-Keep away from this unit child under 3 years unless they are under continuous surveillance.
-Children between 3 and 8 years must only turn on & off the unit as long as it has been installed
in a normal position, that these children have supervision, have received instructions to use of
the device safely and have understood the potential dangers. Children between 3 and 8 years
must not connect, adjust or clean the appliance, or make the user maintenance.
-This device should not be used by unsupervised children under 8 years old and by people with
physical, sensory or mental reduced capabilities and by persons with lack of experience or
knowledge, unless they can benefit through a person responsible for their safety of prior
instructions. Children must not play with the appliance. Cleaning and maintenance by the user
must not be performed by unsupervised children.
-This device must be plugged or connected according to the rules and standards applicable by
an authorized person.
-The instruction book of this product is available by contacting the after-sales service with the
number indicate on the warranty part included in this manual service.
-If the power cable is damaged, it must be replaced by the manufacturer, its after sales service
or similarly qualified persons in order to avoid any danger.
2.1 Where to install your heater?
- This equipment was designed to be installed in a residence. Please ask your distributor before using it for any other
purpose.
- The panel heater should be installed according to normal trade practice and incompliance with legislation in the relevant
country (NFC 15-100 for France).
- The equipment is class 2 and is protected against splashed water IP 24. The device can be installed in volume 2 of a
bathroom (Figure ❶). It’s forbidden to install the device in the volume 1. The device is to be installed so that switches and
other controls cannot be touched by a person in the bath or shower.
- Comply with the minimum clearance distances for positioning of the panel (Figure ❷).
- The wall bracket allows keeping a free space behind the device to not disturb its regulation. The distance between the unit
and the wall should not be obstructed.
2.2 Do not install the panel heater
- In a draught that might affect adjustment (for example, under a central mechanical ventilation unit etc...). Under a fixed
power socket (Figure ❸) or near curtains or other combustible materials.
- In a non-conform position.
- The air outlet grid and the control unit is visible in the upper part of the device. It is forbidden to install a vertical unit
horizontally and vice versa (Figure ❹).
2.3 How to install the panel heater?
2.3.1 Preparation
a. Release the appliance’s hook-on bracket (Figure ❺)
- We recommend that you place the panel heater flat, face down. Take a flat head screwdriver and lift the tab taking care not
deform. While holding the tab lifted, push the locking bracket to the bottom of the unit to release the upper hooks. Rotate
the attachment tab around the lower hooks and remove the attachment tab.
b. Fix the hook-on bracket (Figure ❻)
-Place the bracket on the ground and against the wall and mark the drilling points A. These give the position of the bottom
fasteners. Replace the brackets in alignment with the drilling point Ato locate drilling points B. These give the position of
the upper fasteners. In case of special support, use proper anchors. Position and screw the wall brackets.
2.3.2 Electrical connexion
- The appliance should have a 230 V / 50Hz power supply. The panel heater must be connected to the mains by a 2-wire
cable with plug or 3-wire cable (Brown= Phase, Blue = Neutral, Black = Pilot wire) by means of a connexion box. In humid
5
