-8-
SY120SA SINGLE DOOR CONTROLLER
Burglar
system
operation
Proximity
card END
Start
Enter pppp + nnnn + nnnn + EN
pppp thoe original old password or system first set up password; default deifne 0000
nnnn new password, enter twice to confirm.
Example card password alter from 0000 to 5678
After proximity card then enter + + + EN
The card password change from 0000 to 5678
group set up open door mode to password open door mode
Enter NNNN + pppp + nnnn + nnnn + EN , the system will decide correct or
not, and will response correct status and modify the old password to new password.
NNNN effective card number, 0001 2000
pppp the orginal password or system preset password (default password is 0000)
nnnn new password, enter twice to confirm.
Example the password of card number 0001change from 5678 to 2468
Enter++++EN
The card passowrd change from 6578 to 2468.
【】【】【】
：
：
：
００００ ５６７８ ５６７８
【】
【 】【】【】【】
：～
：
：
：
０００１ ５６７８ ２４６８ ２４６８
9. System default
Under login status, enter FUN + + EN, it will response the correct status if correct;
then enter FUN + + EN again and wait for ten seconds to clear all setting and restore
to default.
9-1 Clear all setting and restore to default (including card data, parameters, and I/O data…etc.)
４９
４９
10. Steal Alarm System Function Setup
10-1 Steal Alarm system relief withdraw
10-2 Start Steal Alarm System deploy
【】
０
【】
１
Enter FUN + + EN, the OK pilot lamp flash once, the warning light go out after proximity
card then burglarproof system complete relief.
Enter FUN + + EN, the pilot lamp flash once, after proximty card the warning light
flashes, the burlgarproof system start operating complete.
8-3 Enabled or Disable Encryption Card
(V3.0)
Enter[FUN][4][8](E) [EN]
(E): E=0 EM/TEMIC Card (default); E=1 Use SYRIS Encryption Card;
E=2 Use Security Encryption Card
