P. 6 - BLACK II 4
1. Mike/line/guitar input jacks of MIC Channel:
The jacks are used to connect microphones or
other audio devices in support of cannon plugs
and 6.5 plugs.
2. +48V phantom switch/LED: When this switch
is turned on, the +48V LED lights and DC +48
V phantom power is supplied to theXLR plug
in Mic input jack. NOTICE: Be sure to leave this
switch o if you do not need phantom power.
Follow the important precautions below, in
order to prevent noise and possible damage to
external devices as well as the mixer if you turn
this switch on. Be sure to leave this switch o
when you connect a device that does not support
phantom power to channel. Make sure to turn
this switch o when connecting/disconnecting a
cable to/from channel. Slide the knob on channel
to minimum before turning this switch on/o.
3. Guitar/Line input shier: The switch is used to
shi the connections to dierent sound sources
of the input channels. Switched up, the input
channel can be connected directly with a high.
impedance audio device such as an electric
guitar o a bass. Switched down, it can be
connected to a low-impedance sound device.
WARNING! In operation of the switch, all level
output control (such as channel volume knobs,
monitor output knobs and earphone knobs)
should be set up to the minimum position.
Because this operation will cause a sudden
impact sound, which can damage the external
devices, and the hearing of the personnel on site.
4. Mic input CH2 band EQ: This is a high quality,
sensitive, 2 segment equalizer that adjusts the
overall tone of the channel. The adjustment
wavefrom of the high and low bass equalizer
is the shape of the broom, which aects the
frequency of 12KHz and the sound below
80Hz.
5. FX send knob: Adjust the size of the signal
sent to the digital eect processor. The signal
transmitting point is located aer the volume
knob of the channel.
6. Pan knob: Positions the channel signal
between L/R in the stereo mix.
7. MIC input volume knob/peak LED: Adjust
the volume of the sound input from the
microphone or other source connected
to channel. When the peak light ashes,
indicating that the input signal is too high,
please turn the volume knob to the le to
reduce the volume. In normal use, please
avoid the peak light for a long time.
8. Th digital eect processo adjust the knob:
REP adjust how many time the echo repeats;
DEL adjust the time interval between each
echo; LEVEL adjust the volume of the eect
processor.
9. MP3 audio signal volume knob: Adjust the
audio signal level from the MP3 player.
10. MAIN output volume knob.
11. Phones output volume knob.
12. The MP3 Player/Recorder controlled
keyboard.
13. The MP3 Player/Recorder LCD display.
14. The MP3 Player/Recorder USB port.
15. Main output level meter.
16. The stereo input channel volume knob.
17. The setereo input channel balance knob.
18. 6.35mm specication for stereo headphone
output inerrupts.
19. Main output jacks: XLR balanced output
interrupt for the connection of active speakers,
power ampliers or other audio devices.
