Sun Microsystems DLT4700 Bedienungsanleitung

Installation

9. Turn on the power to the peripherals and then to the workstation.

5. Set the SCSI address switch to the correct SCSI address.

7. Turn off the power to the workstation and the peripherals.

8. Connect the cables.

See the “Cable Connections” section.

4. Determine the SCSI address

(target ID) for the tape drive.

3. Shut down the operating system.

11. See Chapter 5 of the Quantum Tape Mini-Library Product Manual

for more information.

6. Set the voltage select switch to the correct voltage.

The auto-loader is set for 220V operation. If you are using 110V, you

must change the select switch. See the illustration on the next page.

1. Make sure that total length for each SCSI bus (including internal

cable lengths) is less than 6 meters (20 feet).

The internal SCSI cable length for this auto-loader is 0.35 meters

(14 inches).

Solaris Handbook for

SMCC Peripherals

Solaris AnswerBook™

on-line documentation

10. Conﬁgure the system.

Remember to reboot your system using boot -r

2. For Solaris™2.4, 2.5, and 2.5.1 operating systems, add the

following to the /kernel/drv/st.conf ﬁle.

(Note - There must be ﬁve spaces between “SUN” and “DLT”.)

tape-config-list=

“SUN DLT4700”, “Quantum DLT 4700 Mini-Library”, “QDLT”;

QDLT =1,0x36,0,0xD639,4,0x80,0x81,0x82,0x83,2;

Operation

Read the Quantum CompacTape Handling and Storage Guidelines, this guide, and

chapters 1, 2, and 5 of the Quantum Tape Mini-Library Product Manual, before

operating the auto-loader.

Note – Many of the illustrations and procedures in the Quantum Tape Mini-

Library Product Manual do not apply to the SPARCstorage 4700 Tape Auto-

loader. The illustrations and procedures in this guide take precedence over the

Quantum documentation.

System Diagnostic Support

SunVTSand SunVTS_PROsupport for Solaris 2.5.1 and prior operating

systems is available by applying patch-id number 103097-01 to your system.

Use your normal service channels to obtain this patch. This auto-loader is not

supported by SunDiag.

SCSI connectors SCSI address

switch

Power switch

Voltage select switch

Power connector

Density Speciﬁers

Density speciﬁers override the front-panel settings. Refer to the st man pages

for more information.

Software Commands

Brief descriptions of some commonly used software commands are in the

following table. Refer to the Solaris Handbook for SMCC Peripherals, man pages

or AnswerBook on-line documentation for more information.

Density

speciﬁers Cartridge Types and Capacities

CompacTape IV CompacTape IIIxt CompacTape III

l, h 20 Gbytes 15 Gbytes 10 Gbytes

m, c 40 Gbytes130 Gbytes120 Gbytes1

1Assumes a typical compression ratio of 2:1. The compression ratio will vary depending

upon the type of data being compressed.

Command Description

ufsdump Creates incremental or full backups. The -l option is used to

sequence tape cartridges for large back ups.

ufsrestore Retrieves data backed up using ufsdump

tar Creates tape archives and adds or extracts ﬁles

mt Sends commands to magnetic tape devices

st Acts as a device driver and interface to SCSI tape devices

tapetool OpenWindows™ tool that reads ﬁles from tape or archives ﬁles to tape

cpio Copies ﬁle archives in and out

The Network Is the Computer™

Sun Microsystems Computer Company

Tape Cartridge

Follow the guidelines in the Quantum CompacTape Handling and Storage

Guidelines.

In addition:

•Use only the labels that were supplied with the cartridge. The use of other

labels may cause the cartridge to jam in the tape drive.

•Do not move a SPARCstorage DLT 4700 tape auto-loader with cartridges

installed. Doing so can damage the auto-loader and the cartridges.

Cleaning

In normal operating conditions, this drive does not require periodic cleaning.

When cleaning is required, the front-panel “Use Cleaning Tape” LED will light.

Use a CleaningTape III or equivalent cleaning cartridge. Follow the instructions

included with the cartridge.

Cable Connections

This auto-loader was shipped with one 50-50 pin and one 50-68 pin SCSI cable.

If you are connecting the auto-loader with wide-SCSI devices (68 pin), then the

tape drive should go at the end of the chain.

If you are connecting the auto-loader with other narrow-SCSI devices (50 pin),

then placement is up to you.

Note – A SCSI terminator must be used if the last device in the chain does not

have automatic SCSI termination.

Ordering Sun Documents

The SunDocs Order Desk is a distribution center for Sun Microsystems

technical documentation. It accepts all major credit cards and company

purchase orders. You can order documentation in the following ways:

Reader Comments

Your comments and suggestions are important to us. Please let us know what

you think about the SPARCstorage 140-280 Gbyte DLT 4700 Auto-Loader

Installation and User’s Guide, part number 802-5688-10.

You can send detailed comments through email to [email protected] or a fax

to SMCC Document Feedback at 1-415-786-6443.

In the U.S.A. Outside the U.S.A.

Fax 1-801-373-6798 Fax 1-801-373-6798

Call 1-800-247-0250 Call 1-801-342-3450

World Wide Web: http://www.sun.com/sundocs/catalog.html

1996 Sun Microsystems, Inc., 2550 Garcia Avenue, Mountain View, California 94043-1100 U.S.A.

Inc. in the United States and other countries. All SPARC trademarks, including the SCD Compliant logo, are trademarks or registered

trademarks of SPARC International, Inc. in the United States and other countries. SPARCstation is licensed exclusively to Sun

Microsystems, Inc. Products bearing SPARC trademark are based upon an architecture developed by Sun Microsystems, Inc.

THIS PUBLICATION IS PROVIDED “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED,

INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR

PURPOSE, OR NON-INFRINGEMENT.

1996 Sun Microsystems, Inc., 2550 Garcia Avenue, Mountain View, Californie 9043-1100 U.S.A.

Inc. aux Etats-Unis et dans certains d’autres pays. Toutes les marques SPARC, y compris le logo SCD Compliant, sont des marques

déposées ou enregistrées de SPARC International, Inc. aux Etats-Unis et dans d’autres pays. SPARCstation est exclusivement licenciée

à Sun Microsystems, Inc. Les produits portant la marque SPARC sont basés sur une architecture développée par Sun Microsystems,

Inc.

CETTE PUBLICATION EST FOURNIE "EN L’ETAT" SANS GARANTIE D’AUCUNE SORTE, NI EXPRESSE NI IMPLICITE, Y

COMPRIS, ET SANS QUE CETTE LISTE NE SOIT LIMITATIVE, DES GARANTIES CONCERNANT LA VALEUR MARCHANDE,

L’APTITUDE DES PRODUITS A REPONDRE A UNE UTILISATION PARTICULIERE OU LE FAIT QU’ILS NE SOIENT PAS

CONTREFAISANTS DE PRODUITS DE TIERS.

Part No.: 802-5688-10 Revision A January 1996

140-280GbyteSPARCstorage

™

DLT4700Auto-Loader

InstallationandUser’sGuide

Andere Sun Microsystems Lagerung Handbücher

Sun Microsystems

Sun Microsystems storedge L25 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Storage J4400 Stücklistenhandbuch

Sun Microsystems

Sun Microsystems StorageTek 9985V Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorEdge N8200 Installations- und Betriebshandbuch

Sun Microsystems

Sun Microsystems Sun StorEdge D240 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Enterprise Tape Library 4/1000 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorEdge T3+ Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Blade 100 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Storage J4200 Stücklistenhandbuch

Sun Microsystems

Sun Microsystems Sun StorageTek 5800 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorageTek SL48 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorEdge Series Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun StorageTek SL24 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorageTek L40 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorEdge N8400 Installations- und Betriebshandbuch

Sun Microsystems

Sun Microsystems StorageTek 2500 Series Anleitung zur Verwendung

Sun Microsystems

Sun Microsystems Enterprise Tape Library 7/3500 Kurzanleitung

Sun Microsystems

Sun Microsystems StorageTek T9840 Montageanleitung

Sun Microsystems

Sun Microsystems SPARCstorage Library Bedienungsanleitung

Sun Microsystems

Sun Microsystems Sun Enterprise 10000 Bedienungsanleitung

Sun Microsystems

Sun Microsystems ZFS Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorageTek SL500 Bedienungsanleitung

Sun Microsystems

Sun Microsystems StorEdge 6120 Bedienungsanleitung

Sun Microsystems

Sun Microsystems Blade 6000 Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

HP P9000 Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung