Stratus ftServer T30 Gebrauchs- und Pflegehandbuch
ftServer T30
Technical Reference Guide
Revision 0 – 5/21/04
1. Overview
The ftServer T30 consists of a 6U system, rack mounted in a standard 19-inch customer-supplied
cabinet. The diagram below is a representation of the system configuration, independent of a
cabinet.
2. Operating System Requirements
The ftServer T30 system is supported by the Stratus ft Linux operating system, which is based on
the Linux operating system with Stratus additions. These additions include software hardening
features and support for Stratus fault-tolerant ftServer hardware.
1U I/O Enclosure (Slot 10) Æ
1U I/O Enclosure (Slot 11) Æ
1U CPU Enclosure (Slot 2 Æ
1U CPU Enclosure (Slot 0) Æ
1U DC/AC Inverter Æ
1U DC/AC Inverter Æ
The minimum release of Stratus ft Linux is 2.1.
3. Hardware Components
The main hardware components in the ftServer T30 system are the following:
•2 CPU Enclosures
•2 I/O Enclosures
•4U Backplane
•2 DC/AC Inverters (with backplanes)
3.1 CPU Enclosure
Each CPU enclosure contains:
•2 processors
•6 DIMM slots
The 2.4-GHz processors, with integrated 512-KB iL2 cache and 400-MHz Front Side Bus, are
two-way (two processors per CPU enclosure) symmetric multiprocessing (SMP).
The ftServer T30 uses DDR (Dual Data Rate) Dual Inline Memory Module (DIMM) memory in
256-MB and 512-MB configurations. The minimum ftServer T30 logical memory is 512 MB
and the maximum is 3 GB.
Up to six DIMMs can be housed in each CPU enclosure. DIMMs must be loaded in pairs.
The following table lists the memory modules currently supported in ftServer T30 systems.
The following table shows the supported memory configurations:
Mktg. ID Description Minimum # per
CPU Enclosure
Maximum # per
CPU Enclosure
M227 256-MB DDR DIMM 2 6
M228 512-MB DDR DIMM 2 6
Total Memory in Each
CPU Enclosure Number of Modules in Each CPU Enclosure
512 MB 2 M227 modules
1 GB 4 M227 modules or 2 M228 modules
1.5 GB 6 M227 modules
2 GB 4 M228 modules
3 GB 6 M228 modules
3.2 I/O Enclosure
Each IO enclosure contains:
•One CD-ROM drive
•One 10/100 Ethernet interface
•One 10/100/1000 Ethernet interface
•Three single-initiated internal SCSI disk slots
•One external SCSI port for tape drive
•One 32-bit 33-MHz PCI slot (reserved for the U917 VGA Adapter)
•Two 64-bit 33-MHz PCI slots
3.2.1 PCI Adapters
The table below describes the PCI adapters that can be configured in ftServer T30 systems. It
also includes the minimum and maximum number of adapters supported
Mktg. ID Description Min. # Max. #
U574 2-port 1000Base-Sx (Fiber Gigabit) Ethernet Adapter 0 4
U575 2-port 1000Base-T (Copper Gigabit) Ethernet Adapter 0 4
U917 VGA Adapter 2 2
U918 4-port T1/E1 Adapter (For SINAP) 0 4
3.2.2 SCSI Disk Drives
A minimum of four SCSI disk drives are required in ftServer T30 systems. All three disk slots in
the top core I/O enclosure must be populated, as well as one in the lower enclosure.
The following table lists the SCSI disk drives supported in the core I/O enclosures.
Model Description
D531 36-GB disk drive (10K RPM)
D532 73-GB disk drive (10K RPM)
D533 18-GB disk drive (15K RPM)
3.3 Backplane
The ftServer T30 system contains a 4U backplane through which the CPU and I/O enclosures
interconnect.
The backplane contains the system clock card, two IDPROMs, and the connector I/O card. The
connector I/O card contains the serial, USB, and VGA ports.
3.4 DC/AC Inverter
Each DC/AC inverter supplies power from a NEBS -48 VDC power plant to half of the ftServer
T30 system.
Each DC/AC inverter connects to a separate backplane that contains DC input and AC output
connectors. There are two versions of the DC/AC inverter: one supplies 120V, 60 Hz power.
And the other supplies 230V, 50 Hz power.
3.5 Optional Components
Optional components of an ftServer T30 system include
•Tape drives
•Keyboard, mouse, and monitor
•External Floppy Disk Drive
•Modem
3.5.1 Tape Drives
ftServer T30 systems support DDS-4 tabletop tape drives. No tape drives are mounted in the
cabinet. They are all external to the cabinet.
The following table lists the tape drives supported on ftServer T30 systems.
Model Description
T511 HP-DDS-4 DAT tape drive
T512 HP-DDS-4 DAT tape drive with autoloader
3.5.2 Keyboard/Monitor/Mouse
The V115 is a 107-key, USB-compatible keyboard with PS/2 mouse. The keyboard includes a
PS/2 port to which the mouse can be connected. The keyboard and mouse connect to the system
by a USB port.
The following table lists the keyboard, monitor, and mouse types.
Marketing ID Description
V128 ftServer 15” Rack Mount LCD Display with Keyboard Drawer
V129 External 15” Color VGA Monitor
V115 ftServer USB Keyboard/Mouse
N/A Customer-Supplied Monitor
3.5.3 External Floppy Disk Drive
The ftServer T30 system does not support an internal floppy disk drive. An optional external
USB floppy drive (model number AK438) can be connected via a USB port.
3.5.4 Modem
The C719, an external serial 56K Data/Fax MultiTech ZBA modem, is used to connect to the
Stratus ActiveService Network (ASN).
4. System Configuration
Marketing ID P5101R-2D
Processor DMR
SMP 2-way
Processor Speed 2.4 GHz
Cache size 512 KB iL2
Front-side bus 400 MHz
No. CPU Enclosures 2
No. Logical Processors 2
No. Physical Processors 4
Min/Max Memory 512 MB/3 GB
5. System Specifications
5.1 System
Physical
Height
AC System: 7 in. (17.78 cm; 4U)
DC System: 10.0 in. (6U)
Width 17.75 in. (45 cm)
Depth 29.23 in. (75 cm)
System weight
AC System: 124 lb (56.25 kg)
DC System: 137 lb (62 kg)
Environmental
Operating temperature 5ºC to 40ºC normal - 0ºC to 50º Short Term
Non Operating Temperature
-40°C to +70°C (Unvented)
-40°C to +60°C (Vented)
Operating Altitude 0 to 10000 ft ( 0 to 3048 m )
Maximum rate of temp. change during operation 12°C/Hour
Relative humidity during operation 5% to 85% Non-condensing
Relative humidity during storage To 95%
Acoustic Sound Pressure Limits Operating : 71 dBA max
Heat dissipation 4830 BTUs per hour
Electrical
Input wattage
A-side: 1415W (DC)
B-side: 1415W (DC)
Service requirements
AC Systems: 110 - 240 VAC
DC Systems: -48 VDC
Input voltage (Minimum)
AC Systems: 110 VAC
DC Systems: -40 VDC
Input voltage (Normal)
AC Systems: 200-240 VAC
DC Systems: -48 VDC
Input voltage (Maximum)
AC Systems: 264 VAC
DC Systems: -60 VDC
AC Input frequency
AC Systems: 50-60Hz
DC Systems: NA
5.2 V128 LCD Display
Physical
Height 1.75 in. (4.45 cm; 1U)
Width 19 in. (48.3 cm)
Depth 24 in. (61 cm)
Environmental
Operating temperature 32 F to 104 F (0 C to 40 C)
Storage temperature -13 Fto +140 F (-25 C to +60 C)
Relative humidity during operation 10% to 80% (noncondensing)
Relative humidity during storage 5% to 95% (noncondensing)
Heat dissipation 38 BTUs per hour
Electrical
Output wattage 21 W (AC)
Input voltage 90-265 volts AC; 47-63 Hz
5.3 V129 LCD Display
Physical
Height 14.3 in. (36.2 cm)
Width 13.6 in. (34.2 cm)
Depth 7.3 in. (18.5 cm)
Weight 5.7 lb (2.6 kg)
Environmental
Operating temperature 41°F to 95°F (5°C to 35°C)
Storage temperature 41°F to +113°F (5°C to 45°C)
Relative humidity during operation 30% to 80% (noncondensing)
Relative humidity during storage 5% to 90% (noncondensing)
Heat dissipation 103 BTUs per hour
Electrical
Output wattage 30 W (AC)
Nominal input voltage; Frequency 90–265 volts AC; 47–63 Hz
5.4 V115 Keyboard
Height 2.5 in. (6.4 cm; 2U)
Width 19 in. (48.3 cm)
Depth 8 in. (20.3 cm)
5.5 C719 External Modem
Physical
Height 1.00 in. (2.5 cm)
Width 4.25 in. (10.8 cm)
Depth 5.60 in. (14.2 cm)
Electrical
Output wattage N/A
Nominal input voltage; Frequency range 100–240 volts AC; 50–60 Hz
5.6 T511 DDS-4 DAT Tape Drive
Power
Output wattage 22.5 W (AC) max.
Nominal input voltage; Frequency 100–240 volts AC; 50–60 Hz
Physical
Height 3.7 in. (95 mm)
Width 4.6 in. (116 mm)
Depth 8.7 in. (220 mm)
Weight 4.6 lb (2.1 kg)
5.7 T512 DDS-4 DAT Tape Drive with Autoloader
Power
Output wattage
Tape drive 17.4 W (AC) max.
Tape drive with autoloader 27.8 W (AC) max.
Nominal input voltage; Frequency 100–240 volts AC; 50–60 Hz
Physical
Height 5.3 in. (135 mm)
Width 6.5 in. (165 mm)
Depth 10.6 in. (269 mm)
Weight 10.56 lb (4.65 kg)
Tape capacity 6 tapes
6. Related Documentation
The following sections contain related information pertaining to ftServer T30 systems.
6.1 Service Documentation
•ftServer Technical Service Guide
6.2 Customer Documentation
•Stratus ftServer T30: Site Planning Guide (R001L)
•Stratus ftServer T30: Installation Guide (R002L)
•Stratus ftLinux System Administrator’s Guide (R003L)
•Stratus ftServer T30: Operation and Maintenance Guide (R004L)
•Release Notes: Stratus ftLinux Release 2.1 (R005L)
•Read Me First: Unpacking an ftServer T30 System (R006L)
•Stratus ftServer: ActiveService Network Configuration Guide (R013W)
•Stratus ftServer T30 with ftLinux Release 2.1: Stratus ftLinux Migration White Paper,
Stratus ftServer T30 Configuration Specification (R1000LCD)
Inhaltsverzeichnis
Andere Stratus Server Handbücher
Stratus
Stratus ftServer 2600 Technisches Handbuch
Stratus
Stratus ftServer 2510 Technisches Handbuch
Stratus
Stratus AA-E99100 Bedienungsanleitung
Stratus
Stratus V 6624 Handbuch
Stratus
Stratus ftserver 3300 Technisches Handbuch
Stratus
Stratus ftServer V 2404 Handbuch
Stratus
Stratus ftServer 2900 Series Technisches Handbuch
Stratus
Stratus ftServer V 2302 Handbuch
Stratus
Stratus ftServer 3000 Series Technisches Handbuch
Stratus
Stratus ftServer 2500 Technisches Handbuch
Beliebte Server Handbücher anderer Marken
iRobo
iRobo IPC2U Bedienungsanleitung
Nortel
Nortel 1000 Con?guration guide Bedienungsanleitung
Asus
Asus AP7500 Bedienungs- und Wartungshandbuch
Avid Technology
Avid Technology AirSpeed 5000 Bedienungsanleitung
HP
HP Integrity rx2600 Installationsanleitung
Milestone
Milestone Husky IVO 350T Bedienungsanleitung