Tecslate TS64A001 Bedienungsanleitung
TS64A001
User
manual
MultiMedia
Touchscreen HDTV
with integrated PC
TS64A001
Serial number:
Date of purchase:
If you register your TAG product, we’ll notify you of new features and
software upgrades. Please print this page and keep the following infor-
mation available in case you need to contact TAG Support.
Register online at tecslate.com/registration.
Product registration
I
TS64A001
The documentation and the software included with this product are
copyrighted 2014 by TAG Global Systems, LLC. All rights are reserved.
TAG Global Systems, LLC. reserves the right to make improvements in
the products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated or trans-
mitted in any form or by any means without the prior written permis-
sion of TAG Global Systems, LLC. Information provided in this manual is
intended to be accurate and reliable.
However, TAG Global Systems, LLC. assumes no responsibility for its use,
nor for any infringements of the rights of third parties, which may result
from its use.
All other product names or trademarks are properties of their respective
owners.
Copyright
Acknowledgements
II
TS64A001
III
Declaration of conformity
Radio products with the CE alert marking comply with the R&TTE Direc-
tive (1999/5/EC) issued by the Commission of the European Community.
Compliance with this directive implies conformity to the following Euro-
pean Norms (in brackets are the equivalent international standards):
EN 60950—1 (IEC60950—1) —Product Safety. Products that contain the
radio transmitter are labeled with CE alert marking and may also carry
the CE logo.
CE Conformity Statement
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received, including
interference that may cause undesired operation.
FCC Compliance Statement
Exposure to Radio Frequency Radiation. The radiated output of this
device is far below the FCC radio frequency exposure limits. Neverthe-
less, the device shall be used in such a manner that the potential for
human contact during normal operation is minimized. When connecting
an external antenna to the device, the antenna shall be placed in such
a manner to minimize the potential for human contact during normal
operation. In order to avoid the possibility of exceeding the FCC radio
frequency exposure limits, human proximity to the antenna shall not be
less than 20cm (8 inches) during normal operation.
Caution!
TS64A001
IV
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules.These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced computer technician for help
Technical Support and Assistance
1. Visit the Advantech website at http://support.advantech.com where
you can nd the latest information about the product.
2. Contact your distributor, or sales representative for technical support
if you need additionalassistance. Please have the following information
ready before you call:
- Product name and serial number
- Description of your peripheral attachments
- Description of your software (operating system, version, application
software, etc.)
- A complete description of the problem
- The exact wording of any error messages
Declaration of conformity
TS64A001
Safety instructions
• Before you clean your TAG product, shut down or disconnect the
computer. Otherwise, you may scramble the desktop icons or inadver-
tently activate applications when you wipe the screen.
• Avoid setting up and using the TAG product in an area with excessive
levels of dust, humidity and smoke.
• Make sure an electrical socket is near your TAG product and remains
easily accessible during use.
• For SMART Board 8055ie-SMP interactive at panel only: The external
power supply needs to meet the Limited Power Source (LPS)
requirements of CSA/UL/IEC/EN 60950-1, when required.
• This TAG product should be used only with European TN and TT power
distribution systems.
CAUTION
Important information about your touch screen display
It is not suitable for older, IT-type power distribution systems found in
some European countries. “This system (IT-type) is widely used isolated
from earth, in some installations in France, with impedance to earth, at
230/400V, and in Norway, with voltage limiter, neutral not distributed, at
230V line-to-line.” (IEC 60950:1999) Contact qualied personnel if you’re
uncertain of the type of power system available where you’re installing
your SMART product.
You must connect the USB cable that came with your TECSLATE™ inter-
active at panel to a computer that has a USB compliant interface and
that bears the USB logo. In addition, the USB source computer must be
compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or
UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid
damage to the TAG TS64A001
V
TS64A001
VI
• Failure to follow the installation instructions shipped with your
TAG product could result in personal injury and product damage
which may not be covered by your warranty.
• Do not open or disassemble the TAG product. You risk electrical
shock from the high voltage inside the casing. Opening the casing
also voids your warranty.
• Do not stand (or allow children to stand) on a chair to touch the
surface of your TAG product. Rather, mount the product at the ap-
propriate height.
• To reduce the risk of re or electric shock, do not expose the TAG
product to rain or moisture.
• If your TAG product requires replacement parts, make sure the ser-
vice technician uses replace ment parts specied by TAG or parts
with the same characteristics as the original.
• Ensure that any cables extending across the oor to your TAG
product are properly bundled and marked to avoid a trip hazard.
• Do not insert objects inside the cabinet ventilation holes, because
they could touch dangerous voltage points and cause electric
shock, re or product damage which may not be covered by your
warranty.
• Do not place any heavy objects on the power cable. Damage to the
cable could cause shock, re or product damage which may not be
covered by your warranty.
• Use only extension cords and outlets into which this product’s
polarized plug can be fully inserted.
• Use the power cable provided with this product. If a power cable
is not supplied with this product, please contact your supplier.
WARNING
Safety instructions
TS64A001
Safety instructions
VII
Use only power cables that match the AC voltage of the power
outlet and that comply with your country’s safety standards.
• If the glass is broken, do not touch the liquid crystal. To prevent
injury, handle glass fragments with care when disposing of them.
• Do not move or mount the interactive at panel by connecting
rope or wire to its handles. Be cause the interactive at panel is
heavy, rope, wire or handle failure could lead to personal injury.
• Use only mounting hardware included in your packaging.
Disconnect all power cables for your interactive at panel from
the wall outlet and seek assis tance from qualied service per-
sonnel when any of the following occurs:
The power cable or plug is damaged.
Liquid is spilled into the interactive at panel.
Objects fall into the interactive at panel.
The interactive at panel is dropped.
Structural damage such as cracking occurs.
The interactive at panel behaves unexpectedly when
you follow operating instructions.
WARNING
TS64A001
Contents
VIII
Product features 1
Package contents 3
Optional accessories 4
Safety tips 5
Front panel keys 6
Port descriptions
Side view 7
Bottom view, Front view, Rear view 8
Remote control 9
Getting Started 11
Software
Learning the tecslate pro tools 13
Before you use Tecslate Pro 14
Calibrating the Touch Screen 14
Getting to know TecslatePro 15
Bases of touch control 16
Maintenance
Maintataining the LCD Display 20
Cleaning the device 20
Maintaining ventilation 21
Preventing condensation 21
To evaporate condensation from your interactive at panel 21
Trouble shooting 22
Technical specications 23
TS64A001
Product features
The TAG TS64A001 is loaded with features to make your presentations shine.
LED Touchscreen Display
On board PC
Soware
Network Connectivity
Blu-Ray/DVD
1
Inhaltsverzeichnis
Andere Tecslate HDTV Handbücher
