SYSFORM S-500 Bedienungsanleitung
How to change radius die set on S-500 Corner Cutter
1
Changing blade
(Warning: Sharp knife. Be careful during replacement.)
Switch the machine off.
Remove the clamp.
Remove the left and right side lays.
Loosen the two lower die fixing screws.
Take away the lower die.
Loosen the four fixing plate screws.
Replace a new upper blade back into the original
position and make sure screws fasten tightly.
Switch the machine on then press the inching
button to have the upper blade cut down to the
lowest point.
Put the lower die into the working desk, and
setting two screws.
As shown in the photo, right hand pushes the
lower die to press the upper blade slightly then
fasten two screws.
After replacing the blade, the side lays must be
recalibrated.
How to change radius die set on S-500 Corner Cutter
2
Calibration for side lays
Switch the machine on then press the inching
button to have the upper blade cut down to the
lowest point.
Place the calibration gauge onto the working table.
Push it to let its angle press the upper blade with
no gap.
Push the left and right side lays to close the left
and right edges of the calibration gauge then
fasten their fixing screws.
Sharpening blade and die
Sharpen the upper blade and the lower die, grind
the plane shown at the arrowed place and remove
0.1mm per time.
One sharpening process can sustain for over
10,000 cuts, but still depending on the operation
and the materials.
Lubrication
Refuel lubricant every 30 days for using frequently,
for not often use every 90 days.
Switch the machine off, unplug the power cord.
Remove the cover, lubricate sliding motion
mechanism.
Adjust sliding gap every 90 days for using
frequently, for not often use every 180 days.
Loosen the two screws of lower die, loosen the
two screws of left sliding bar then let the sliding
bar clamp the upper blade carrier slightly then
fasten their screws.
Attention, the blade must be recalibrated after adjustment.
Andere Handbücher für S-500
1
Inhaltsverzeichnis
Andere SYSFORM Cutter Handbücher
Beliebte Cutter Handbücher anderer Marken
Milwaukee
Milwaukee HEAVY DUTY M12 FCOT Bedienungsanleitung
Makita
Makita DCS552 Bedienungsanleitung
SignWarehouse.com
SignWarehouse.com Bobcat BA-60 Bedienungsanleitung
Makita
Makita 4112HS Bedienungsanleitung
GEISMAR STUMEC
GEISMAR STUMEC MTZ 350S Bedienungsanleitung
Hitachi
Hitachi CM 4SB2 Fehlerbehebungshandbuch
