4DimGate DIN DMX AC dimmer with four additional 0-10V/1-10V outputs
Operation
DimGate DIN devices start their normal operation in a few seconds after they have been powered up.
Output channels operate according to values receiving from DMX512 port. AC channel 1 corresponds
to DMX start address set by DIP switcher, AC channel 3- to start address+3. 1-10V channel 1 corresponds
to start address+4, 1-10V channel 4- to start address+7. When AC dimmer mode selected, actual level on
AC outputs changes proportionally to DMX value. When AC switcher mode selected, AC channels just
switch the load ON and OFF, DMX value 0-127 switches the load OFF, DMX value 128-255 switches
the load ON.
LED indicator shows the status of input DMX512 signal. If indicator is red, no DMX512 signal detected
on input. If indicator is green, valid DMX512 signal is received. The indicator blinks on change DMX
values controlling device’s outputs.
RDM
Device supports DMX address assignment and dimmer/switcher function changing via RDM.
To select RDM address assignment mode, set all DIP-switcher sections to OFF. In other cases the actual
DMX address will be indicated in RDM parameters anyway.
AC dimmer and AC switcher functions can be selected via RDM by choosing corresponding
“device personality”.
Advantages
Dim AC lines and 1-10V/0-10V lines from one device
Independent phase inputs for dimmable 230V channels
Active analogue 1-10V/0-10V outputs, capable to connect up to 100 drivers/ballasts
Maximum surge protection – power supply optimized for voltage from 100 to 315 V
AC switcher mode
Full galvanic isolation of all ports (except 1-10V)
Warning!
Before mounting and turning
on the power,you need to make
sure protective ground cable
connections and places of their
connection
Installation
1. Ensure the device has no damage caused by transportation
2. Install the device on DIN-rail
3. Connect power supply according to connection scheme
4. Connect DMX512, AC dimming lines, 1-10 outputs according
to connection scheme
5. Connect the grounding circuit to the grounding clamp terminal
6. Set DMX start address on DIP switcher section 1-9. DMX start address is set as binary code where section
1 refers to LSB and section 9- to MSB, ON position- to binary «1», OFF position- to binary «0». Valid address
range from 1 to 504
7. Select the necessary AC channels mode by DIP switcher section 10. Set section 10 to OFF to select
AC dimmer function. Set section 10 to ON to select AC switcher function
8. Apply a MAINS voltage to the terminal «~230V»
