
www.taeredlace.co.uk
To ghten, move the wheel towards you. This adjuster allows you to ne tune the pressure
of the rollers. Below the thumbwheel is a slider with numbers. Numbered “0” to “18”,
the lower numbers are a general seng for thinner dies and materials, while the larger
numbers open up the rollers for thicker materials and dies. We suggest you “make friends”
with your Crossover™ and you will quickly adjust to using the thumbwheel and will
ancipate the correct sengs for your projects.
PRESSURE ADJUSTMENTS
The Crossover™ oers the unique capability to
adjust the space between the rollers, negang the
need to use shims and mulple layers of plasc to
get a good result. The adjustment “thumbwheel”
is conveniently placed between two arrows on
the centre top of the machine. If le-handed, turn
the machine around, however ensure you turn
the handle counter-clockwise when operang the
machine.
To lessen pressure, move the wheel away from you.
INSTRUCTIONS
THE CUTTING PLATFORM
The basic plaorm consists of two layers. A
thick white base and a thick clear plasc cung
plate for viewing. The Crossover™ cung plate
is almost twice as thick as smaller machines
available, and will last much longer without
“bowing”. Included in your package is a stainless
steel adapter plate for detailed die cuts or mul-
layer fabric cuts.
The gears on the Crossover™ have been sized so that the plaorm rolls through the
machine quickly. If you nd that the handle is too hard to turn, it’s likely you have set
the rollers too ghtly. Simply move the thumbwheel away from you aer removing the
plaorm. This feature was designed to avoid breaking your machine by over-shimming.
CUTTING ACTIVITY