Sun Microsystems Sun Fire E25K Bedienungsanleitung

1 2 3 4 5 6

12SV2

System Controller CPU Board, Netra™

CompactPCI, Installation Guide

Sun Fire™E25K/E20K Systems

Sun Fire 15K/12K Systems

Preparing the Sun Fire Systems for the System

Controller CPU Board Installation

Caution – Be sure you are properly grounded before you begin the

hardware removal and installation. There are four ground points on

the system cabinet, two at the front top left and top right, and two at

the rear top left and top right.

Caution – The Sun Fire systems do not support the Netra CP2140

CompactPCI as a hot-swappable component.

The system controller CPU board, Netra CP2140 CompactPCI, is not a hot-

swappable component. Damage can occur to the board if all power-down

procedures are not followed.

Caution – Before removing the system controller CPU board from

the system, the green activation LED must be off and the amber or

blue removal OK LED must be on.

1. Power off and remove the System Control (SC) board as defined in the

system service manual for your system.

2. Remove the SC and the system controller CPU board as defined in the

system service manual for your system.

Inspecting the System Controller CPU Board for

the System Control Board

Note – Prior to installation, Sun Microsystem technicians need to reference

Infodoc 72037 for the required system controller CPU upgrade information.

Inspect the new board before inserting it into your Sun Fire system.

1. Remove the connector protective cover from the board being installed

and inspect the connector for any damage or gaps between the pins.

2. Ensure the board alignment tabs are not bent.

3. Inspect the mating connector before inserting the new board.

Caution – Do not force any board into a slot; it can cause damage to

the board and the system. The board should insert and seat

smoothly. If it binds, remove the board and inspect the card cage slot

for any obvious obstructions.

Installing the Memory Boards on the System

Controller CPU Board

The system controller CPU board can support up to two memory boards, each

with a 512-Mbyte configuration. The first memory board is installed directly

onto the system controller CPU board. The second memory board is installed

directly on top of the first memory board.

1. Determine if one or two memory boards are being installed for this

installation.

■If you are installing the single memory board configuration, follow

Step 2, Step 3, and Step 5 below.

■If you are installing the double memory board configuration, follow

Step 2 through Step 5 below.

2. Using a screwdriver, set the two memory board plastic support fasteners

to the open position with the slots away from the board.

3. Align the two bottom memory board connectors (P3 and P4) above the

memory board connector sockets (J0601 and J0602), located at the center

of the system controller CPU board, and press down firmly, ensuring the

two connectors are properly seated.

Caution – To avoid microfracture damage to the system controller

CPU board, do not apply excessive pressure on any of the

connectors.

4. For the second memory board, align the two bottom connectors (P3 and

P4) on top of the first memory board connector sockets (P1 and P2) and

press down firmly, ensuring the two connectors are properly seated in the

first memory board.

5. Using a screwdriver, set the two memory board plastic support fasteners

to the locked position by turning the fastener 180 degrees.

Verifying the Switch Settings on the System

Controller CPU Board

Verify all switch positions are set as follows prior to rebooting the system

controller CPU board.

1. Ensure the system management controller (SMC) switches (SW0501-1 and

SW0501-2) are in the down (off) position.

2. Ensure power module configuration (PS) switches 1 and 4 are in the up

(on) position, and PS 2, 3, 5, and 6 are in the down (off) position.

3. Ensure the SW1801 and SW2401 switches are in the up position.

Completing the Installation

To complete the installation procedure, refer to the following sections of the

system service manual for your system:

■“Installing the System Controller CPU Board”

■“Installing the System Control (SC) Board”

■“Verifying the Memory Boards on the System Controller CPU”

1 2 3 4 5 6

34 SV4

12 SV2

SW2401 SW1801

12 SV2

34 SV4

12 SV2

SW2401

SW1801

12 SV2

SW0501

1 2 3 4 5 6

Sun Microsystems, Inc.

www.sun.com

Part No. 817-1841-10, Rev. A

April 2004

Accessing Sun Documentation

You can view, print, or purchase a broad selection of Sun documentation,

including localized versions, at:

http://www.sun.com/documentation

Contacting Sun Technical Support

If you have technical questions about this product that are not answered in this

document, go to:

http://www.sun.com/service/contacting

Sun Welcomes Your Comments

Sun is interested in improving its documentation and welcomes your

comments and suggestions. You can submit your comments by going to:

http://www.sun.com/hwdocs/feedback

Please include the title and part number of your document with your feedback:

System Controller CPU Board, Netra CP2140 CompactPCI, Installation Guide, part

number 817-1841-10

technology, is copyrighted and licensed from Sun suppliers. Portions may be derived from Berkeley BSD systems, licensed from

U. of CA. Sun, Sun Microsystems, the Sun logo, Sun Fire, and Solaris are trademarks or registered trademarks of Sun

Microsystems, Inc. in the U.S. and in other countries. All SPARC trademarks are used under license and are trademarks or

registered trademarks of SPARC International, Inc. in the U.S. and in other countries. U.S. Government Rights—Commercial

use. Government users are subject to the Sun Microsystems, Inc. standard license agreement and applicable provisions of the

FAR and its supplements.

logiciel détenu par des tiers, et qui comprend la technologie relative aux polices de caractères, est protégépar un copyright et

licenciépar des fournisseurs de Sun. Des parties de ce produit pourront être dérivées des systèmes Berkeley BSD licenciés par

l’Universitéde Californie. Sun, Sun Microsystems, le logo Sun, Sun Fire, et Solaris sont des marques de fabrique ou des

marques déposées de Sun Microsystems, Inc. aux Etats-Unis et dans d’autres pays. Toutes les marques SPARC sont utilisées

sous licence et sont des marques de fabrique ou des marques déposées de SPARC International, Inc. aux Etats-Unis et dans

d’autres pays.

Andere Handbücher für Sun Fire E25K

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sun Microsystems Computerhardware Handbücher

Sun Microsystems

Sun Microsystems Sun Enterprise 5000 Installations- und Betriebshandbuch

Sun Microsystems

Sun Microsystems Sun Blade T6320 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Blade 1000 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Rack Bedienungsanleitung

Sun Microsystems

Sun Microsystems SME5224AUPA-400 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorageTek 5220 NAS Appliance Bedienungsanleitung

Sun Microsystems

Sun Microsystems Enterprise 00 Series Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Fire Cabinet Installations- und Betriebsanleitung

Sun Microsystems

Sun Microsystems StorEdge L1000 Bedienungsanleitung

Sun Microsystems

Sun Microsystems 2060 Installations- und Betriebshandbuch

Sun Microsystems

Sun Microsystems Enterprise 3500 Bedienungsanleitung

Sun Microsystems

Sun Microsystems UltraSPARC-I Bedienungsanleitung

Sun Microsystems

Sun Microsystems SPARCcenter 2000 Bedienungsanleitung

Sun Microsystems

Sun Microsystems 3400 Merkblatt

Sun Microsystems

Sun Microsystems StorEdge 3000 Series Bedienungsanleitung

Sun Microsystems

Sun Microsystems UltraSPARC III Cu Module Bedienungsanleitung

Sun Microsystems

Sun Microsystems Enterprise 3500 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Adapter forTCP/IPHL7 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Ultra Enterprise Caster Base Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Enterprise 10000 Handbuch

Sun Microsystems

Sun Microsystems Dual Anleitung zur Verwendung

Sun Microsystems

Sun Microsystems Netra ft 1800 Kurzanleitung

Sun Microsystems

Sun Microsystems SunPCi II 2.3 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Netra t1 Series Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung