Serial Number: 0120505089 Version:00.00 Edition: 2006-7
Dishwasher Model:TEL12DWMSV2
5/5
5.Installation and Accessory Parts
5.1 Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it,
and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water
supply and drain hoses that can be positioned on the right or the left to facilitate proper
installation.
5.2 Leveling the Appliance
Once the appliance is positioned, adjust the feet (screw them in or out) to level the
dishwasher. In any case, the appliance should not be inclined more than 2¡. If the appliance
is level,it will help ensure proper performance.
5.3 Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(gas) connector and make sure that it
is fastened tightly in place (see Fig 1).
If the water pipes are new or have not been used for an extended period of time,let the water
run to make sure that the water is clear and free of impurities.If this precaution is not
taken,there is a risk that the water inlet can get blocked and damage the appliance.
5.4 Hot Water Connection
The water supply to the appliance can also be connected to the house's hot water line
(centralised system,heating system),as long as it does not exceed a temperature of 60¡æ.
In this case,the wash cycle time will be shortened by about 15 minutes and the wash
efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line.
