INGLÉS
7 / 14
SCANNING CHANNEL
1. Press "Scan / Monitor " Key, LCD display
icon. It will start to scan channel
automatically.
Note: If press and hold the button
over 2 seconds, it will break the
squelch noise and listen to the
current channel.
2. The unit scan all channels one by one it will
stay on the occupied channel. Press" " Key to
continue scanning.
3. If there is no signal, it will continue to scan.
Press PTT key, it will stay on the current
channel and continue to scan after 5
seconds.
4. Press"Scan/Mon"Key to quit and return to
current channel.
Note: Occupied Channel means main
channel and CTCSS code are same.
SENDING CALL TONES
You can use Call Tones to get the attention of other
people with radios on the same channel and CTCSS
tone. You can also use Call Tones as the signal of the
start or end of a transmission.
1. Press"CALL"key, LCD display icon and your
call tone will be transmitted to nearby
receivers set at the same channel.
2. The call tones have 10 kinds of sound for
personal selection.
Select call tones
1. Press" "key three times, LCD display
icon and call tone number will flash,
2. Press" "," "key to select your desired the
call tone
3. Press the"PTT"Key to confirm, the call tone
number display will stand.
VOX - HANDS-FREE FUNCTION
The Radio has a built-in Voice Activated
Circuit(VOX)function,You can connect the radio
with the earphone for hands-free talking and
listening without pressing PTT Key.
To turn on VOX fuction
1. Press" "key four times, LCD display
icon and VOX sensitivity digit display will flash
2. Press" "," " key to select 1, 2, 3 for low,
medium & high sensitivity. (0 is off)
3. Then press key again, the digit of VOX
overtime digit will flash.
4. Press" "," "key to choose overtime from 1
to 5 seconds
5. After turn on VOX, you need to connect
the earphone to use the hands-free
function. See below steps.
