Do not attempt to repair, adjust or replace parts in the appliance. Repair the
malfunctioning appliance in the nearest service center.
To protect against the risk of severe burns, do not touch the heating plates.
CAUTION:
Be careful, the device becomes very hot during operation.
If the device is plugged in the socket or it is cooling off after using, do not place the
device on an unprotected surface or lean it against the power cord.
The device is to be used only on dry clean hair or towel-dried hair.
The manufacturer reserves the right to introduce minor changes into the product
design without prior notice, unless such changes influence significantly the
product safety, performance, and functions.
INSTRUCTION FOR USE
STRAIGHTENING
Before using always make sure that the cord is straightened out.
Insert the plug into the power socket; the indicator light should light up.Allow the
appliance to heat for a few minutes.
You can choose one of the two operation modes. Lower temperature is
recommended for straightening thin hair (mode 1), while for straightening thicker
hair the higher temperature mode should be set (mode 2).
Before using it on your hair, divide the hair into thin strands of hair.
To straighten the hair, place it between the straightening plates and gently slide it
downwards. Repeat this process 2-4 times.
CURLING
In order to curl your hair you must divide your hair into thin strands
Take one strand of hair at a time and curl it around the curling plate of the unit.
(During this time be very careful not to touch the curling plate with your hands)
Hold the strand of hair for approximately 5-10 seconds and then release the hair
strand. Repeat this process with the rest of the hair strands until the process has
been completed.
Do not comb the hair just after curling; wait until it cools down completely.
Unplug the appliance from the power supply and allow it to cool down.
NOTE: Do not use the appliance longer than 15-20 minutes.
NOTE: In order to get more defined curls, hold the hair strands around the curling plate for
a few extra seconds.
