Teledyne LeCroy T3PS Series Bedienungsanleitung

www. .com information@itm.com1.800.561.8187

This chapter contains important safety

instructions that you must follow during

operation and storage. Read the following before

any operation to insure your safety and to keep

the instrument in the best possible condition.

These safety symbols may appear in this manual or on the

instrument.

Warning: Identifies conditions or practices that

could result in injury or loss of life.

Caution: Identifies conditions or practices that

could result in damage to the T3PS or to other

properties.

DANGER High Voltage

Attention Refer to the Manual

Protective Conductor Terminal

Earth (ground) Terminal

www. .com information@itm.com1.800.561.8187

Do not dispose electronic equipment as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased.

Do not place any heavy object on the T3PS.

Avoid severe impact or rough handling that

leads to damaging the T3PS.

Do not discharge static electricity to the T3PS.

Use only mating connectors, not bare wires, for

the terminals.

Do not block the cooling fan opening.

Do not disassemble the T3PS unless you are

qualified.

AC Input voltage range: 85Vac-265Vac

Input Power 2000 VA (Max)

Frequency: 47Hz to 63Hz

To avoid electrical shock connect the protective

grounding conductor of the AC power cord to

an earth ground.

www. .com information@itm.com1.800.561.8187

Use proper power cord.

Maintain ground. The AC inlet ground is

connected to the frame of the instrument. Connect

line cords only to outlets with safety ground

contacts.

Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild

detergent and water. Do not spray any liquid.

Do not use chemicals containing harsh material

such as benzene, toluene, xylene, and acetone.

Location: Indoor, no direct sunlight, dust free,

almost non-conductive pollution (Note below)

Relative Humidity: 20%- 85% (no condensation)

Altitude: < 2000m

Temperature: 0°C to 50°C

www. .com information@itm.com1.800.561.8187

Location: Indoor

Temperature: -25°C to 70°C

Relative Humidity: 90%(no condensation)

Do not dispose this instrument as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased. Please make sure

discarded electrical waste is properly recycled to

reduce environmental impact.

www. .com information@itm.com1.800.561.8187

When using the power supply in the United Kingdom, make sure

the power cord meets the following safety instructions.

As the colours of the wires in main leads may not correspond with

the coloured marking identified in your plug/appliance, proceed

as follows:

The wire which is coloured Green & Yellow must be connected to

the Earth terminal marked with either the letter E, the earth symbol

or coloured Green/Green & Yellow.

The wire which is coloured Blue must be connected to the terminal

which is marked with the letter N or coloured Blue or Black.

The wire which is coloured Brown must be connected to the

terminal marked with the letter L or P or coloured Brown or Red.

If in doubt, consult the instructions provided with the equipment

or contact the supplier.

This cable/appliance should be protected by a suitably rated and

approved HBC mains fuse: refer to the rating information on the

equipment and/or user instructions for details. As a guide, a cable

of 0.75mm2should be protected by a 3A or 5A fuse. Larger

conductors would normally require 13A types, depending on the

connection method used.

Any exposed wiring from a cable, plug or connection that is

engaged in a live socket is extremely hazardous. If a cable or plug is

deemed hazardous, turn off the mains power and remove the cable,

any fuses and fuse assemblies. All hazardous wiring must be

immediately destroyed and replaced in accordance to the above

standard.

www. .com information@itm.com1.800.561.8187

This chapter describes the power supply,

including its main features and front / rear panel

introduction. After going through the overview,

please read the theory of operation to become

familiar with the operating modes, protection

modes and other safety considerations.

Series lineup ......................................................................................11

Main Features ...................................................................................11

Accessories ........................................................................................12

Front Panel........................................................................................13

Display and Operation Panel .........................................................16

Rear Panel..........................................................................................18

Operating Area Description...........................................................20

CC and CV Mode.............................................................................21

Slew Rate ...........................................................................................23

Bleeder Control ................................................................................23

Internal Resistance ...........................................................................24

Alarms ................................................................................................25

Considerations ..................................................................................26

Grounding .........................................................................................28

www. .com information@itm.com1.800.561.8187

Dieses Handbuch passt für folgende Modelle

Andere Teledyne Stromversorgung Handbücher

Teledyne

Teledyne T3PSX3200P Series Bedienungsanleitung

Teledyne

Teledyne T3PS30721P Bedienungsanleitung

Teledyne

Teledyne T3PS40381P Betriebsanleitung

Teledyne

Teledyne Battery-Backed Power Supply Betriebsanleitung

Teledyne

Teledyne 3190 Series Bedienungsanleitung

Teledyne

Teledyne Power Pod 400 Bedienungsanleitung

Teledyne

Teledyne Power Pod 400 Bedienungsanleitung

Teledyne

Teledyne HASTINGS 200 Series Bedienungsanleitung

Teledyne

Teledyne T3PS3000 Bedienungsanleitung

Teledyne

Teledyne 913 Betriebsanleitung

Teledyne

Teledyne T3PS20051P Bedienungsanleitung

Teledyne

Teledyne T3PS16081P Bedienungsanleitung

Teledyne

Teledyne T3PS13206P Bedienungsanleitung

Teledyne

Teledyne T3PS13206 Bedienungsanleitung

Teledyne

Teledyne T3PS40381P Bedienungsanleitung

Teledyne

Teledyne T3PS12415 Bedienungsanleitung

Teledyne

Teledyne T3PS36006 Bedienungsanleitung

Beliebte Stromversorgung Handbücher anderer Marken

Monacor

Monacor PS-12CCD Bedienungsanleitung

VOLTIMA

VOLTIMA MagicBox 15 Bedienungsanleitung

Miller

Miller Auto Deltaweld 452 Bedienungsanleitung

BCP

BCP PUOUBK Merkblatt

HC 2210 Bedienungsanleitung

Agilent Technologies

Agilent Technologies 6032A Bedienungsanleitung

Puls

Puls CT5.241 Bedienungsanleitung

OCZ

OCZ ZX1250W Bedienungsanleitung

iseg

iseg ECH 238 Bedienungsanleitung

Agilent Technologies

Agilent Technologies 6631B Bedienungsanleitung

Power

Power XXL A Series Bedienungsanleitung

Renogy

Renogy PHOENIX 300 Bedienungsanleitung

HP 6200B Service-Handbuch

Epson

Epson Stylus Scan 2500 Betriebsanleitung

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Bedienungsanleitung

Puls

Puls MiniLine ML50.100 Bedienungsanleitung

Puls

Puls AS-Interface SLA4.100 Bedienungsanleitung

Kenwood

Kenwood PS-60 Bedienungsanleitung