Superb MASON 12V20Ah Bedienungsanleitung
Manual
MASON 12V20Ah | 12V25Ah
Version
March 2022
2
User Manual Mason 12V20Ah | 12V25Ah
This manual contains all the information necessary to install, use and maintain the Li-ion
battery. We kindly ask you to read this manual carefully before using the product. In this
manual, the Super B Mason 12V20Ah / 12V25Ah Li-ion power battery will be referred to as
the Li-ion battery. This manual is meant for the installer and the user of the Li-ion battery.
Only qualied and/or certied personnel may install and perform maintenance on the Li-ion
battery. Please consult the index at the start of this manual to locate information relevant to
you.
During the use of the Li-ion battery, user safety should always be ensured, so installers,
users, service personnel and third parties can safely use the Li-ion battery.
Copyright© Super B All rights reserved. Licensed software products are owned by Super B
or its subsidiaries or suppliers, and are protected by national copyright laws and international
treaty provisions. Super B products are covered by Dutch and foreign patents, issued and
pending. Information in this publication supersedes that in all previously published material.
Specications and price change privileges reserved. Super B is a registered trademark of
Super B.
For more information please contact:
Super B Lithium Power B.V.
Europalaan 202
7559 SC Hengelo (Ov)
The Netherlands
Tel: +31(0)88 00 76 000
E-mail: info@super-b.com
www: www.super-b.com
3
Be in charge. Super B.
Table of content
1. Safety guidelines and measures 5
1.1. General 5
1.2. Disposal 5
1.3. Safety symbols and markings on product 6
2. Introduction 7
2.1. Product description 7
2.2. Intented use 7
2.3. Glossary of Terminology 7
2.4. Used symbols 8
3. Product specifications 8
3.1. Technical specications 8
3.1.1. Electrical specications 8
3.1.2. Mechanical specications 8
3.1.3. Charge and discharge specications 9
3.1.4. Temperature specications 9
3.1.5. Compliance specications 9
3.1.6. General product specications 9
3.2. Environmental conditions 10
3.3. Required tools 10
3.4. Scope of delivery 10
3.5. Connections 11
3.6. Optional Components 11
3.7. Protection tresholds 11
4. Installation 12
4.1. General information 12
4.2. Unpacking 12
4.3. Preparing the Li-ion battery for use 12
4.3.1. Placement of the Li-ion battery 13
4.3.2. Connection wires 13
4.3.3. Connecting a charger or load to the Li-ion battery 13
4.4. Disconnecting a Li-ion battery 14
5. Battery use 14
5.1. General information 14
5.2. Charging 14
5.2.1. Charging rate 15
6. Inspection and cleaning 15
6.1. General information 15
6.2. Inspection 15
4
6.3. Cleaning 16
7. Storage 16
8. Transportation 16
9. Disposal and recycling 16
10. Troubleshooting 17
11. Warranty and liability 18
5
Be in charge. Super B.
1. Safety guidelines and measures
1.1. General
• Do not short-circuit the Li-ion battery.
• Treat the Li-ion battery as described in this manual.
• Do not dismantle, crush, puncture, open or shred the Li-ion battery.
• Do not expose the Li-ion battery to heat or re. Avoid exposure to direct sunlight.
• Do not remove the Li-ion battery from its original packaging until required for use.
• In the event of electrolyte leaking, do not allow the liquid to come in contact with the skin or
eyes. If contact has been made, wash the affected area with water and seek medical advice.
• Always use a class 2 charger which is specically provided for use with a Lithium Iron
Phosphate battery (LiFePO4).
• Observe the plus (+) and minus (–) marks on the Li-ion battery and equipment and ensure
correct use.
• Do not mix batteries of different manufacture, capacity, size or type.
• Keep the Li-ion battery clean and dry.
• Secondary batteries need to be charged before use. Always use the correct charger and
refer this manual for proper charging instructions.
• Do not leave the Li-ion battery on prolonged charge when not in use.
• After extended periods of storage, it may be necessary to charge and discharge the Li-ion
battery several times to obtain maximum performance.
• Retain the original product documentation for future reference.
• Disconnect the Li-ion battery from the equipment when not in use.
• Do not charge the Li-ion battery below 0°C.
1.2. Disposal
Li-ion
WARNING:
Must be disposed of properly.
May explode if damaged or disposed
of in re. Do not short circuit.
Dispose the Li-ion battery in accordance with local, state and federal laws
and regulations.
Batteries may be returned to the manufacturer.
Do not mix with other (industrial) waste.
6
1.3. Safety symbols and markings on product
Several safety symbols and markings can be found on the product. These markings are
displayed below. Never remove these markings!
The meanings of the symbols:
Wear eye protection
Refer to instruction manual/booklet
Warning, corrosive substance
Warning, explosive material
No open ame, ignition source and smoking prohibited
No children allowed
14340_067_id_SUPB_Labels_Safety_30x70.indd 126-04-17 09:27
7
Be in charge. Super B.
2. Introduction
2.1. Product description
The Mason 12V20Ah / 12V25Ah power battery is light-weighted, compact and offers high
performance. Thanks to its lithium iron phosphate technology and integrated Battery
Management System (BMS) this new generation battery is extremely reliable and offers
optimal safety. The BMS constantly monitors the status of individual battery elements such
as cell temperature, cell voltage, charge and discharge currents. The integrated BMS also
provides cell balancing.
Please note that Li-ion batteries have to be treated differently from conventional lead-acid
batteries. We kindly ask you to pay attention to the warnings as mentioned on the battery:
1.Risk of re and burns when not used or treated correctly.
2.Do not open, crush, heat above 60°C or incinerate.
3.Follow manufacturer’s instructions.
4.Avoid contact with electrolyte. In the event of an accident, ush with water.
5.Do not jumpstart.
6.Use correct charger.
7.Do not puncture or impact this battery.
8.Do not short battery terminals.
9.Do not reverse connect (polarity).
10.Do not operate battery beyond published maximum specications.
11.This product can store fault conditions internally, like excessive charge current or deep
discharge situations. Super B uses this information in the warranty process.
2.2. Intented use
The Mason series Li-ion battery serves as a voltage source for starting combustion engines,
which use a 12V board net. Also stationary applications which require a short and high peak
current can benet from using this Li-ion battery. The Mason series Li-ion battery has an
integrated BMS, which will monitor whether the battery is being misused and will then shut
down to protect the Li-ion cells. Therefore it is not advised to use the battery in vehicles or
systems where the battery voltage, current or temperature exceeds the specied working
range. In these circumstances the battery will shut down and can cause damage to the 12V
system if it is not designed for Li-ion battery use. Never install multiple Li-ion batteries in
series or parallel.
2.3. Glossary of Terminology
Endurance Life-cycle: The products maximum lifespan, achieved by following the guidelines
presented in this manual
8
Charge cycle: A period of use from fully charged, to fully discharged, and fully
recharged again
CCCV: Constant Current - Constant Voltage
LiFeP04 Lithium Iron Phosphate
BMS Battery Management System
Table 1. Glossary of terminology
2.4. Used symbols
The following icons will be used throughout the manual:
!
Warning! A warning indicates severe damage to the user and/or product may occur when a
procedure is not carried out as described.
!
Caution! A caution sign indicates problems may occur if a procedure is not carried out as
described. It may also serve as a reminder to the user.
3. Product specications
3.1. Technical specications
3.1.1. Electrical specications
Mason 12V20Ah Mason 12V25Ah
Nominal capacity120Ah 25Ah
Energy 256Wh 320Wh
Nominal voltage 12.8V 12.8V
Open circuit voltage 13.2V 13.2V
Self-discharge <3% per Month <3% per Month
EqPb (Equals lead-acid
battery) 70 to 100Ah 100 to 130Ah
Table 2. Electrical specications.
1The nominal capacity may deviate by ± 8%
3.1.2. Mechanical specications
Mason 12V20Ah Mason 12V25Ah
Dimensions (LxWxH) 255 x 101 x 171mm
10.0” x 4.0” x 6.7”
255 x 101 x 171mm
10.0” x 4.0” x 6.7”
Weight 4.6 kg / 10.1lbs 5.2 kg / 11.46lbs
Ingress protection IP66 IP66
Cell type / chemistry Cylindrical - LiFePO4 Cylindrical - LiFePO4
Table 3. Mechanical specications
9
Be in charge. Super B.
3.1.3. Charge and discharge specications
Mason 12V20Ah Mason 12V25Ah
Charge method CCCV CCCV
Charge voltage 14.3V - 14.6V 14.3V - 14.6V
Max charge current 66A 77A
End of discharge voltage 8V 8V
Discharge current
continuous 260A 260A
Discharge pulse current
(1 sec) 892A (45C) 1000A (40C)
Table 4. Charge and discharge specications
3.1.4. Temperature specications
Mason 12V20Ah Mason 12V25Ah
Charge temperature 0°C to 55°C1 / 32°F to 131°F10°C to 55°C1 / 32°F to 131°F1
Discharge temperature -30°C to 55°C / -22°F to 131°F -30°C to 55°C / -22°F to 131°F
Storage temperature short
term (<1 month) -40°C to 60°C / -40°F to 140°F -40°C to 60°C / -40°F to 140°F
Storage temperature long
term (>1 month) -10°C to 25°C / 14°F to 77°F -10°C to 25°C / 14°F to 77°F
Relative humidity 10-90% 10-90%
Table 5. Temperature specications
1Do not charge the Li-ion battery below 0°C / 32°F
3.1.5. Compliance specications
Mason 12V20Ah Mason 12V25Ah
Certications CE, FCC, UN 38.3, UN ECE R10 CE, FCC, UN 38.3, UN ECE R10
Shipping classication UN 3480 UN 3480
Table 6. Compliance specications
3.1.6. General product specications
Mason 12V20Ah Mason 12V25Ah
Battery designation 4IFpR27/66-8 4IFpR27/66-10
Cycle life >1000 (10C discharge, 100% DoD) >1000 (10C discharge, 100% DoD)
Table 7. General product specications
*The cycle life given above is an indication at 23°C. Battery lifespan depends strongly on temperature and the applied charging and
discharging currents.
10
3.2. Environmental conditions
!
!
Warning! The Li-ion battery may only be used in conditions specied in this manual.
Exposing the battery to conditions outside the specied boundaries may lead to serious
damage to the product and/or the user.
Use the Li-ion battery in a dry, clean, dust free, well ventilated space. Do not expose the
Li-ion battery to re, water, solvents or excessive heat.
3.3. Required tools
• 10mm Hexagon socket wrench
3.4. Scope of delivery
2 3 4
65 7
Figure 1. Scope of delivery
1. (1x) Mason Li-ion Power battery
2. (1x) Terminal cover, Red
3. (1x) Terminal cover, Black
4. (2x) M6 bolt
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Superb Kamerazubehör Handbücher
Superb
Superb EPSILON 12V100Ah Bedienungsanleitung
Superb
Superb EPSILON 12V90Ah Bedienungsanleitung
Superb
Superb Epsilon SB12V1200Wh-M Bedienungsanleitung
Superb
Superb SB12V100E-ZC Bedienungsanleitung
Superb
Superb Epsilon SB12V1200Wh-M Bedienungsanleitung
Superb
Superb NOMADA 12V105Ah Bedienungsanleitung
Superb
Superb NOMIA 12V340Ah Bedienungsanleitung
Superb
Superb SB12V160E-ZC Bedienungsanleitung
Superb
Superb NOMIA 12V160Ah Bedienungsanleitung
Superb
Superb NOMIA 12V210AH Bedienungsanleitung
