Long press the power button until the
power indicator light flashes to blue . After
15 seconds, the “beep” sound comes out.
The drone is switched on successfully.
Long press the power button until
the power indicator light goes out.
The drone turns off.
A、Swith on/off The Drone
B、Ready to Fly
Launch the App, click “Enter Device“ button,
follow the instructions into settings and
connect Wi-Fi between the mobile device and
the drone, then back to the homepage of App
and enter control interface.
C、Compass Calibration
The drone is already calibrated in factory, Before the first flight, suggest to calibrate the
compass again; otherwise the drone may not work properly and affect flight safety.
Frequent calibration of the compass can improve the reliability of drone.
6、Fly
Take Off
Click on the "Take Off" button at the buttom of the screen, slide to the right end,
the drone will take off and rise to 0.6m altitude and hover.
Landing
During the flight, click on the "Landing" button and slide to the right end. The
drone will land in the place.
Return
During the flight in GPS mode，click the "Return" button, slide to the right end,
the drone will return to the point of departure.
Propellers Forced to Stop
During the flight, such as in an emergency, you can click on the “Propellers Forced
to Stop” button, the drone will force the propeller to stop working. With a certain
risk and destructive, please use caution.
In the implementation of take off or landing or return operation, if the button does not slide to the end,
the slider will be automatically hidden, the corresponding operation will be not executed.
The returning drone will rise to the defaut return altitude of SUNLY FLY App (default return altitude is
10meters), please ensure no obstacle in returning route.
Default SSID: AlphaCAM-XXXX, password: sunlytech, it can be changed in Settings.
You can reset the password by click the power button 5 times after the drone is turnd on.
How to calibrate: Select "Calibration - Compass Calibration" in Settings of the upper right corner of the
flight interface, you can start to calibrate referring to the prompts.
The default Wi-Fi Frequency is 5.8GHz. You can swith it to 2.4 GHz by clicking the power button 3times
after the drone is turnd on.
4
