SUNITECENTERPRISECO.,LTD www.sunitec.com
complete pairing. (Pairing procedure might be varied because of different phones. Users are recommended
to refer to individual User's Manual.) Mean while, this unit is under connection mode - green LED blinks once
every 4 seconds.
(d) To remove pairing, constantly press function key for 4 seconds until both green & red LEDs are off. Mean
while, a short beep comes up.
(C) To Use Headset:
Once pairing is successful, this unit is automatically under connection to phone mode - green LED blinks once
every 4 seconds. All calls will be through headset. Please locate this unit within 10 meters (max.) to phones.
Please be reminded if connection is removed, re-connection to headset is needed.
(a) Headset initiates connection to phones:
Under stand-by mode, short press on function key, up & down, will cause headset initiating connection to
phones. In the mean time, the phone screen will show "Connect with Earpiece?". Please press "Accept" to
accept connection. Please press "Reject" to refuse connection.
Note:Please be reminded if headset is power off, connection to phone will be off. If headset is powered on
again, headset will connect to the phone automatically. Mean while the phone screen will indicate "Connect
with Earpiece?". Please press "Accept" to accept connection.
(b) Phones initiates connection to headset:
Please refer to individual phone operation manual. For example: NKI 8910, procedures is
"Menu/Bluetooth/View paired devices/Earpiece/ Establish Bluetooth connection". After completion of
connection, phone mode is under headset communication mode.
OPERATION:
(a) To Answer a Call:
When a call is in, a ringing tone will come out of this unit. Press function key, up & down, to answer a call.
(User may press phone key to answer, too.) Once it's under talking status, green LED blinks twice every 1.5
seconds.
(b) Not to Answer a Call:
When a call is in, a ringing tone will come out of this unit. If user doesn't intend to answer this call, constantly
press function key, up & down, for 3 seconds until ringing tone is off.
(c) Dialing out:
After pairing is done, user may dial out numbers through phones and talk through this unit. During
conversation, green LED blinks once every 1.5 seconds.
(d) Volume Adjustment:
Simply adjust the function key, left & right, to adjust volume.
(e) Voice Activation:
For example: NKI 8910, to voice dialing, under connection mode, constant press the "Names" button and LCD
will show "Speak Now".User may talk to mic. of this unit for voice dialing. If it's successful, green LED stays
blinking once every 1.5 seconds. Users are recommended to refer to voice dialing procedure of individual
phone.
(f) To Disconnect Bluetooth connection between phones headset:
After completion of pairing, this unit is automatically under Bluetooth connection to phones. To remove
connection, please operate disconnection through the pre-connected phone. Procedure is "Menu/
Bluetooth/View active device/Select/ Earpiece / Disconnection".) Mean while, this unit will resume stand-by
mode and ready for connection again.
(E) LED Indication (Single LED, Bi-Colored.)
Status LED Indication
