Sunjoy L-GZ428PST Bedienungsanleitung

ASSEMBLY INSTRUCTIONS

ITEM#L-GZ428PST

20’ x 20’ PARTY PAVILION

Our clear, easy-to-follow, step-by-step instructions will guide you through the project from start to finish. The

final product will be a quality piece that will go together smoothly and give years of enjoyment.

WARNINGS:

1. Assembly Instructions must be followed.

2. Carefully consider the possibility of falling rocks or tree limbs, lightning strikes, flash floods, avalanches,

strong winds, and other objective hazards to reduce the risk of injury to the occupants, or damage to the

canopy.

3. Anchor your canopy properly at all times to reduce the risk of injury to the occupants, or damage to the tent.

This includes staking out all guy lines, and securing the canopy top to the center pole by staking down and

adjusting the center peak rope.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with

any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant

properties ineffective.

Tools required: hammer (not included)

Parts List:

No Parts Qty Image

A Tow-piece Pole 8

B Four-piece Center Pole 1

C Base Plate 1

D Canopy 1

E 15”stake 14

F 9”stake 17

Assembly Instructions:

Remove canopy from the bag, unroll it and lay it out flat on level ground.

Step 1: Assemble the ten two-piece corner and side poles, connect the two four-piece center poles and base

plates as Fig.1.

4＇

4＇ 4＇ 4＇

4＇

Stake Canopy Here

Canopy Rolled Out

Pole at 45 Degree Angles

Mesh

Step 2: Starting at one of the canopy corners, measure out approximately 4 ft. at a right angle and drive a 15”

stake into the ground at a 45-degrees (as Fig.2) with the hook portion of the stake facing away from the canopy

(as Fig.5). Pull the loop of the stake-out webbing and loosely wrap the webbing around the stake. This should

be done on each of the two straps of the canopy corner. Go to the remaining corners and repeat the process.

Locate the webbing straps between two corners on the sides and ends of the canopy. Drive a stake at a right

angle to the canopy in the same manner as above, and loosely wrap the loop of the stake out webbing around

the stake. Repeat the process on every side.

Step 3: Slide a two-piece corner pole underneath the canopy and mesh walls with the top of the pole angled

toward you. Place the tip through the grommet located on the eave corner, being sure that the tip of the pole

goes through the grommet and the metal ring where the webbing attaches (as Fig.3). Lift the pole to a

45-degree angle or until the stake-out points at the opposite corner won’t allow you to raise it any further (as

Fig.4).

Canopy Top

Pole Through Grommet and Matal Ring

Upright Canopy Before Center Pole

Mesh

Step 4: Go to the bottom of the stake-out webbing, which should be looped over the hook part of the stake,

and adjust the tension of the stake by pulling the free end of the stake-out webbing (as Fig.5). (Below the

ladder lock buckle, towards the ground. Do not over tighten. You want to have the canopy tension just enough

to support the poles.) Go to the remaining corners and repeat steps 3 and 4. It is important to make sure all of

the door zips are fully closed at this point.

Step 5: Go to each corner pole and raise the pole into an upright position, erecting all side walls (as Fig.6).

Once each corner pole is upright, enter the canopy through one of the zippered doors and place the tip of one

of the assembled side poles through the grommet on the eave of canopy top between each corner pole, being

sure that the tip goes through grommet and the metal ring where the stake-out webbings attaches (as fig.3).

Stand the sidewall upright, and adjust the tension of the stake-out webbing as described in step 4. Repeat the

process for all pole positions along the remaining sidewalls and ends.

45°

Ground

Ladder Lock Adjuster Stake(Shown with Web Strap)

Erected Canopy

Mesh

Step 6: Re-enter the canopy through one of the zippered doors. Place the tip of the four-piece center poles

through the grommet in the top of the canopy and push the pole upward to an erect position (as Fig.7). If the

center pole will not stand at an erect position, loosen all of the corner staked-out webbings slightly and retry.

Tighten all corner stake-out webbings after the center poles have been erected. Drive two 15” stakes into the

center pole base plates and attach the center peak ropes to one of the stakes using the loop (as Fig.8). Use

the guy-line tensioner to tighten the top of the canopy to the center poles (as Fig.9). This is very important to

keep the canopy top in contact with the center poles during high winds. The 9” stakes can secure the screened

walls using the dual loops at the base of the zipper on each screen. You can also roll up the screens and attach

them securely inside the canopy eaves with the attached toggles.

Once canopy is fully erect, retighten all staked out web straps at every corner, and side pole and

tighten the center peak ropes with the guy-line tensioner.

Taking Down Your Canopy:

1. Roll up and secure all the screened walls with the toggles on the inside of canopy eaves. This will make it

easier to raise the canopy next time.

2. Remove the stake holding the center peak ropes and center pole base plates.

3. Remove the center poles, then each side and corner pole.

4. Remove the stakes.

5. Place all poles and stakes into their individual bags.

6. Fold the canopy so the width is equal to the length of the carry bag.

7. Place the pole bag at one end of the folded canopy and using the poles as a core, roll the canopy and

place it inside the bag. Also place the stake bag inside the carry bag.

Made in China

Center Pole Base Plates 9

Guy Line Tensioner

Inhaltsverzeichnis

Andere Sunjoy Zelt Handbücher

Sunjoy

Sunjoy SummerCove A101015301 Bedienungsanleitung

Sunjoy

Sunjoy 110211019-K Bedienungsanleitung

Sunjoy

Sunjoy SummerCove A101013004 Bedienungsanleitung

Sunjoy

Sunjoy Verano L-PG108PST-B Bedienungsanleitung

Sunjoy

Sunjoy A101011500 Bedienungsanleitung

Sunjoy

Sunjoy L-GZ815PST-1-PK Bedienungsanleitung

Sunjoy

Sunjoy D-GZ942PST Bedienungsanleitung

Sunjoy

Sunjoy L-GZ605PST-A4 Bedienungsanleitung

Sunjoy

Sunjoy A101012200 Bedienungsanleitung

Sunjoy

Sunjoy L-GZ761PST Bedienungsanleitung

Sunjoy

Sunjoy A101012602 Bedienungsanleitung

Sunjoy

Sunjoy L-GZ717PST-C-PK Bedienungsanleitung

Sunjoy

Sunjoy 10'x12' Bay Window Gazebo Bedienungsanleitung

Sunjoy

Sunjoy BIRMINGHAM L-GZ340PST-3D-E Bedienungsanleitung

Sunjoy

Sunjoy S-GZ001 Bedienungsanleitung

Sunjoy

Sunjoy D-GZ399PST-H Bedienungsanleitung

Sunjoy

Sunjoy L-AW001-R Bedienungsanleitung

Sunjoy

Sunjoy S-AW011-R Bedienungsanleitung

Sunjoy

Sunjoy L-GZ120PST-2 Bedienungsanleitung

Sunjoy

Sunjoy L-GZ1033PST Bedienungsanleitung

Sunjoy

Sunjoy 110211017-K Bedienungsanleitung

Sunjoy

Sunjoy A106005500 Bedienungsanleitung

Sunjoy

Sunjoy L-GZ098PST Bedienungsanleitung

Sunjoy

Sunjoy A101011000 Bedienungsanleitung

Beliebte Zelt Handbücher anderer Marken

OZTENT

OZTENT JV SIGNATURE EDITION Bedienungsanleitung

GigaTent

GigaTent Summer Chalet Mini Tent Bedienungsanleitung

ShelterLogic

ShelterLogic 107153 Bedienungsanleitung

Outsunny

Outsunny 84C-230 Bedienungsanleitung

Napier

Napier SPORTZ COVE 61 Series Bedienungsanleitung

EuroTrail

EuroTrail ATLANTIS PRO Bedienungsanleitung

Reimo

Reimo Marina Bedienungsanleitung

TiiTENT

TiiTENT TB300 Bedienungsanleitung

Coleman

Coleman 2000033134 Installationsanleitung

Ozark Trail

Ozark Trail W784.1 Kurzanleitung

SlingFin

SlingFin CrossBow 2 Bedienungsanleitung

Coleman

Coleman 9600-141 Bedienungsanleitung

Palram

Palram Arizona 5000 Wave - WINGS Bedienungsanleitung

COVERPRO

COVERPRO 56184 Montageanleitung

Vango

Vango Zenith 100 Bedienungsanleitung

Costway

Costway PATIOJOY OP70818 Bedienungsanleitung

Clarke

Clarke PUC 88 Bedienungsanleitung

Coleman

Coleman MONTANA 14'x7' Bedienungsanleitung