Pairing
CONNECTION INSTRUCTIONS FOR THE
D01
Your new SG01 can only be connected to mobile phones, mp3
and
GPS navigators that come provided with a communication
system.
To connect the SG01 to your mobile phone or mp3, it is necessary
to
make an initial setting operation called
“PAIRING”.
The PAIRING process is required for only the first time you are
going
to use your SG01
system.
(After the first power up pf the unit, you will only have to follow
the
normal ON/OFF procedure going
forward.)
PAIRING
PROCEDURE
1) Your SG01 must be switched
off.
2) Again, your mobile phone or MP3 must have systems
and
they
must be enabled on your device. (Please refer to your phone
or
mp3
manual for directions /
support).
3) Push your SG01 on/off-pairing button and keep it pressed for
about
7 seconds – until you see a fast blue blinking LED light on the
unit.
4) Take your now enabled phone or MP3 and
select
“search option”. When your phone or mp3 will detect SG01, the
name
of SG01(BT-02)will appear. Please select the unit to PAIR with
your
phone or
MP3.
PLEASE
NOTE
Some models of mobile phone or MP3 also may require you to insert
a
password.
Should this be requested-Please enter 0000 as your code and
press
enter
.
5) The blue indicator will change from a fast to a slow flashing
LED
light when the pairing operation is
successful.
YOUR PAIRRING OPERATION IN NOW
COMPLETE
IMPORTANT NOTE :If you wish to use your mobile phone for
phone
calls and your MP3 for listening to music at the same time , it is
neces-
sary to do the PAIRING operation for both the mobile phone and
the
MP3. (Note – PAIR one unit at a time / only one unit is to be
powered
on at a time to have a successful
PAIRING.
(You can not have both the phone and the MP3 units powered on
the
time when
PAIRING.)
