Music A
3.5mm jack
Music B RCA
input jack
Installation and Operating Instructions
ChromaSense and AudioSense Option
Control Module Installation
Models: TSMC, TSCH, & TSMU
The ChromaSense and AudioSense options are designed to work exclusively with the Steamist Total Sense TSG
generators and TSC, TSC-350 controls. This option does not work with the TSC-250 control. This manual covers the
installation of both the ChromaSense and the AudioSense package model TSMC. It also covers the ChromaSense only
option model TSCH and the AudioSense only option model TSMU. The iPod cradle and music connections are exclu-
sive to the AudioSense option and are not included with the ChromaSense only option. The Chromatherapy Light and
light connection is exclusive to the ChromaSense option and not included in the AudioSense only option. These three
models use different control modules. They are not interchangeable. To upgrade from the ChromaSense only or
AudioSense only to the combined package requires replacing the control module.
NOTE: This option will not work with the TSC-250 control
Figure 1 - TSC Digital Control Module
06/10 Pub. No. 206-C
- 1 -
NOTE: Installation of models TSMC, TSCH, and TSMU
are the same.
1) Select a location for mounting the control module in a
utility area or closet. When purchased with Audio-
Sense option there are audio input jacks on the side of
the module that should be conveniently accessible to
plug in additional audio inputs. Do not install any part
of this assembly in a wall.
2) Secure two screws in the wall to hang the control
module in this location. The screws should be placed
10" apart and level.
3) Make sure a 120 volt outlet is located next to the
module mounting location. Plug the power cord after
all connections are complete.
4) Route the control cable from the module location to the
TSG generator or optional TSA. The manners in which
the cables are routed are dependent on what is best
suited for the installation. There are four connection
jacks in TSG generator(s) and two in the TSA, and two
in this module allowing for gangable connections in
the most convenient arrangement. The manner in
which everything is interconnected is not important
only that everything is interconnected (See page 4 for
the system wiring diagram).
5) The AudioSense option requires speakers which are
purchased separately. Refer to the wiring diagram on
page 4 for connecting the speakers to the control
module.
6) The wiring for the iPod cradle and Chroma light, are
explained in the following sections.
Note: Audio jacks are not available on the TSCH.
®CUS
®
