SupaWarm SOFR9D Bedienungsanleitung

This manual is to be used with the following SupaWarm radiator:

SOFR9D

IMPORTANT:

Read these instructions before use. Please retain for future reference.

2000 Watt

Oil Filled Radiator

with Thermostatic Control

CORRECT DISPOSAL OF THIS PRODUCT

Please read these instructions fully before use.

WARNING! This appliance must be earthed.

DO NOT TURN HEATER UPSIDE-DOWN DURING OPERATION.

IMPORTANT INFORMATION

FOR CORRECT DISPOSAL OF THE

PRODUCT IN ACCORDANCE WITH

EC DIRECTIVE 2002

EC.

At the end of its working life,

the product must not be disposed

of as urban waste. It must be

taken to a special local authority

differentiated waste collection centre

or to a dealer providing this service.

Disposing of a household appliance

separately avoids possible negative

consequences for the environment

and health, avoiding inappropriate

disposal enables the constituent

materials to be recovered to obtain

significant savings in energy and

resources. As a reminder of the need

to dispose of household appliances

separately, the product is marked

with a crossed-out wheeled dustbin.

This marking indicates that this product

should not be disposed with other

household wastes throughout the EU.

To prevent possible harm to the

environment or human health from

uncontrolled waste disposal, recycle it

responsibly to promote the sustainable

reuse of material resources. To return

your used device, please use the return

and collection systems or contact the

retailer where the product was

purchased. They can take this product for

environmental safe recycling

When using an electrical appliance, basic safety precautions

should always be observed, as explained in this manual.

PLEASE READ ALL INSTRUCTIONS CAREFULLY

BEFORE USING THE PRODUCT.

WARNING: To reduce the risk of fire, electrical shock,

or injury to person or property:

This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have

been given supervision or instruction concerning use of the

appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play

with the appliance.

The product is for household use only.

Connect the appliance to single-phase AC supply of the voltage

specified on the rating plate.

In order to avoid overheating, do not cover the heater.

leave the heater unattended while it is in use. Always

turn the product to the OFF position and unplug it from the

electrical outlet when not in use.

The heater must not be located immediately below an electrical

socket-outlet.

run cord under carpeting and do not cover cord

with rugs, runners or alike. Arrange the power cord away

from areas where people walk and where it will not

be tripped over.

operate the heater with a damaged cord or plug,

or after the heater malfunctions, has been dropped, or

damaged in any way.

If the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualified

person to avoid a hazard.

Avoid the use of an extension cord as this may overheat

and cause a risk of fire.

Use the heater in a well-ventilated area. Do not insert or

allow objects to enter any ventilation or exhaust opening.

Do not use on soft surfaces, like a bed, where openings may

become blocked.

Only use the heater on flat, dry surfaces.

use the heater on items of furniture or fitting where

the heater could fall off during use or where the heater

openings may become blocked.

place this heater near flammable materials, surfaces

or substances, as there may be a risk of fire. Keep the above

flammable materials, surfaces or substances at least 1mtr

from the front of the product and keep them away from the

sides and rear of the heater.

use the heater in any areas where petrol, paint or other

flammable liquids are stored e.g. Garages or workshop where

there is risk of hot sparks falling onto the heater.

use this heater in the immediate surroundings

of a bath, a shower or a swimming pool.

locate the heater where it may fall into a bathtub

or other water container.

This heater is hot when in use. To avoid burns and personal

injury, do not let bare skin touch hot surfaces. If provided,

use handles when moving the product.

Be sure that no other appliances are in use on the same

electrical socket as your product as an overload can occur.

This heater is filled with a precise quantity of special oil.

Repair requiring opening of the o



container is only to be

made by a service agent who must be contacted if there is

an oil leakage.

Regulations concerning the disposal of oil when scrapping

the appliance have to be followed.

The heater should not be used in a room, of which the floor

area is less than 5m

The cord shouldn

t be placed nearby the hot surface of the

appliance.

When scrapping the heater, follow the regulations

concerning the disposal of oil.

Children of less than 3 years should be kept away unless

continuously supervised.

Children aged from 3 years and less than 8 years shall only

switch on/off the appliance provided that it has been placed

or installed in its intended operating position and they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

Children aged from 3 years and less than 8 years shall not

plug in, regulate and clean the appliance or perform user

maintenance.

Some parts of this product can become very hot

and cause burns. Particular attention has to be given where

children and vulnerable people are present.

It is normal when the heaters are turned on

for the first time or when they are turned on after having not

been used for a long period of time the heaters may have

noise inside. This will disappear when the heater has been

on a short while.

Always remove the plug from the socket-outlet and allow

the radiator to cool down before cleaning the heater.

Wipe radiator with a soft damp (not wet) cloth.

To store away the heater, wind the cable around the bobbin

and store the heater in a clean dry place.

In case of malfunction or doubt, do not try to repair the

radiator yourself, it may result in a fire hazard or electric shock.

Do not immerse the heater in water.

Do not use any cleaning chemicals such as detergents

and abrasives.

Do not allow the interior to get wet as this could create

a hazard.

DO NOT OPERATE HEATER IF ANY OF THE

FINS ARE DENTED, DAMAGED OR BROKEN

The heater is packaged with the feet unattached.

You must attach them before operating the heater.

WARNING! Do not operate without feet attached. Do operate

the heater only in upright position (feet on the bottom, controls

on the top), any other position could create a ha

ardous situation.

Ensure the power cord is not plugged in before

attempting to assemble the heater.

The only assembly required for the oil heaters are attaching

the wheels onto the main unit. Follow these procedures:

Place the radiator body upside-down on a scratch-free

location, make sure it is stable and will not fall.

Screw off the wing nuts from the U-shaped bolt provided,

attach the U-shaped bolt to the U-facing flange between

first and second fins (near the front cover).

To attach the castor mounting plate to the radiator body,

you should insert the threaded ends of the U bolt in the

holes on the castor mounting plate.

Screw the wing nuts back to the U bolt and fasten the wing

nut properly.

PLEASE NOTE: Do not over tighten, which may cause the

damage of radiator flange.

Screw off spherical nut from the castor, align the shaft to

the hole of the castor mounting plate, insert in, and screw

on the spherical nut.

Repeat 2, 3, 4 and 5 on the rear of radiator for mounting

of the rear castors.

PLEASE NOTE: The rear cast

rs must be m

unted between

the end tw

fins.

Before using the heater, make sure that it is on a flat and

stable surface. Damage may occur if it is placed on an incline

or decline. Place the heater on the floor at least 90cm away

from the wall and any other flammable objects such as

furniture, curtains or plants. (Make sure the power supply

used corresponds to the one on the rating label).

With the thermostat control switch and the power setting

switches in the OFF position, plug the heater into the main

power supply.

Rotate the thermostat knob clockwise to MAX position

and switch the heater on as follows;

Switch to ‘l

for low heat

Switch to ‘II

for medium heat

Switch on both for high heat

When your room reaches the desired temperature, now

slowly rotate the thermostat knob counter clockwise until

the pilot light goes out. The thermostat can now be left at

this setting. As soon as the room temperature has dropped

below the set temperature, the unit will switch itself on

automatically until the set temperature has been reached

again. In this way the room temperature remains constant

with the most economical use of electricity.

If you want to change the room temperature setting, rotate

the thermostat knob clockwise to raise the temperature,

or counter clockwise to lower it.

This heater includes an overheat protection system that

shuts off the heater when parts of the heater are getting

excessively hot.

To completely shut the heater off, turn all the controls

to OFF, and remove the plug from the socket-outlet.

Inhaltsverzeichnis

Andere SupaWarm Heizung Handbücher

SupaWarm

SupaWarm SHHD1200A Bedienungsanleitung

SupaWarm

SupaWarm SFH10 Bedienungsanleitung

SupaWarm

SupaWarm SMHH1 Bedienungsanleitung

SupaWarm

SupaWarm SFH15 Bedienungsanleitung

SupaWarm

SupaWarm SHH1200C Bedienungsanleitung

SupaWarm

SupaWarm SOFR11D Bedienungsanleitung

SupaWarm

SupaWarm SCH2000T Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

IRSAP

IRSAP The Radiator Company Ovali Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung