StarTech.com 110VDSLEXTGB Bedienungsanleitung

VDSL Ethernet LAN Extender

10/100 VDSL Ethernet

LAN Extender Kit over Single

Pair Wire

110VDSLEXT

110VDSLEXTGB

110VDSLEXTEU

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-

sonable protection against harmful interference in a residential installation. This equip-

ment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio com-

munications. However, there is no guarantee that interference will not occur in a particu-

lar installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.•

Increase the separation between the equipment and receiver.•

Connect the equipment into an outlet on a circuit different from that to which the receiver•

is connected.

Consult the dealer or an experienced radio/TV technician for help.•

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and

do not represent an endorsement of a product or service by StarTech.com, or an en-

dorsement of the product(s) to which this manual applies by the third-party company in

question. Regardless of any direct acknowledgement elsewhere in the body of this doc-

ument, StarTech.com hereby acknowledges that all trademarks, registered trademarks,

service marks, and other protected names and/or symbols contained in this manual and

related documents are the property of their respective holders.

Table of Contents

Introduction .................................................................... 1

Package Contents .......................................................................1

Installation....................................................................... 1

Hardware Installation...................................................................1

Operation......................................................................... 2

LED Displays ...............................................................................2

DIP Switch Settings.....................................................................2

Connector Architecture ...............................................................5

Speciﬁcations.................................................................. 6

Technical Support........................................................... 7

Warranty Information...................................................... 7

Introduction

Package Contents

2 x 110VDSLEXT/GB/EU units•

2 x RJ-45 to VDSL Cable•

2 x Power Adapter•

1 x Instruction Manual•

Installation

Hardware Installation

Install one of the 110VDSLEXT / GB / EU units with all four of the1.

DIP switches set to the upward (OFF) position. This places the unit

in CO mode.

Install the second 110VDSLEXT / GB / EU unit with DIP switches 22.

through 4 set to the upward (OFF) position and DIP switch 1 set to

the downward position (ON). This places the unit in CPE mode.

Plug the DC power adapter into the port on the rear panel of the3.

units, and then into an available AC outlet.

Plug in an RJ45 Ethernet cable to the RJ45 port on the4.

110VDSLEXT / GB / EU units. Connect the other end of the cables

to your Ethernet devices.

Plug a phone cable into the VDSL port of the 110VDSLEXT/GB/EU.5.

Connect the other end of the cable into the opposing 110VDSLEXT/

GB/EU unit.

Optional:6. Conﬁgure DIP switches 2 through 4 as necessary (see

DIP Switch Settings section). Leave DIP switch 1 alone, as one unit

should always be set to CO mode while the other is CPE mode.

Operation

LED Displays

LAN LED Display

VDSL LED Display

DIP Switch Settings

The 110VDSLEXT / GB / EU has a 4-position DIP switch for

conﬁguration of Side, Channel, Rate Limit, and SNR.

Pin 1 - CO, CPE Switch

OFF:If Pin 1 is in the OFF position, the

110VDSLEXT / GB / EU will operate in

Central Ofﬁce (CO) mode.

ON: If Pin 1 is in the ON position, the

110VDSLEXT / GB / EU will operate in

Customer Premise Equipment (CPE)

mode.

LED Blinking ON OFF

1Activity Device

Power On

Device Power Off

2-CPE Mode CO Mode

3Slowly: Idle

Quickly: Training Linked Ofﬂine

LED Blinking ON OFF

1Activity Link up Link down

2100 Mbps 10 Mbps

3Full duplex Half duplex

Pin 2 - Interleave Noise Protection

OFF:If Pin 2 is in the OFF position, the 110VDSLEXT / GB / EU will

operate in Interleave mode, with communication protection for up to

250ms of impulse noise with latency less than 6 ms

ON:If Pin 2 is in the ON position, the 110VDSLEXT / GB / EU will

operate in Fast mode, with direct data transmissions having less than

1ms of latency.

Pin 3 - Band Plan

OFF:If Pin 3 is in the OFF position, the 110VDSLEXT / GB / EU will

operate in Symmetric mode, with both downstream and upstream

transmissions operating on the G.997 band plan.

ON:If Pin 3 is in the ON position, the 110VDSLEXT / GB / EU

will operate in Asymmetric mode, with asymmetric short range

transmissions operating at the highest available line rate.

Pin 4 - General Protection

OFF:If Pin 4 is in the OFF position, the 110VDSLEXT / GB / EU will

operate with a SNR ratio up to 9 dB.

ON:If Pin 4 is in the ON position, the 110VDSLEXT / GB / EU will

operate with a SNR ratio of 6 dB.

Connector Architecture

Ethernet Port

VDSL Port

Pin Number Assignment (MDI-X)

1RX+; Receive data +

2RX-; Receive data -

3TX+; Transmit data +

4Not used

5Not used

6TX-; Transmit Data -

7Not used

8Not used

Pin Number Assignment (MDI-X)

1Not used

2Not used

3Not used

4ANALOG Input/Output

5ANALOG Input/Output

6Not used

7Not used

8Not used

Specications

110VDSLEXT

110VDSLEXTGB

110VDSLEXTEU

LAN Interface

RJ-45 connector•

Complies with IEEE•

802.3/802.3u/802.3x

10/100 Base-T Auto-•

Negotiation, Auto-MDI/MDI-X

VDSL Interface

RJ-45 connector•

DMT Encoding•

Complies with ITU-T•

G993.1/993.2

On-board surge protection•

DIP Switch 4 position

LED

LAN: ACT/LNK, 10/100 Mbps,•

Half/Full Duplex

VDSL: Power On/Off, CO/CPE,•

Idle/Trained/Link

Power Supply 12VDC, 1A output, 3.5mm jack

Power Consumption 4.2 Watt maximum

Dimensions 95.5 mm x 72.0 mm x 22.0 mm

Technical Support

StarTech.com’s lifetime technical support is an integral part of our com-

mit-ment to provide industry-leading solutions. If you ever need help

with your product, visit www.startech.com/support and access our com-

prehensive selection of online tools, documentation, and downloads.

Warranty Information

This product is backed by a one year warranty.

In addition, StarTech.com warrants its products against defects in

materials and workmanship for the periods noted, following the initial

date of purchase. During this period, the products may be returned for

repair, or replacement with equivalent products at our discretion. The

warranty covers parts and labor costs only. StarTech.com does not war-

rant its products from defects or damages arising from misuse, abuse,

alteration, or normal wear and tear.

Limitation of Liability

In no event shall the liability of StarTech.com Ltd. and StarTech.com

USA LLP (or their ofﬁcers, directors, employees or agents) for any dam-

ages (whether direct or indirect, special, punitive, incidental, consequen-

tial, or otherwise), loss of proﬁts, loss of business, or any pecuniary loss,

arising out of or related to the use of the product exceed the actual price

paid for the product. Some states do not allow the exclusion or limitation

of incidental or consequential damages. If such laws apply, the limita-

tions or exclusions contained in this statement may not apply to you.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere StarTech.com Extender Handbücher

StarTech.com

StarTech.com ST124UTPE Handbuch

StarTech.com

StarTech.com ST12MHDDC Bedienungsanleitung

StarTech.com

StarTech.com ST121R Bedienungsanleitung

StarTech.com

StarTech.com 110VDSLEXT2 Bedienungsanleitung

StarTech.com

StarTech.com ST121UTP232 Bedienungsanleitung

StarTech.com

StarTech.com USBthere USB100EXT Bedienungsanleitung

StarTech.com

StarTech.com SV565UTPUL Bedienungsanleitung

StarTech.com

StarTech.com ST121HDBTE Bedienungsanleitung

StarTech.com

StarTech.com SV565UTP Bedienungsanleitung

StarTech.com

StarTech.com ST12MHDLAN4K Bedienungsanleitung

StarTech.com

StarTech.com SV565UTPUL Bedienungsanleitung

StarTech.com

StarTech.com ST124UTPEA Bedienungsanleitung

StarTech.com

StarTech.com ST124HDBT Bedienungsanleitung

StarTech.com

StarTech.com USB2001EXT2P Bedienungsanleitung

StarTech.com

StarTech.com USB2004EXTV Bedienungsanleitung

StarTech.com

StarTech.com 8STST12MHDLAN Bedienungsanleitung

StarTech.com

StarTech.com USB2004EXTGB Bedienungsanleitung

StarTech.com

StarTech.com USBthere USB201EXT Bedienungsanleitung

StarTech.com

StarTech.com ST121HD20FXA Bedienungsanleitung

StarTech.com

StarTech.com USB110EXT2 Bedienungsanleitung

StarTech.com

StarTech.com 0065030863223 Bedienungsanleitung

StarTech.com

StarTech.com ST121USBHD Bedienungsanleitung

StarTech.com

StarTech.com UTPE Series Bedienungsanleitung

StarTech.com

StarTech.com ST121WHDS Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Enable-IT

Enable-IT 824WP Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Marmitek

Marmitek MegaView70 Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung