ON/OFF button: Turns the unit on or off Indicator light
illuminates when unit is plugged in.
Unit operates in default fan speed that last time worked.
SPEED button: Selects fan speed: Low – Medium – High.
Corresponding indicator light will illuminate.
SWING button: Starts/stops horizontal swing of vertical louvers,
swing indicator light will illuminate.
*To direct vertical airflow, adjust the horizontal louvers manually.
MODE button: Selects the operating mode, corresponding indicator
light will illuminate.
(Normal): Operates at selected fan speed.
(Natural): Imtates natural air flow. Unit operates according to
preset computer program, alternating between different fan speeds.
Please refer to next page for schematics.
(Sleep): Unit operates according to preset program. Please refer
to next page for schematics.
TIMER button: Press to set off timer between 1 to 12 hours.
Each press is 1-hour increments. Illuminated lights add up to set time.
COOL button: Press to engage evaporative cooling
function.NOTE: Unit does NOT have a water-out indicator. Please
add water when you hear a gurgling noise (the water pump trying to
pump water).Make sure water is added before turning on this
function. Unit cycles the water to blow cool, humidified air. Add
ice/ice pack for added cooling.
TAYAMAR
Ice or reusable ice
box (2pcs empty ice
box included)
Cool
Speed
Swing
Timer
ON/OFF
Mode
TAYAMAR
With use, the filter and honeycomb pad will become clogged with
dust, which will greatly affect the unit's performance. Sometimes
mold and mildew may also occur, due to lack of water changes. It is
recommended to clean the filter and honeycomb pad once every two
weeks.
1. Turn unit off and disconnect power.
2. Remove the screw of the rear cover.
3. Remove filter and honeycomb pad.
4. Wash the filter in a mild detergent and warm water solution and
rinse with clean water.
5. Wash the honeycomb pad with clean water only. A soft brush can
be used for cleaning.
6. Replace the honeycomb pad, filter and screw to fix the position.
The water tank should be cleaned periodically:
1. With unit powered off and unplugged.
2. Remove screws of the filter net and take out the filter and
honeycomb pad.
3. Unplug the rubber plug in the water tank and clean tank with
brush or cloth.
Before putting unit away for storage, please clean filter, honey comb
pad and water tank. Allow to dry completely before replacing. Then
run the unit in fan only mode for 30 minutes or so to dry the inside.
This will prevent mold and mildew growth.
Remote Control
The functions on the remote are the
same as the control panel for the
exception of timer (deduction
function) Attention ： Unit does NOT hav
gurgling noise (the water pum trying to pump water).
ea water-out indicator. Please add water when you hear a
p
