MAINTENANCE
LUBRICATION:
Air tools require lubrication throughout the lifetime of the tools. The air motor and bearing uses
compressed air to power the tool, due to the moisture of the compressed air will rust the air motor
and other parts in side of the tools, therefore lubrication is required daily. Failure to lubricate the air
tool properly will dramatically shorten the life of the tool and will void the warranty.
This air tool requires lubrication BEFORE initial use, also before and after each additional use.
To lubricate the air tool manually.
STORAGE:
The air tool must be lubricated before storing. Follow the “Lubrication” instruction with exception of step 4.
NOTE
DANGER: Danger alerts you to a hazard that WILL result in death or serious injury.
WARNING: Warning alerts you to a hazard that COULD result in death or serious injury.
CAUTION: Caution alerts you to a hazard that MAY result in minor injury.
1. Remove any attachment on the drive of air tools, such as: sockets, chisels and etc.
2. Disconnect the tool from the air supply source, place the air inlet faces up.
3. Depress the trigger and place about 5 c.c. of air tool oil into the air inlet. (Depressing the trigger
will help circulating oil in the motor.) NOTE: Use SAE #10 weight oil if air tool oil is not available.
WARNING: Keep out of the reach of children. If taken internally, do not induce vomiting, call a
doctor immediately.
4.
Connect the tool to air source, cover the exhaust end with a towel and run for about 20 to 30 seconds.
WARNING: Any excess oil in the motor is immediately expelled from the exhaust port.
Always direct exhaust port away from people or objects.
9. Never lever the tool when not applied to a work object. Attachments must be securely attached.
Loose attachments can cause serious injury.
10. Protect air lines from damage or puncture.
11. Never point an air tool at oneself or any other person. Serious injury could occur.
12.
Check air hoses for weak or worn condition before each use. Make sure all connections are secure.
13. Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition.
14. Do not put hands near or under moving parts.
WARNING: DO NOT misuse the product, excessive exposure to vibration, work in awkward
position and repetitive work motion.
15. IMPORTANT: The warnings mentioned in this manual cannot cover all possible conditions
and situations that may occur. Operators must have common sense in mind and use this tool
with caution to avoid any injuries from happening.
16. Keep children and bystanders far away during operating this tool.
17. Maintain air tools. If the tools are damaged, have the tools repaired before use.
18. Do not smoke during use.
19. Always stay alert and keep an eye on what you are doing. Do not use the product if you feel
tired or under the influence of drugs, alcohol, or medication. A moment of distraction when
operating cranes may result in serious personal injury.
