Tatung TLM1905 Bedienungsanleitung

OPERATING INSTRUCTIONS

TLM-1705 / TLM1905

PREFACE

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Opeartion is subjected to

the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference

that may cause undesired operation.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful

inerference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the

shielded signal cord supplied with this unit.

The Federal Communications Commission warns that changes or modifications

of the unit not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

CE mark for Class B ITE (Following European standard EN55022/1998; EN61000-

3-2/1995; EN61000-3-3/1995, EN55024/1998, EN60950/1992+A1+A2+A3+A4+A11)

Radio Frequency Interference Statement

Warning:

This is a Class B product. In a domestic environment, this product may cause

radio interference in which case the user may be required to take adequate

measures.

Canadian Doc Notice

For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise

emissions from digital apparatus as set out in the Radio Interference Regulation

of the Canadian Department of Communications.

“Le présent appareil numérique n’èmet pas de bruits radioélectriques dépassant

les limites applicables aux appareils numériques de la class B prescrites dans le

Règlement sur le brouillage radioélectrique édicté par le ministère des

Communications du Canada”

iii

Important Operating Instructions

Please read the following instructions carefully. This manual should be retained

for future use.

1. To clean the LCD monitor screen, first, make sure the monitor is in the

power off mode. Unplug the monitor from its power source before cleaning

it. Do not spray liquid cleaners directly onto the unit. Without applying

excessive pressure, clean the screen with a slightly dampened rag.

2. Do not place your LCD monitor near a window. Exposing the monitor to

rain, water, moisture, or sunlight can severely damage it.

3. Do not place anything on top of the monitor-to-PC signal cord. Make sure

the cord is placed in an area where it will not be stepped on.

4. Do not apply pressure to the LCD screen. Excessive pressure may cause

permanent damage to the display.

5. Do not remove the cover or attempt to service this unit by yourself. You may

void the warranty. Servicing of any nature should be performed only by an

authorized technician.

6. Safe storage of the LCD monitor is in a range of minus 20 to plus 60 degrees

Celsius. Storing your LCD monitor outside this range could result in

permanent damage.

7. Immediately unplug your monitor and call an authorized technician when:

• The power or monitor-to-PC signal cord is frayed or damaged.

• Liquid has been spilled into the monitor, or it has been exposed to rain.

• The monitor has been dropped or the case has been damaged.

8. Only with use of supplied adaptor, in case of loss or replacement contact the

retailer or service center.

9. If you lost the power cord that we given, you must to purchase a same

configuration/type of power cord (with ground-connection)

 Japan：VCTF type, 3 wires or with ground-wire, T-mark approval is

required.

 U.S.：VW-1; 18AWG X 3C; SVT with national approval as UL

and/or CSA approval/number(s)

 Europe：VDE/ÖVE and/or KEMA approval; H05VV-F, 3G,

0.75mm2, or equivalent.

Above power cord should bear with the type and manufacturer name on.

Introduction

CONTENTS

PREFACE .....................................................................................................................I

CHAPTER 1................................................................................................................. 1

Unpacking 1

Identifying Components 2

The LCD Multimedia Monitor — Front View 2

The LCD Multimedia Monitor — Rear View 2

Adjusting the Tilting Angle 3

Raising Your Monitor to an Upright Position and Adjusting Monitor Angle4

Power Management System 5

CHAPTER 2................................................................................................................. 6

LCD Multimedia Monitor Control Panel 6

Adjusting the Monitor’s Display 7

OSD Main Menu 7

Hot-Key Buttons for Quick Adjustment of Monitor Settings. (〝AUTO-

ADJUST〞hot-key is effective only when analog input signal is selected for

application) 16

APPENDIX A............................................................................................................. 17

Troubleshooting Procedures 17

APPENDIX B ............................................................................................................. 19

LCD Monitor Specifications 19

APPENDIX C............................................................................................................. 21

CHAPTER 1

The LCD Multimedia Monitor

Unpacking

After you unpack your LCD multimedia monitor, make sure the following items are

included in the box and in good condition:

Standard Item

• LCD multimedia monitor

• Monitor-to-PC analog signal cable (15-pin)

• Monitor-to-PC digital signal cable (24-pin) – (Optional)

• Power cord

• Addendum

• User’s manual

• 1.5M Stereo Jack audio cable

If you find that any of these items are missing or appear damaged, contact your dealer

immediately. Do not throw away the packing material or shipping carton in case you

need to ship or store the LCD multimedia monitor in the future.

Identifying Components

The LCD Multimedia Monitor — Front View

Figure 1-1: The LCD multimedia Monitor Front View

1. Power-On Indicator

This LED indicator stays lit when the power is on and blinks

when the LCD multimedia monitor is in power saving mode.

2. Monitor Stand

3. LCD Screen

4. LCD Multimedia Monitor Control Panel

Refer to Chapter 2 for a detailed.

The LCD Multimedia Monitor — Rear View

Figure 1-2: LCD Multimedia Monitor Rear View

1. Audio Line-in

2. AC Power Jack

3. VGA (Analog) Cable With 15-Pin D-Sub VGA Connector (Male)

4. S-Video connector

5. AV connector

6. Digital VGA (DVI) Cable Connector (Optional)

Adjusting the Tilting Angle

The LCD multimedia monitor’s angle settings range from -3°to 20°. See Figure 1-3.

Figure 1-3: Tilting the Monitor

Raising Your Monitor to an Upright Position and

Adjusting Monitor Angle

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Tatung Monitor Handbücher

Tatung

Tatung OMNISCAN SERIES Bedienungsanleitung

Tatung

Tatung TCM-2102s Bedienungsanleitung

Tatung

Tatung L19CMATB-U32 AD Bedienungsanleitung

Tatung

Tatung L7CMS Bedienungsanleitung

Tatung

Tatung 5005L13 Bedienungsanleitung

Tatung

Tatung VM-14AF Bedienungsanleitung

Tatung

Tatung VM9G5DA S995T Bedienungsanleitung

Tatung

Tatung VM7K9 Bedienungsanleitung

Tatung

Tatung VM9K9DA Bedienungsanleitung

Tatung

Tatung F Series Bedienungsanleitung

Tatung

Tatung Vibrant VM77S Bedienungsanleitung

Tatung

Tatung TME17A Bedienungsanleitung

Tatung

Tatung DS42-AV Bedienungsanleitung

Tatung

Tatung VM9K9DA P990S Bedienungsanleitung

Tatung

Tatung CM-1480 Bedienungs- und Montageanleitung

Tatung

Tatung TLM-1503 Bedienungsanleitung

Tatung

Tatung Vibrant VM99S Bedienungsanleitung

Tatung

Tatung CM-1496 Series Bedienungs- und Montageanleitung

Tatung

Tatung G5GS Series Bedienungsanleitung

Tatung

Tatung Decca CM-1380F Series Bedienungsanleitung

Tatung

Tatung TME24 Bedienungsanleitung

Tatung

Tatung TCM-0902 Bedienungsanleitung

Tatung

Tatung 7005L Bedienungsanleitung

Tatung

Tatung TME22W Bedienungsanleitung

Beliebte Monitor Handbücher anderer Marken

Linear Acoustic

Linear Acoustic LQ-1000 Bedienungsanleitung

AOC

AOC I2579V Bedienungsanleitung

Gateway

Gateway FPD1520 Bedienungsanleitung

Furuno

Furuno Mu 120c Bedienungsanleitung

Asus

Asus VB171D - 17" LCD Monitor Bedienungsanleitung

Dell

Dell S2230MX Gebrauchsanweisung

Philips

Philips 107C64 Bedienungsanleitung

Dell

Dell S2409WFP Bedienungsanleitung

EverFocus

EverFocus EN-7517E Bedienungsanleitung

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Bedienungsanleitung

Dell

Dell Precision 7680 Bedienungsanleitung

LG 50PM1M - - 50" Plasma Panel Bedienungsanleitung

Bosch

Bosch DDU 9 Bedienungsanleitung

Acer

Acer A231HL Bedienungsanleitung

Philips

Philips 86BDL4152T Bedienungsanleitung

NEC

NEC AccuSync LCD5V Bedienungsanleitung

Emay

Emay SleepO2 Bedienungsanleitung

IBM

IBM 6360 Montageanleitung