To power on the transmitter press the power button. To power down the transmitter
press and hold the power button until the screen displays “Shutting Down”. The front left
switch is the Arm switch. The away and middle position are both Disarm and the closest
position to you is the Arm position. Note: Never arm the Teal Sport Drone with anything
near the props. They will cause damage. Only arm your Teal Sport when it has plenty
of clearance and is on a flat surface. The back left switch is the Acro/Stabilized flight
mode switch. The away position is the Stabilized flight mode and the closest to you
switch position is the Acro flight mode. Stabilized is for beginners and Acro mode is for
advanced pilots who want full agility control. The back right spring-loaded switch is for
telemetry. Momentarily moving the switch to the position closest to you will announce a
battery telemetry report for battery capacity (announced in milliamp hours) and voltage
(announced in volts.) Think of milliamp hours as fuel left in the tank and voltage as the
strength of that fuel. Land your Teal Sport before 1,000 milliamp hours is reached to
prevent permanent battery damage. If voltage goes below 14 volts the Teal Sport should
immediately be landed.
With the Taranis QX7 turned on, pressing and holding the page button will show the
Telemetry page. This shows VFAS (voltage) and Fuel (indicated in milliamp hours). To exit
out of the telemetry screen press the Exit button. Telemetry will begin when your Teal
Sport Drone is powered up by plugging in your battery.
IMPORTANT: Unplugging and replugging in a partially discharged battery will reset the
battery capacity monitor. Your audio capacity warnings may not be accurate. Use a fully
charged battery for accurate audio warnings.
NOTE: Always begin your flights with a full battery.
