarTech.com
StarTech.com SATDOCK5U3ER Bedienungsanleitung
StarTech.com
StarTech.com SATDUP11IMG Bedienungsanleitung
Beliebte Disc-Duplikator Handbücher anderer Marken
Logicube
Logicube EchoPlus-NG Bedienungsanleitung
Silca
Silca Delta 2000 SA Bedienungsanleitung
Reflex7
Reflex7 Daisy Chain Series Bedienungsanleitung
Vinpower Digital
Vinpower Digital SharkCopier DC Bedienungsanleitung
Codonics
Codonics Virtua E Bedienungsanleitung
Octave
Octave Copy Master II Bedienungsanleitung
Kanguru
Kanguru U2-DVDDUPE-S Bedienungsanleitung
DUPLO SEIKO CORPORATION
DUPLO SEIKO CORPORATION Duprinter DP-460 Bedienungsanleitung
Addonics Technologies
Addonics Technologies UDFH7 Bedienungsanleitung
Vinpower Digital
Vinpower Digital MiniLoader VDX-1 Bedienungsanleitung
Addonics Technologies
Addonics Technologies CFASTD5 Bedienungsanleitung
MicroBoards Technology
MicroBoards Technology Quic Disc QD-2 Bedienungsanleitung