TDK-Lambda PHV Series Benutzerhandbuch

IEEE DIGITAL INTERFACE SETUP MANUAL FOR

PHV Series High Voltage

POWER SUPPLY

Document: 83550130 Rev A

TDK-LAMBDA AMERICAS

405 Essex Road, Neptune, NJ 07753

Tel: (732) 922-9300

Fax: (732) 922-9334

Web: www.us.tdk-lambda.com/hp

THIS PAGE LEFT INTENTIONALLY BLANK

83550130 Revision A

Table of Contents

1. Overview...................................................................................................................................3

1.1. Scope........................................................................................................................................3

1.2. ADDR LED................................................................................................................................3

1.3. Service Request (SRQ) LED.....................................................................................................3

2. Interface setup information........................................................................................................5

2.1. GPIB primary address (PA).......................................................................................................5

2.2. Other DIP switch settings..........................................................................................................5

83550130 Revision A

THIS PAGE LEFT INTENTIONALLY BLANK

83550130 Revision A

1. Overview

1.1. Scope

This manual applies to PHV series power supplies equipped with the IEEE digital interface

option. The manual describes setting the GPIB interface address only.

The IEEE interface programming commands can be found in the Digital Interface

Command Reference manual (document 83550100) downloadable from the PHV product

page: http://www.us.tdk-lambda.com/hp/product_html/PHVpower.htm.

The IEEE interface is located on the rear panel of the power supply. A sketch is shown

below.

IEEE Interface features

1- IEEE-488 interface connector

2- Configuration DIP switch (see section 2.1)

3- Interface Addressed LED (see section 1.2)

4- Service Request LED (see section 1.3

1.2. ADDR LED

This LED illuminates when the interface is either in listener addressed state or talker

addressed state.

1.3. Service Request (SRQ) LED

This LED illuminates when the interface asserts the SRQ line. After a serial poll the LED

extinguishes.

83550130 Revision A

THIS PAGE LEFT INTENTIONALLY BLANK

83550130 Revision A

2. Interface setup information

For normal operation, only the GPIB primary address should be adjusted using switches 1

through 5 if required. The other switches, 6 through 8 remain in the OFF position.

2.1. GPIB primary address (PA)

The GPIB primaryaddress (PA) enables identification of all units connected to an IEEE-488

bus system, and each unit connected to the bus must be assigned a unique PA.

The Host PC usually has PA=0 and the connected units usually have addresses from 4

upwards. Normally PHV power supplies arefactory configured with the PA set to 8.

The user can change the factory set PA via a DIP switch located on the IEEE-488 interface

converter on the rear panel of the unit (see the figure on page 3). It is not necessary to

open the power supply.

After changing a configuration switch, the power supply should be turned off for 5 seconds

and turned on again.

To change the GPIB PA, the user should only change switches 1 through 5. The unit is

factory set with switch 4 in the ON position and switches 1, 2, 3, and 5 are in the OFF

position (PA=8).

The switch settings follow the binary system:

Switch 1 has value 1

Switch 2 has value 2

Switch 3 has value 4

Switch 4 has value 8

Switch 5 has value 16

Example: To set the GPIB PA to 9, Switches 1 and 4 are ON, switches 2, 3, and 5 are

OFF. To set the GPIB PA to 20, Switches 3 and 5 are ON, switches 1, 2, and 4 are OFF.

2.2. Other DIP switch settings

DIP switches 6, 7, and 8 are special functions and are factory set to the OFF position and

the settings should not be changed. Contact the factory for further information.

Andere Handbücher für PHV Series

Inhaltsverzeichnis

Andere TDK-Lambda Stromversorgung Handbücher

TDK-Lambda

TDK-Lambda CPF1200F280 Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda RKY Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda GENESYS 750W HALF RACK Bedienungsanleitung

TDK-Lambda

TDK-Lambda Alpha 600 Bedienungsanleitung

TDK-Lambda

TDK-Lambda LZS-A1500-3-001 Bedienungsanleitung

TDK-Lambda

TDK-Lambda CPFE500 Montage- und Bedienungsanleitung

TDK-Lambda

TDK-Lambda GENESYS 1500W Bedienungsanleitung

TDK-Lambda

TDK-Lambda Z+ series Bedienungsanleitung

TDK-Lambda

TDK-Lambda GENESYS GEN 2400W Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda FPS-T1U Bedienungsanleitung

TDK-Lambda

TDK-Lambda LZS-A1000-3 Bedienungsanleitung

TDK-Lambda

TDK-Lambda 500A Bedienungsanleitung

TDK-Lambda

TDK-Lambda ZWS-BP Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda ZWQ Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda CUT35 Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda HFE1600-48 Bedienungsanleitung

TDK-Lambda

TDK-Lambda CUT75 Bedienungsanleitung

TDK-Lambda

TDK-Lambda DBM20 Bedienungsanleitung

TDK-Lambda

TDK-Lambda RWS-B Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda EZA2500W Series Installationsanleitung

TDK-Lambda

TDK-Lambda Genesys GEN8-300 Bedienungsanleitung

TDK-Lambda

TDK-Lambda DDA Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda ZWS240RC Series Bedienungsanleitung

TDK-Lambda

TDK-Lambda DRB120 Series Bedienungsanleitung

Beliebte Stromversorgung Handbücher anderer Marken

Monacor

Monacor PS-12CCD Bedienungsanleitung

VOLTIMA

VOLTIMA MagicBox 15 Bedienungsanleitung

Agilent Technologies

Agilent Technologies 6032A Bedienungsanleitung

Miller

Miller Auto Deltaweld 452 Bedienungsanleitung

BCP

BCP PUOUBK Merkblatt

HC 2210 Bedienungsanleitung

Puls

Puls CT5.241 Bedienungsanleitung

OCZ

OCZ ZX1250W Bedienungsanleitung

iseg

iseg ECH 238 Bedienungsanleitung

Power

Power XXL A Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies 6631B Bedienungsanleitung

Renogy

Renogy PHOENIX 300 Bedienungsanleitung

HP 6200B Service-Handbuch

Epson

Epson Stylus Scan 2500 Betriebsanleitung

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Bedienungsanleitung

Puls

Puls MiniLine ML50.100 Bedienungsanleitung

Puls

Puls AS-Interface SLA4.100 Bedienungsanleitung

Kenwood

Kenwood PS-60 Bedienungsanleitung