STRIVR STRIVR Bedienungsanleitung

The main pieces of equipment you’ll

be using are the VR headset and its

attached controller.

Before you start training, make sure

the headset is charged. Plug the

white USB cable into the adapter

and plug it into a wall outlet. Then

plug the other end into the charging

port on your headset. If you see a

red or yellow light on the headset,

it’s charging. If the light shows

green, the headset is fully charged.

Don’t start training if the light is red.

A full charge takes about two hours.

Get ready to experience Immersive Learning. You’ll be putting on a VR headset and exploring

training activities in a virtual world.

This booklet will give you an overview of how to use the equipment and what to expect, plus

some troubleshooting tips.

Get ready

STEP

Welcome to Immersive

Learning with Strivr

INDICATOR

LIGHT CHARGING

PORT

Get familiar with the equipment

The controller

BACK

VOLUME

TRIGGER

BATTERY

COMPARTMENT

HOME

INDICATOR

LIGHT

The controller is what you use to point and click in VR, using the trigger.

When you rst put the headset on, you may be asked to re-center or calibrate the

controller, matching the view inside the headset to the direction you’re facing. Do this by

holding down the home button for two seconds.

Control the volume with the buttons on the side of the controller, pause the experience

with the back button, and exit to the Strivr menu with the home button.

STEP

The headset

To turn the headset on, press and

hold the power button located on the

bottom of the headset for about ve

seconds or until the indicator light

next to the power button turns blue.

To check to see that it’s powered on,

hold the headset up to your eyes and

the screen inside will illuminate.

If you accidentally press the power

button during training, the display

will go to sleep. Press it again to

turn the display back on and resume

training.

Wearing the headset

Put the headset over your eyes rst

(if you have glasses, leave them

on—most frames t.) Then pull the

straps over your head and adjust

the straps until they’re comfortable.

The headset includes a detachable

inner top strap for a good t. If you

take it off, be sure not to lose it.

Once the headset’s charged and

powered on, you’re ready to start

training with Strivr.

VOLUME

CONTROL

POWER

INDICATOR LIGHT

SIDE STRAP

REMOVABLE INNER STRAP

CHARGING

PORT

HEADPHONE

JACK

Connect to Wi-Fi

STEP

If this is the rst time this headset is being used at your location, you’ll need to connect to

your local Wi-Fi network.

Put the headset on and hold

Trackpad-UP and the trigger

for three seconds to open the

Wi-Fi page.

Make sure Wi-Fi is on, then

select your Wi-Fi network and

key in the password. Select

the return arrow to go back to

training.

In the headset, you can check that you’re connected by visting the About page. Select

About on the menu screen and make sure the status reads Connected to Strivr.

When you put the headset on, you’ll see several screens with the kind of information you’re

reading right now: how to adjust the headset and how to use the controller. Next you’ll

be asked to log in with the credentials you received from your company. Then you’ll pick a

training experience and dive in.

NOTE: Your company’s screens may look different than the screens you see here.

STEP

Finish up

When your training ends, make sure to log off inside the headset—if you don’t, your

results can’t be sent to your company and you won’t get credit for the training.

STEP

Clean and replace the equipment

Place the headset and controller back into the tray and plug the charging cable into the

headset.

Before you replace the headset and controller in the tray, use the included wet wipes to make

sure the equipment is clean and disinfected. Wipe the entire headset and controller including

the headset straps, but not the lenses! Then use the dry microber cloth to wipe the lenses.

Starting from the center of the lens, gently wipe the lens in a circular motion moving outwards.

STEP

Thank you for training with Strivr

The screen is black

Try the following solutions in order until one

works:

• You may have pressed the power button

on the headset when putting it on. Press it

again to wake the headset.

• Try rebooting the headset by holding down

the power button for about 5 seconds

• If the screen is still black, connect the

headset to power for 15 minutes and

check again.

The controller is not working

If the controller is unresponsive and the

controller battery level is ashing 0%, press

the Home button to wake the controller. The

battery level should reset.

If the controller is still unresponsive, try the

following solutions in order until one works:

• Press and hold the Home button for two

seconds to re-center the controller.

• Open the battery compartment on the

back of the controller and make sure the

battery is pushed in all the way.

• If the controller has become disconnected

from the headset, re-pair it by pressing

the Home button. The indicator light starts

to blink—when the light turns off, the

controller is paired.

• If these solutions don’t work, try replacing

the controller batteries. NOTE: you can

check the battery level during training

by holding the controller in front of the

headset.

The headset is not charging

Try the following solutions in order until one

works:

• Plug the headset into the adapter and

wait 15 minutes. If the light is yellow, the

headset is currently charging. If the light is

green, the headset is fully charged.

• If no light shows on the headset, make

sure the USB cable is fully plugged into the

adapter and the headset.

I accidentally exited training

If you accidentally exit training and see the Pico

Settings screen, you can return to training by

pressing the Home button.

Troubleshooting

The headset is not connected to

Strivr

If the About screen in the headset does not

say Connected to Strivr, it cannot transfer

training results and download training content.

If the About screen says Wi-Fi not enabled,

open the Wi-Fi screen as shown in Step 3 of

this document and enable Wi-Fi. If you see

the status Not Connected to Strivr, contact

support.

Note that learners can train when not

connected to Strivr.

I sometimes feel dizzy. Should I

take precautions?

Discomfort can happen, especially for rst-time

VR users. If you feel discomfort, the rst thing

to do is take off the headset and relax for a few

minutes. You may nd when you try again, you

feel ne. Try sitting in a swivel chair to train,

rather than standing. If that doesn’t mitigate

the dizzy feeling, no problem—we never want

to force anyone into the headset.

Let your manager know if you are unable to

complete the training.

USING VIRTUAL REALITY (“VR”) CAN PO-

TENTIALLY HAVE UNINTENDED HARMFUL

EFFECTS ON YOUR HEALTH OR SAFETY. TO

REDUCE THE RISK OF PERSONAL INJURY,

USING VIRTUAL REALITY (“VR”) CAN PO-

TENTIALLY HAVE UNINTENDED HARMFUL

EFFECTS ON YOUR HEALTH OR SAFETY. TO

REDUCE THE RISK O PERSONAL INJURY,

DISCOMFORT, OR PROPERTY DAMAGE,

PLEASE ENSURE THAT ALL USERS READ

THESE WARNINGS CAREFULLY BEFORE USE.

CONSULT WITH A PHYSICIAN BEFORE

USING VR IF YOU ARE PREGNANT, ELDERLY,

EPILEPTIC, OR HAVE VISION, PSYCHIAT-

RIC, HEART, OR OTHER SERIOUS MEDICAL

CONDITIONS. THIS PRODUCT SHOULD NOT

BE USED BY CHILDREN UNDER THE AGE OF

13. DO NOT USE IF YOU ARE SICK, FATIGUED,

UNDER THE INFLUENCE OF INTOXICANTS/

DRUGS, OR NOT FEELING WELL, AS IT MAY

EXACERBATE YOUR CONDITION.

Photosensitivity & seizures

Some individuals may experience epileptic

seizures or blackouts when exposed to certain

light patterns or ashing lights. Exposure to

certain patterns or backgrounds on a screen or

when viewing video content, such as VR con-

tent, may trigger epileptic seizures or blackouts.

These conditions may trigger previously unde-

tected epileptic symptoms or seizures even in

persons who have no history of prior seizures

or epilepsy.

If you, or anyone in your family has an epileptic

condition or has had seizures of any kind, con-

sult your physician before using these Services.

Nausea & potential health eects

VR may trigger motion sickness in some

individuals due to the difference in the eld of

vision and focus points between the real world

and the virtual world. Cease use of VR immedi-

ately if you experience disorientation or motion

sickness.

IMMEDIATELY DISCONTINUE use and con-

sult your physician before resuming use of the

Services if you experience any of the following

health problems or symptoms at any time be-

fore, during, or after use:

Dizziness

Altered, blurred, or double vision or eye dis-

comfort

Eye or muscle twitches

Loss of awareness

Disorientation

Panic or anxiety attack

Excessive sweating

Nausea

Health & safety warnings

Strivr health & safety warnings

Inhaltsverzeichnis

Andere STRIVR Virtual-Reality-Headset Handbücher

STRIVR

STRIVR PICO NEO 3 Bedienungsanleitung

Beliebte Virtual-Reality-Headset Handbücher anderer Marken

iLive

iLive IVR77-1762-01 Bedienungsanleitung

NuEyes

NuEyes e2+ Bedienungsanleitung

WalkOVR

WalkOVR WalkOVR Bedienungsanleitung

D-Parts

D-Parts Fantastic Bedienungsanleitung

PICO

PICO G2 4K Bedienungsanleitung

Zoomax

Zoomax Acesight VR Bedienungsanleitung

AVANTIS

AVANTIS CLASSVR CVR-255-64 Bedienungsanleitung

VITURE ONE

VITURE ONE XR GLASSES Bedienungsanleitung

Samsung

Samsung SM-R320 Bedienungsanleitung

HTC

HTC Vive Focus 3 Bedienungsanleitung

Sony

Sony Glasstron PLM-S700E Bedienungsanleitung

PICO

PICO Neo 2 Bedienungsanleitung

HP Reverb G2 Bedienungsanleitung

Exibel

Exibel VR-F601 Bedienungsanleitung

Sony

Sony PLAYSTATION VR Bedienungsanleitung

OCULUS

OCULUS Rift S Bedienungsanleitung

Aimpoint

Aimpoint Gaim Compact Bedienungsanleitung

OCULUS

OCULUS Go Bedienungsanleitung