9
PREPARING THE REMOTE CONTROL
The remote control runs on batteries. Use the batteries included in this product or two new
batteries.
1. Remove the battery cover in the back of the
remote control.
2. Put the batteries into the battery holder,
according to the polarity markings (+) and (-)
inside the holder.
3. Put the battery cover back to the former state.
NOTE
nTry changing the batteries when the remote
control malfunctions.
nThis remote control works with the remote
sensors on the projector using infrared light
(Class 1 LED). The active sensor will sense the
remote control signal within 60 degrees to the
right and left, and within 3 meters
nPrevent the remote sensors from being hit by a
strong ray. This may cause a malfunction.
WARNING
nBe careful handling batteries, as they may cause an explosion, cracking or leakage, which could
result in a re, an injury and environment pollution.
nOnly use the specied and new battery. Do not use a battery with damage, such as a scratch, a
dent, rust or leakage. Do not mix a new battery with used one.
nIf a battery leaks, wipe the leakage out well with a waste cloth. If the leakage adheres to your
body, immediately rinse it well with water. If a battery leaks in the battery holder, replace the
batteries after wiping the leakage out.
nMake sure the plus and minus terminals are correctly aligned when loading a battery.
nDo not work on a battery; for example recharging or soldering.
nDo not keep the batteries put in the remote control when it is not used for a long period. Keep a
battery in a dark, cool and dry place. Never expose a battery to a re or water.
nObey the local laws on disposing a battery.
