Teamline 5250 Page 8
Connecting Teamline 5250 to peripherals
nStarLeaf microphone
nA camera and where applicable, camera cables, mounting kit, and
camera power supply
Positioning the Teamline 5250 system
1. Choose an appropriate installation site:
lThe system must be accessible to ensure all cables are easily connected
lProvide ventilation for the system; leave a space of at least 10cm (4
inches) behind, in front, and to the left and right of the system
lUse a grounded AC power outlet for the system
2. Rack mount the unit or place on firm horizontal surface. The system is 1.5 U
high (with removable feet detached) and is designed to fit in standard 19-
inch racks. If you are using wireless (for example, Miracast) to connect
devices to present content in meetings, ensure the system is not enclosed in
a rack or behind a display. Otherwise, the wireless signal may not function.
Connecting network cables to the Teamline system
Note: When connecting HDMI or DVI cables to the camera inputs, the PC
input, and the display outputs, ensure you use the correct gauge of
HDMI/DVI cable. For short cable lengths of up to 5m (17 feet), use 28AWG or
thicker core. For longer lengths, use 24AWG or thicker. StarLeaf does not
support the use of HDMI or DVI cables of longer than 15m (49 feet) with the
Teamline system.
1. Using an Ethernet cable, connect the StarLeaf Controller Only connector
on the Teamline system to the PoE network port on the rear of the
touchscreen controller. The touchscreen controller must connect directly to
the Teamline 5250. Do not connect the touchscreen controller through a
switch. The network port on the touchscreen controller is marked with this
symbol:
2. Using the second Ethernet cable, connect the Network port on the rear of
the Teamline system to an Ethernet switch in your network. The Ethernet port
is a 10/100/1000 Mbit/s auto-sensing port and is set to ‘auto’ by default.
If your network doesn't support automatic detection, you can configure the
network speed manually. On the touchscreen controller connected to the
Teamline system, go to settings > networking > network port speed and
select 100Mb/s (full).
The icons in the top-left corner of the touchscreen show the status of
connected devices:
