Sun Microsystems Netra ft 1800 Montageanleitung

901 San Antonio Road

Palo Alto, CA 94303-4900 USA

650 960-1300 Fax 650 969-9131

Netra™ft 1800

Hardware Installation

Manual

Part No.: 806-2689-10

Revision A, December 1999

Sun Microsystems, Inc.

Send comments about this document to: [email protected]

Install.book Page 1 Wednesday, December 8, 1999 12:18 PM

Please

Recycle

This product or document is protected by copyright and distributed under licenses restricting its use, copying, distribution, and

decompilation. No part of this product or document may be reproduced in any form by any means without prior written authorization

of Sun and its licensors, if any. Third-party software, including font technology, is copyrighted and licensed from Sun suppliers.

Parts of the product may be derived from Berkeley BSD systems, licensed from the University of California. UNIX is a registered trademark in

the U.S. and other countries, exclusively licensed through X/Open Company, Ltd.

Sun, Sun Microsystems, the Sun logo, AnswerBook, Java, the Java Coffee Cup, Netra and Solaris are trademarks, registered trademarks, or

service marks of Sun Microsystems, Inc. in the U.S. and other countries. All SPARC trademarks are used under license and are trademarks or

registered trademarks of SPARC International, Inc. in the U.S. and other countries. Products bearing SPARC trademarks are based upon an

architecture developed by Sun Microsystems, Inc. Registered Excellence (and Design) is a certiﬁcation mark of Bellcore.

The OPEN LOOK and Sun™ Graphical User Interface was developed by Sun Microsystems, Inc. for its users and licensees. Sun acknowledges

the pioneering efforts of Xerox in researching and developing the concept of visual or graphical user interfaces for the computer industry. Sun

holds a non-exclusive license from Xerox to the Xerox Graphical User Interface, which license also covers Sun’s licensees who implement OPEN

LOOK GUIs and otherwise comply with Sun’s written license agreements.

RESTRICTEDRIGHTS: Use, duplication, or disclosure by the U.S. Government is subject to restrictions of FAR 52.227-14(g)(2)(6/87) and

FAR 52.227-19(6/87), or DFAR 252.227-7015(b)(6/95) and DFAR 227.7202-3(a).

DOCUMENTATION IS PROVIDED “AS IS” AND ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES,

INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-

INFRINGEMENT, ARE DISCLAIMED, EXCEPT TO THE EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID.

Ce produit ou document est protégé par un copyright et distribué avec des licences qui en restreignent l’utilisation, la copie, la distribution, et la

décompilation. Aucune partie de ce produit ou document ne peut être reproduite sous aucune forme, par quelque moyen que ce soit, sans

l’autorisation préalable et écrite de Sun et de ses bailleurs de licence, s’il y en a. Le logiciel détenu par des tiers, et qui comprend la technologie

relative aux polices de caractères, est protégé par un copyright et licencié par des fournisseurs de Sun.

Des parties de ce produit pourront être dérivées des systèmes Berkeley BSD licenciés par l’Université de Californie. UNIX est une marque

déposée aux Etats-Unis et dans d’autres pays et licenciée exclusivement par X/Open Company, Ltd.

Sun, Sun Microsystems, le logo Sun, AnswerBook, Java, le logo Jave Coffee Cup, Netra et Solaris sont des marques de fabrique ou des marques

déposées, ou marques de service, de Sun Microsystems, Inc. aux Etats-Unis et dans d’autres pays. Toutes les marques SPARC sont utilisées sous

licence et sont des marques de fabrique ou des marques déposées de SPARC International, Inc. aux Etats-Unis et dans d’autres pays. Les

produits portant les marques SPARC sont basés sur une architecture développée par Sun Microsystems, Inc.

L’interface d’utilisation graphique OPEN LOOK et Sun™ a été développée par Sun Microsystems, Inc. pour ses utilisateurs et licenciés. Sun

reconnaît les efforts de pionniers de Xerox pour la recherche et le développement du concept des interfaces d’utilisation visuelle ou graphique

pour l’industrie de l’informatique. Sun détient une licence non exclusive de Xerox sur l’interface d’utilisation graphique Xerox, cette licence

couvrant également les licenciés de Sun qui mettent en place l’interface d’utilisation graphique OPEN LOOK et qui en outre se conforment aux

licences écrites de Sun.

CETTE PUBLICATION EST FOURNIE "EN L’ETAT" ET AUCUNE GARANTIE, EXPRESSE OU IMPLICITE, N’EST ACCORDEE, Y

COMPRIS DES GARANTIES CONCERNANT LA VALEUR MARCHANDE, L’APTITUDE DE LA PUBLICATION A REPONDRE A UNE

UTILISATION PARTICULIERE, OU LE FAIT QU’ELLE NE SOIT PAS CONTREFAISANTE DE PRODUIT DE TIERS. CE DENI DE

GARANTIE NE S’APPLIQUERAIT PAS, DANS LA MESURE OU IL SERAIT TENU JURIDIQUEMENT NUL ET NON AVENU.

Install.book Page ii Wednesday, December 8, 1999 12:18 PM

iii

Contents

1. Before Installation 1

Electrical Supply Considerations 1

Environmental Considerations 1

Dimensions 2

Airflow Consideration when Mounting in the Equipment Frame 2

Mechanical Considerations when Mounting in the Equipment Frame 6

Mounting Requirements 6

2. Hardware Installation 11

Unshipping the System 11

Cable Bracket Assemblies 15

Removing and Installing Modules 16

Configuration Limitations 16

Module Injector/Ejector Mechanisms 16

Replacing an RMM 23

Replacing a Disk Chassis 25

Flexible Module Cabling 28

Installing the Filter Trays 29

CAF External I/O Connections 31

System Console Terminal Connections 32

Install.book Page iii Wednesday, December 8, 1999 12:18 PM

iv Netra ft 1800 Hardware Installation Manual • December 1999

Modem Port Connections 33

Alarms Port Connections 34

RCP Port 34

3. Electrical Supply Installation 35

System Switch 35

DC Source Site Requirements 36

Overcurrent Protection Requirements 36

Required Connection Materials 44

DC Supply and Ground Conductor 44

Dual Grounding Environment 45

Connecting the Power Leads 47

4. Powering on the System 51

Index 53

Install.book Page iv Wednesday, December 8, 1999 12:18 PM

Figures

FIGURE 1-1 Netra ft 1800 Airflow Requirements (External) 4

FIGURE 1-2 Netra ft 1800 Airflow Requirements (Internal) 5

FIGURE 1-3 Chassis Mounting Hole Arrangement (all measurements in millimeters) 8

FIGURE 2-1 Shipping Brackets and Sacrificial Plinth 13

FIGURE 2-2 Cable Bracket Assembly 15

FIGURE 2-3 Module Injector/ejector Lever 17

FIGURE 2-4 Removing a CPUset Module 19

FIGURE 2-5 Removing a CAF 20

FIGURE 2-6 Removing a PCI Card Carrier 21

FIGURE 2-7 Removing a Power Supply 22

FIGURE 2-8 Removing an RMM Module 24

FIGURE 2-9 Removing a Disk Drive 26

FIGURE 2-10 Removing a DSK Module 27

FIGURE 2-11 Cable Management Shelf 28

FIGURE 2-12 Large Filter Tray 29

FIGURE 2-13 Small Filter Tray 29

FIGURE 2-14 Inserting the Environmental Filters 30

FIGURE 2-15 External I/O Connections on CAF Module 31

FIGURE 3-1 PSU Fault Situation 37

Install.book Page v Wednesday, December 8, 1999 12:18 PM

vi Netra ft 1800 Hardware Installation Manual • December 1999

FIGURE 3-2 Circuit Breakers for Single Power Rails 39

FIGURE 3-3 Circuit Breakers for Dual Power Rails 40

FIGURE 3-4 Sided Independent Feeds with Single Pole Circuit Breakers 41

FIGURE 3-5 Side-independent Feeds to Each PSU with Single Pole Circuit Breakers (double pole can be

used) 42

FIGURE 3-6 Dual Feeds with Local Common Return – Single Pole Circuit Breakers (double pole can be

used) 43

FIGURE 3-7 Location of Chassis-to-Logic-0V Link and Grounding Points, and Wrist Strap Connection

Point 46

FIGURE 3-8 Power Inlet Connector 47

FIGURE 3-9 Power Connector Wiring Polarity and Securing Screws 48

FIGURE 3-10 Power Lead Receptacles 49

FIGURE 3-11 Power Lead Securing Screws 49

FIGURE 3-12 Power Cable Arrangement for Strain Relief 50

FIGURE 4-1 System Switches (Front Panel) 52

Install.book Page vi Wednesday, December 8, 1999 12:18 PM

vii

Tables

TABLE 1-1 Mounting Hole Pattern Dimensions 7

TABLE 2-1 Console Connector Pinout 32

TABLE 2-2 Console and Modem Port Parameters 32

TABLE 2-3 Modem Port Pinout 33

TABLE 2-4 Alarms Port Pinout 34

TABLE 2-5 Remote Control Processor Port Pinout 34

TABLE 3-1 Overcurrent Protection Requirements 36

Install.book Page vii Wednesday, December 8, 1999 12:18 PM

viii Netra ft 1800 Hardware Installation Manual • December 1999

Install.book Page viii Wednesday, December 8, 1999 12:18 PM

Preface

This document describes the installation procedures for the core hardware used in

the Netra™ft 1800.

Who Should Use This Book

This guide is intended to be read by installation engineers and service personnel. It

is not intended for the end user of the system.

How This Book Is Organized

This guide is arranged as follows:

Chapter 1 “Before Installation” gives guidelines on site preparation and

environmental considerations.

Chapter 2 “Hardware Installation” describes how to unpack the system and install

the chassis in a rack.

Chapter 3 “Electrical Supply Installation” provides the information required to

install the electrical supply.

Chapter 4 “Powering on the System” tells you how apply power to the Netra ft 1800.

Install.book Page ix Wednesday, December 8, 1999 12:18 PM

xNetra ft 1800 Hardware Installation Manual • December 1999

Related Books

■Netra ft 1800 Hardware Reference Manual (Part No. 805-4531-11)

■Netra ft 1800 Safety and Compliance Manual (Part No. 805-7019-10)

Symbols

The following symbols mean:

Note – A note provides information which should be considered by the reader.

Caution – Cautions accompanied by this Attention icon carry information about

procedures or events which if not considered may cause damage to the data or

hardware of your system.

Caution – Cautions accompanied by this Hazard icon carry information about

procedures which must be followed to reduce the risk of electric shock and danger

to personal health. Follow all instructions carefully.

Sun Welcomes Your Comments

We are interested in improving our documentation and welcome your comments

and suggestions. You can email your comments to us at:

[email protected]

Please include the part number of your document in the subject line of your email.

Install.book Page x Wednesday, December 8, 1999 12:18 PM

Andere Handbücher für Netra ft 1800

Inhaltsverzeichnis

Andere Sun Microsystems Industrieanlagen Handbücher

Sun Microsystems

Sun Microsystems Sun StorageTek SL24 Handbuch

Beliebte Industrieanlagen Handbücher anderer Marken

ABB

ABB Unifix AD Handbuch

Mark 7

Mark 7 Evolution Bedienungsanleitung

Husky

Husky HyPET Bedienungsanleitung

bora

bora PM-1800 Bedienungsanleitung

Grizzly

Grizzly T32428 Bedienungsanleitung

Siemens

Siemens 8MF1 Series Bedienungsanleitung

ABB

ABB HT610965 Bedienungsanleitung

ABB

ABB SafeLink Bedienungsanleitung

Phoenix

Phoenix PHX-150 Bedienungsanleitung

ABB

ABB A165-L32 Bedienungsanleitung

ABB

ABB HT842936 Bedienungsanleitung

Rioned

Rioned UrbanJet Bedienungsanleitung

Hermetica

Hermetica 10 Series Bedienungsanleitung

HORNER

HORNER OEE Solution Bedienungsanleitung

Hammerhead

Hammerhead HG375 Bedienungsanleitung

SCHUNK

SCHUNK VERO-S NSE-A3 138 Gebrauchsanweisung

ABB

ABB HT566657 Bedienungsanleitung

Webasto

Webasto GSE CAN Bedienungsanleitung