Steamfast SF-450 Bedienungsanleitung

team

Fast

Built

for years

care

free use,

Read These Ins

tructions complete

before

use.

MODEL

450

Steam.

Model SF

450

Fast

Professional Style Steamer

Thank you for purchasing the Ste

amFast Professional Style

steamer.

If tap water is being used, in order to prolong the life of your

steamer, we recommend that the unit be drained after each

use. This will reduce lime buildup within the unit.Ifused in

hard water area the use of distilled water is encouraged.

If you chose to use distilled water it will not be necessary to

drain the unit.

Your SteamFast steamer is equipped with a thermostat

control that will shut the steamer off when the temperature

reaches 250°F. The steamer will automatically begin heating

again whenthetemperature drops below

250°

Should the water tank run dry while the unit is in operation,

we recommended that it be turned off immediately. If the

steamer is not turned off immediately, the thermostat will

cause the unit to shut off, however, damage may occur to

the unit.

In the event that the steamer is left in operation without water

or the thermostat should fail to operate properly, the unit's

fuse will burn out at

302°

F causing the steamer to shut off.

Top Innovations, Inc.

400

Platte Valley Dr.,

Riverside

, MO 64150

web site: www.topinnovations.com

Dear Consumer

INTRODUCTION

Congratulations! You are about to use the simplest and most

Versatile steamer brought to you, SteamFast, a trusted name

in clothing care.

Your new steamer provides clean, professional results every

time!

Holds over

1/2

gallon of water

enough for

approximately

minutes of continuous operation.

Water container is removable and easy to fill.

Automatic shut

off safety feature.

Easy to use drain port.

Eliminates ironing by removing wrinkles.

Easy roll casters make unit highly portable

Convenient hanger for hose.

Stores upright minimizing storage space requirements.

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, always follow basic safety

precautions, including the following:

Read all instructions.

To protect against risk of electrical shock, do not put appliance in water or

other liquid.

Close supervision is necessary when any appliance is used by or near

children.

Unplug from electrical outlet when not in use, before putting on or taking off

parts and before cleaning.

Avoid contact with hot parts. Keep hands, hair, and clothing away from these

parts to prevent risk of injury to persons and or burns that could occur.

Use this product for its intended use only

Do not operate any appliance with a damaged cord or plug or after the

appliance malfunctions or is dropped or damaged in any manner.

damaged

cord, plug or unit may result in fire, electrical shock or injury.

Do not leave the steamer unattended

Please allow the unit to cool before storage

10.

Always

turn

the

switch

off' position before plugging in or unplugging

the unit.

11.

Do not let cord touch hot surfaces.

12.

Do not operate steamer without properly filling the water container.

13.

Always keep the hose nozzle elevated above the water container.

Do not lay the hose on the floor.

14.

This appliance has a grounded plug. The unit must be plugged into

a properly grounded three-pronged outlet.

15.

Burnscan occur by touching hot parts, hot water or steam.

SAVE THESEINSTRUCTIONS

LEARNING ABOUT YOUR

STEAMER

Please refer to thepicture for each point

(1)

The control HANDLE on the end of the hose sits

just before the nozzle. The HANDLE is designed

to be heat free and is safe to grasp.Use the

HANDLE to aim the direction of the steam

released from the nozzle

(2)

The NOZZLE on the end of the handle is located

on the end of the steamer hose. Always hang the

NOZZLE end of the hose on the hanger rod when

not in use. Keep the NOZZLE point the NOZZLE

downward,water may condense and drip.

(3)

The ROD is designed to conveniently hang the

hose handle and also can support garments for

steaming

(4)

The

HOSE

extends from the base of the unit Do

not

pull

on the

HOSE

with undo tension as

damage to the hose may result

steam leakage

(5)

The ON/OFF switch is located on the front of the

base.

(6)

The WATER CONTAINER is filled through the

removable water valve on the bottom and should

be placed in the reservoir on the base.Avoid

spilling excess water into the reservoir as this

could cause the steamer to expel water from the

nozzle. Do not try to substitute another water

container for the one designed for this unit.

(7)

The WATER LEVEL can be seen visually in the

water container. Do not operate the steamer

without water in the WATER CONTAINER.

(8)

The steamer BASE houses the reservoir and

water container. It also supports the hanger rod

and hose.

(9)

The CASTERS allow the unit to roll freely

(10) The ELECTRICAL CORD plugs into a standard

three

prong plug. Use only three prong UL

approved extension cords with a minimum

20-

ampere rating

(11) The DRAIN

PLUG

is located on the side for

convenient drainage of the water reservoir.

STEAMER ASSEMBLY

STEP

ATTACHING THE METAL ROD

Set the appliance on a steady

surface. The bottom metal rod is

threaded on one end. Screw the two

larger metal rods together. Insert the

bottom of the metal rod into the

holder on the unit base and screw

the setscrew until tight. (Caution: do

not over tighten) Screw the top

smaller metal rod (with hook) into

the top of the large metal rod.

STEP

ATTACHING THE STEAMER HOSE

Screw the end of the steamer hose

with the knurled knob onto the

threaded pipe on the top of the

steamer unit. (Caution: Do not use

excessive force in tightening the

knob) Tighten by hand until it's no

longer turns. Hang the nozzle from

the metal rod. Prior to filling the

water tank, be certain that the

steamer's drain plug is properly

installed and tightened to prevent

leaking.

STEP

BEFORE FILLING THE WATER CONTAINER

Turn the water container upside down and inspect to see the valve

and spring assembly are functioning in the bottom of the container.

Place the container in the reservoir and inspect that it seats

securely.

STEAMER OPERATION

STEP I

PREPARATION FOR USE

Set the unit on the

floor and remove the

water container. Check the inside of the

container for sediment. Turn the container

upside down and push the valve open and

allow to close two or three times to insure

it is functioning smoothly. If the container

has been stored with water inside, it may

be necessary to remove the water and

clean the container. Follow the steps for

care and cleaning.

STEP

FILLING THE WATER CONTAINER

(PRIOR TO PLUGGING IN THE APPLIANCE)

Remove the water container with the handle

and turn upside down. Unscrew the valve

in the center of the base and pour water

into the opening or hold under a source of

running water until the container is filled to

the desired level. Replace the valve and

return the container to the upright position.

Place the water container onto the base

and make certain it seats properly into the

cavity.

DO NOT FILL THE CONTAINER WITH HOT WATER.

DO NOT ALLOW THE CONTAINER TO BECOME DRY DURING

OPERATION AS THIS WILL SHORTEN THE LIFE OF THE STEAMER

STEP

OPERATING THE STEAMER

Insure the ON/OFF switch is in the OFF

position. Plug the steamer cord into a normal

electrical outlet or approved extension cord.

Turn the

ON/OFF

switch to the

position.

The switch will light when electricity is

connected. Steam will be produced from

the nozzle in

few seconds.

PRESSING WITH STEAM

Grasp the control handle with the

nozzle facing upward. Beginning at the

bottom of the fabric will allow the steam

to rise inside and outside removing

wrinkles. Slowly move the nozzle from

the bottom to the top of the fabric.

Remove the nozzle from the garment

and smooth the fabric with your free

hand.

NOTE:

Pressing will be easier if there are fewer creases in the object to be

steamed.

Shaking out the article prior to steaming will avoid excess creasing

For towels, handkerchiefs and napkins, drape them over a rod or

steam press them in place over towel racks.

Heavier fabrics may require repeated steaming. Repeat steps one

and two as necessary.

With practice you will gain speed and efficiency. You will soon learn

which fabrics will require multiple steam applications.

Accessories

Fabric Brush

Your steamer is supplied with an

accessory fabric brush which can be

used to gently brush the knap of fabric

such as corduroy. To install simply snap

into the appropriate slot in the nozzle

when the steamer is off and cool.

Don't use the brush on delicate

fabrics such as silk or satin

Lint Remover

The supplied lint removal tool may be

used with the steamer or by itself. To

install on the steamer make certain the

unit is off

and

cool. Simply snap the tool

on the nozzle.

Captured lint may be removed by rubbing

the surface of the tool with a dry scrap of

fabric in the reverse direction from

normal use.

Squeegee

Another feature of steam is the ability to

clean. Live steam dissolves greasy film

and dirt. To take advantage of this your

unit is equipped with a squeegee to allow

the cleaning of windows, mirrors and

other glass surfaces. To install the

squeegee merely snap

into the

appropriate slot in the nozzle when your

unit is off and cool.

CLEANING AND STORING

a. Turn the ON/OFF switch to the

OFF

position and unplug from the

power source.

Wait for the steamer to cool completely for at least

minutes.

c. Remove and drain the water container.

Drain the unit by removing the drain

plug and allowing the contents of the,

reservoir to drain. Tip the unit in the

direction of the drain plug to remove

remaining water. Replace the plug.

d. Remove the steamer hose and

hanger rod.

e. Remove the water tank.

Remove excess water from the

reservoir by lifting the unit and

pouring. Flush the reservoir area with

fresh water to clean any residue from

the water source.

g. Pour fresh water into threaded pipe of steam hose. Then remove water

from reservoir to clean any residue inside the steamer. If there is too

much residue, you may use soft water to soak and flush the reservoir.

h. Reattach the hose, hanger rod and water container and store the unit.

OTHER IMPORTANT NOTES

During operation the steamer hose may

gurgle. This is

normal result of

condensation collecting inside the hose.

Simply lift the control handle upward until

the hose is extended to its full height. The

gurgling will disappear when the excess

moisture inside the hose has had a chance

to drain back into the base. If the steamer

stops producing steam then starts again.

You may wish to examine the inside of the

reservoir. The most common reason for

this effect is the accumulation of sediment

from mineral laden water. Clean the

offending sediment from inside the unit,

first following the steps for cooling and

cleaning the unit as presented previously.

Andere Handbücher für SF-450

Inhaltsverzeichnis

Andere Steamfast Küchengerät Handbücher

Steamfast

Steamfast SF-562 Bedienungsanleitung

Steamfast

Steamfast SF-562 Bedienungsanleitung

Steamfast

Steamfast SF-540 Bedienungsanleitung

Steamfast

Steamfast SF-435W Bedienungsanleitung

Steamfast

Steamfast SF-510 Bedienungsanleitung

Steamfast

Steamfast SF-292 Bedienungsanleitung

Steamfast

Steamfast SF-420 Bedienungsanleitung

Steamfast

Steamfast SF-540 Bedienungsanleitung

Steamfast

Steamfast MODEL SF-407 Bedienungsanleitung

Steamfast

Steamfast SF-410 Bedienungsanleitung

Steamfast

Steamfast SF-565 Bedienungsanleitung

Steamfast

Steamfast SF-452 Bedienungsanleitung

Steamfast

Steamfast SF-562 Bedienungsanleitung

Steamfast

Steamfast MODEL SF-407 Bedienungsanleitung

Steamfast

Steamfast Salton SF-450 Bedienungsanleitung

Steamfast

Steamfast QuickSteam SF-465 Bedienungsanleitung

Steamfast

Steamfast SP-350 Series Bedienungsanleitung

Beliebte Küchengerät Handbücher anderer Marken

Tayama

Tayama TYG-35AF Bedienungsanleitung

AEG

AEG 43172V-MN Bedienungsanleitung

REBER

REBER Professional 40 Benutzerhandbuch

North American

North American BB12482G / TR-F-04-B-NCT-1 Bedienungsanleitung

Presto

Presto fountain popper Bedienungsanleitung

Westmark

Westmark 1035 2260 Bedienungsanleitung

Zanussi

Zanussi ZCG64396XA Bedienungsanleitung

HOFFEN

HOFFEN SM-9302M Bedienungsanleitung

Philips

Philips HD3133 Bedienungsanleitung

Ronco

Ronco Beef Jerky Bedienungsanleitung

Hendi

Hendi 470411 Bedienungsanleitung

Livoo

Livoo MEN386 Bedienungsanleitung

Vogue

Vogue D446 Bedienungsanleitung

croydon

croydon WR-10313-700 Bedienungsanleitung

ADE

ADE AUTOMATIC-L Bedienungsanleitung

Chefman

Chefman RJ43-SQ Series Bedienungsanleitung

Vacmaster

Vacmaster VP680 Bedienungsanleitung

Jetmaster

Jetmaster 900HG Bedienungsanleitung